Linux version 2.6.12-rc1-suspend2-r3disciplina (root@parvus) (gcc version 3.3.5-20050130 (Gentoo 3.3.5.20050130-r1, ssp-3.3.5.20050130-1, pie-8.7.7.1)) #8 Mon May 23 03:54:50 BST 2005
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009f800 (usable)
 BIOS-e820: 000000000009f800 - 00000000000a0000 (reserved)
 BIOS-e820: 00000000000ce000 - 00000000000d0000 (reserved)
 BIOS-e820: 00000000000dc000 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 000000003f6f0000 (usable)
 BIOS-e820: 000000003f6f0000 - 000000003f6fb000 (ACPI data)
 BIOS-e820: 000000003f6fb000 - 000000003f700000 (ACPI NVS)
 BIOS-e820: 000000003f700000 - 0000000040000000 (reserved)
 BIOS-e820: 00000000fec10000 - 00000000fec20000 (reserved)
 BIOS-e820: 00000000ffb00000 - 00000000ffc00000 (reserved)
 BIOS-e820: 00000000fff00000 - 0000000100000000 (reserved)
Warning only 896MB will be used.
Use a HIGHMEM enabled kernel.
896MB LOWMEM available.
On node 0 totalpages: 229376
  DMA zone: 4096 pages, LIFO batch:1
  Normal zone: 225280 pages, LIFO batch:16
  HighMem zone: 0 pages, LIFO batch:1
DMI 2.3 present.
ACPI: RSDP (v000 FUJ                                   ) @ 0x000f5d70
ACPI: RSDT (v001 FUJ    FJNB189  0x01240000 FUJ  0x00000100) @ 0x3f6f4c2d
ACPI: FADT (v001 FUJ    FJNB189  0x01240000 FUJ  0x00000100) @ 0x3f6faf8c
ACPI: SSDT (v001 FUJ    FJNB189  0x01240000 INTL 0x20030522) @ 0x3f6fab42
ACPI: BOOT (v001 FUJ    FJNB189  0x01240000 FUJ  0x00000100) @ 0x3f6faf64
ACPI: DSDT (v001 FUJ    FJNB189  0x01240000 MSFT 0x0100000e) @ 0x00000000
Allocating PCI resources starting at 40000000 (gap: 40000000:bec10000)
Built 1 zonelists
Kernel command line: root=/dev/hda3 video=vesafb:ywrap,mtrr,1280x768-32@60 splash=fadein,theme:emergence CONSOLE=/dev/tty1 i8042.nomux acpi_sleep=s3_bios
Local APIC disabled by BIOS -- you can enable it with "lapic"
mapped APIC to ffffd000 (01703000)
Initializing CPU#0
PID hash table entries: 4096 (order: 12, 65536 bytes)
Detected 600.281 MHz processor.
Using tsc for high-res timesource
Console: colour VGA+ 80x25
Dentry cache hash table entries: 131072 (order: 7, 524288 bytes)
Inode-cache hash table entries: 65536 (order: 6, 262144 bytes)
Memory: 899760k/917504k available (3371k kernel code, 17292k reserved, 1868k data, 3484k init, 0k highmem)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Calibrating delay loop... 1183.74 BogoMIPS (lpj=591872)
Mount-cache hash table entries: 512
CPU: After generic identify, caps: afe9f9ff 00000000 00000000 00000000 00000180 00000000 00000000
CPU: After vendor identify, caps: afe9f9ff 00000000 00000000 00000000 00000180 00000000 00000000
CPU: L1 I cache: 32K, L1 D cache: 32K
CPU: L2 cache: 2048K
CPU: After all inits, caps: afe9f9ff 00000000 00000000 00000040 00000180 00000000 00000000
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU: Intel(R) Pentium(R) M processor 1.20GHz stepping 08
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
ACPI: setting ELCR to 0200 (from 0800)
NET: Registered protocol family 16
PCI: PCI BIOS revision 2.10 entry at 0xfd982, last bus=3
PCI: Using configuration type 1
mtrr: v2.0 (20020519)
ACPI: Subsystem revision 20050211
ACPI: Interpreter enabled
ACPI: Using PIC for interrupt routing
ACPI: PCI Root Bridge [PCI0] (00:00)
PCI: Probing PCI hardware (bus 00)
PCI: Ignoring BAR0-3 of IDE controller 0000:00:1f.1
PCI: Transparent bridge - 0000:00:1e.0
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT]
ACPI: PCI Interrupt Link [LNKA] (IRQs 3 4 5 7 9 10 *11)
ACPI: PCI Interrupt Link [LNKB] (IRQs 3 4 5 7 9 10 *11)
ACPI: PCI Interrupt Link [LNKC] (IRQs 3 4 5 7 9 10 *11)
ACPI: PCI Interrupt Link [LNKD] (IRQs 3 4 5 7 9 10 *11)
ACPI: PCI Interrupt Link [LNKE] (IRQs 3 4 5 7 9 10 *11)
ACPI: PCI Interrupt Link [LNKF] (IRQs 3 4 5 7 9 10 11) *0, disabled.
ACPI: PCI Interrupt Link [LNKG] (IRQs 3 4 5 7 9 10 11) *0, disabled.
ACPI: PCI Interrupt Link [LNKH] (IRQs 3 4 5 7 9 10 *11)
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.HUB_._PRT]
Linux Plug and Play Support v0.97 (c) Adam Belay
pnp: PnP ACPI init
pnp: PnP ACPI: found 8 devices
SCSI subsystem initialized
PCI: Using ACPI for IRQ routing
PCI: If a device doesn't work, try "pci=routeirq".  If it helps, post a report
TC classifier action (bugs to netdev@oss.sgi.com cc hadi@cyberus.ca)
Simple Boot Flag at 0x7f set to 0x1
audit: initializing netlink socket (disabled)
audit(1116817054.523:0): initialized
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
Initializing Cryptographic API

testing md5
test 1:
d41d8cd98f00b204e9800998ecf8427e
pass
test 2:
0cc175b9c0f1b6a831c399e269772661
pass