Linux version 2.6.18-6-486 (Debian 2.6.18.dfsg.1-18etch6) (dannf@debian.org) (gcc version 4.1.2 20061115 (prerelease) (Debian 4.1.1-21)) #1 Fri Jun 6 21:47:01 UTC 2008
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
 BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
 BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 0000000002000000 (usable)
 BIOS-e820: 00000000fffe0000 - 0000000100000000 (reserved)
32MB LOWMEM available.
On node 0 totalpages: 8192
  DMA zone: 4096 pages, LIFO batch:0
  Normal zone: 4096 pages, LIFO batch:0
DMI not present or invalid.
ACPI: Unable to locate RSDP
Allocating PCI resources starting at 10000000 (gap: 02000000:fdfe0000)
Detected 167.051 MHz processor.
Built 1 zonelists.  Total pages: 8192
Kernel command line: root=/dev/hda1 ro fb800x600 vga=788 
No local APIC present or hardware disabled
mapped APIC to ffffd000 (01041000)
Initializing CPU#0
PID hash table entries: 256 (order: 8, 1024 bytes)
Console: colour dummy device 80x25
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Memory: 25248k/32768k available (1499k kernel code, 7132k reserved, 599k data, 256k init, 0k highmem)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Calibrating delay using timer specific routine.. 334.49 BogoMIPS (lpj=668999)
Security Framework v1.0.0 initialized
SELinux:  Disabled at boot.
Capability LSM initialized
Mount-cache hash table entries: 512
CPU: After generic identify, caps: 008001bf 00000000 00000000 00000000 00000000 00000000 00000000
CPU: After vendor identify, caps: 008001bf 00000000 00000000 00000000 00000000 00000000 00000000
Intel Pentium with F0 0F bug - workaround enabled.

CPU: After all inits, caps: 008001bf 00000000 00000000 00000000 00000000 00000000 00000000
Compat vDSO mapped to ffffe000.
CPU: Intel Pentium MMX stepping 03
Checking 'hlt' instruction... OK.
checking if image is initramfs... it is
Freeing initrd memory: 4227k freed
NET: Registered protocol family 16
EISA bus registered
PCI: PCI BIOS revision 2.10 entry at 0xfd8a0, last bus=0
PCI: Using configuration type 1
Setting up standard PCI resources
ACPI: Interpreter disabled.
Linux Plug and Play Support v0.97 (c) Adam Belay
pnp: PnP ACPI: disabled
PnPBIOS: Scanning system for PnP BIOS support...
PnPBIOS: Found PnP BIOS installation structure at 0xc00fe700
PnPBIOS: PnP BIOS version 1.0, entry 0xf0000:0xe724, dseg 0xf0000
PnPBIOS: 17 nodes reported by PnP BIOS; 17 recorded by driver
PCI: Probing PCI hardware
PCI: Probing PCI hardware (bus 00)
Boot video device is 0000:00:03.0
pnp: 00:0b: ioport range 0x4d0-0x4d1 has been reserved
pnp: 00:0b: ioport range 0x15e8-0x15ef has been reserved
PCI: Ignore bogus resource 6 [0:0] of 0000:00:03.0
NET: Registered protocol family 2
IP route cache hash table entries: 256 (order: -2, 1024 bytes)
TCP established hash table entries: 1024 (order: 0, 4096 bytes)
TCP bind hash table entries: 512 (order: -1, 2048 bytes)
TCP: Hash tables configured (established 1024 bind 512)
TCP reno registered
audit: initializing netlink socket (disabled)
audit(1215190751.844:1): initialized
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
Initializing Cryptographic API
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered (default)
vesafb: framebuffer at 0x8000000, mapped to 0xc2880000, using 1024k, total 1024k
vesafb: mode is 800x600x16, linelength=1600, pages=0
vesafb: protected mode interface info at c000:7f40
vesafb: pmi: set display start = c00c7f76, set palette = c00c7fc8
vesafb: scrolling: redraw
vesafb: Truecolor: size=0:5:6:5, shift=0:11:5:0
Console: switching to colour frame buffer device 100x37
fb0: VESA VGA frame buffer device
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing enabled
serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a NS16550A
pnp: Device 00:0e activated.
00:0e: ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A
RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize
PNP: PS/2 Controller [PNP0303,PNP0f13] at 0x60,0x64 irq 1,12
serio: i8042 AUX port at 0x60,0x64 irq 12
serio: i8042 KBD port at 0x60,0x64 irq 1
mice: PS/2 mouse device common for all mice
EISA: Probing bus 0 at eisa.0
EISA: Detected 0 cards.
TCP bic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
NET: Registered protocol family 8
NET: Registered protocol family 20
Using IPI Shortcut mode
Time: tsc clocksource has been installed.
Freeing unused kernel memory: 256k freed
input: AT Translated Set 2 keyboard as /class/input/input0
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
MPIIX: IDE controller at PCI slot 0000:00:01.0
MPIIX: chipset revision 3
MPIIX: bad irq (0): will probe later
Probing IDE interface ide0...
hda: TOSHIBA MK2103MAV, ATA DISK drive
hdb: HITACHI CDR-S100, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: max request size: 128KiB
hda: 4128768 sectors (2113 MB) w/128KiB Cache, CHS=4096/16/63
 hda: hda1 hda2
hdb: ATAPI 20X CD-ROM drive, 128kB Cache
Uniform CD-ROM driver Revision: 3.20
Attempting manual resume
kjournald starting.  Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
PCI: No IRQ known for interrupt pin A of device 0000:00:13.0. Please try using pci=biosirq.
pd6729: Cirrus PD6729 PCI to PCMCIA Bridge at 0x3e0 on irq 0
pd6729: ISA irqs = 3,4,5,7,9,10,11  polling status changes.
input: PC Speaker as /class/input/input1
pccard: PCMCIA card inserted into slot 1
IBM TrackPoint firmware: 0x06, buttons: 2/3
input: TPPS/2 IBM TrackPoint as /class/input/input2
Real Time Clock Driver v1.12ac
Floppy drive(s): fd0 is 1.44M
parport: PnPBIOS parport detected.
parport0: PC-style at 0x3bc, irq 7 [PCSPP,TRISTATE]
irda_init()
NET: Registered protocol family 23
FDC 0 is a National Semiconductor PC87306
nsc_ircc_pnp_probe() : From PnP, found firbase 0x3F8 ; irq 4 ; dma 3.
nsc-ircc, chip->init
nsc-ircc, Found chip at base=0x02e
nsc-ircc, Wrong chip version 16
nsc-ircc, Found chip at base=0x02e
nsc-ircc, Wrong chip version 16
pnp: Device 00:0f disabled.
CS4232 WSS PnP manual resources are invalid, using auto config
CS4232 WSS PnP configure failed for WSS (out of resources?)
PnP BIOS detection failed for CS4232
pnp: Device 00:10 disabled.
cs4232-pnpbios: probe of 00:10 failed with error -16
CS4232 soundcard not found or device busy
cs: IO port probe 0x100-0x3af: clean.
cs: IO port probe 0x3e0-0x4ff: clean.
cs: IO port probe 0x820-0x8ff: clean.
cs: IO port probe 0x100-0x3af: clean.
cs: IO port probe 0x3e0-0x4ff: clean.
cs: IO port probe 0x820-0x8ff: clean.
cs: IO port probe 0xc00-0xcf7: clean.
cs: IO port probe 0xa00-0xaff: clean.
cs: IO port probe 0xc00-0xcf7: clean.
cs: IO port probe 0xa00-0xaff: clean.
cs: memory probe 0xa0000000-0xa0ffffff: clean.
pcmcia: registering new device pcmcia1.0
ad1848/cs4248 codec driver Copyright (C) by Hannu Savolainen 1993-1996
ad1848: No ISAPnP cards found, trying standard ones...
pnp: Device 00:10 activated.
cs4232.c: ISA PnP configured, but not detected?
cs4232: ISA PnP card found, but not detected?
pnp: Device 00:10 disabled.
cs4232: Must set io, irq and dma.
ts: Compaq touchscreen protocol output
eth0: NE2000 Compatible: io 0x300, irq 3, hw_addr 00:40:F4:23:B2:42
Adding 208836k swap on /dev/hda2.  Priority:-1 extents:1 across:208836k
EXT3 FS on hda1, internal journal
device-mapper: ioctl: 4.7.0-ioctl (2006-06-24) initialised: dm-devel@redhat.com
NET: Registered protocol family 10
lo: Disabled Privacy Extensions
IPv6 over IPv4 tunneling driver
eth0: no IPv6 routers present