[    6.511926] usb 1-1: configuration #1 chosen from 1 choice
[    6.522483] usb 1-1: New USB device found, idVendor=04b3, idProduct=310c
[    6.522488] usb 1-1: New USB device strings: Mfr=0, Product=2, SerialNumber=0
[    6.522493] usb 1-1: Product: USB Optical Mouse
[    6.550482] usbcore: registered new interface driver hiddev
[    6.554741] input: USB Optical Mouse as /class/input/input1
[    6.558547] input,hidraw0: USB HID v1.11 Mouse [USB Optical Mouse] on usb-0000:00:03.0-1
[    6.558572] usbcore: registered new interface driver usbhid
[    6.558576] usbhid: v2.6:USB HID core driver
[    9.748607] PM: Starting manual resume from disk
[    9.780601] EXT3-fs: INFO: recovery required on readonly filesystem.
[    9.780601] EXT3-fs: write access will be enabled during recovery.
[   10.316514] kjournald starting.  Commit interval 5 seconds
[   10.316514] EXT3-fs: dm-1: orphan cleanup on readonly fs
[   10.316514] ext3_orphan_cleanup: deleting unreferenced inode 15171636
[   10.316514] ext3_orphan_cleanup: deleting unreferenced inode 15171609
[   10.316514] ext3_orphan_cleanup: deleting unreferenced inode 15171605
[   10.316514] ext3_orphan_cleanup: deleting unreferenced inode 15171600
[   10.316514] ext3_orphan_cleanup: deleting unreferenced inode 15171599
[   10.316514] EXT3-fs: dm-1: 5 orphan inodes deleted
[   10.316514] EXT3-fs: recovery complete.
[   10.548019] EXT3-fs: mounted filesystem with ordered data mode.
[   12.923707] udevd version 125 started
[   14.161281] pci_hotplug: PCI Hot Plug PCI Core version: 0.5
[   14.169282] shpchp: Standard Hot Plug PCI Controller Driver version: 0.4
[   14.185281] Linux agpgart interface v0.103
[   14.201587] input: Power Button (FF) as /class/input/input2
[   14.205588] agpgart: Detected SiS chipset - id:1633
[   14.209596] agpgart: AGP aperture is 64M @ 0xe0000000
[   14.258526] ACPI: Power Button (FF) [PWRF]
[   14.258694] input: Power Button (CM) as /class/input/input3
[   14.296106] ACPI: Power Button (CM) [PWRB]
[   14.820232] Silan SC92031 PCI Fast Ethernet Adapter driver 2.0c
[   14.820275] ACPI: PCI Interrupt 0000:00:0a.0[A] -> GSI 18 (level, low) -> IRQ 18
[   14.861617] input: PC Speaker as /class/input/input4
[   15.173195] udev: renamed network interface eth0 to eth2
[   15.204344] parport_pc 00:08: reported by Plug and Play ACPI
[   15.204344] parport0: PC-style at 0x378 (0x778), irq 7 [PCSPP,TRISTATE]
[   15.347202] ACPI: PCI Interrupt 0000:00:02.7[C] -> GSI 18 (level, low) -> IRQ 18
[   15.670553] intel8x0_measure_ac97_clock: measured 53840 usecs
[   15.670613] intel8x0: clocking to 48000
[   17.427297] EXT3 FS on dm-1, internal journal
[   18.098397] loop: module loaded
[   19.389113] fuse init (API version 7.9)
[   19.466085] kjournald starting.  Commit interval 5 seconds
[   19.466085] EXT3 FS on sda1, internal journal
[   19.466085] EXT3-fs: mounted filesystem with ordered data mode.
[   19.542377] Adding 2715640k swap on /dev/mapper/jan-swap_1.  Priority:-1 extents:1 across:2715640k
[   20.334324] eth1: link up, 100Mbps, full-duplex, lpa 0x43E1
[   21.301907] NET: Registered protocol family 10
[   21.301907] lo: Disabled Privacy Extensions
[   27.565811] lp0: using parport0 (interrupt-driven).
[   27.638002] ppdev: user-space parallel port driver
[   33.177590] eth1: no IPv6 routers present
[   34.770572] warning: `ntpd' uses 32-bit capabilities (legacy support in use)