ivtv:  ==================== START INIT IVTV ====================
ivtv:  version 0.6.3 (tagged release) loading
ivtv:  Linux version: 2.6.16-2-486 486 gcc-4.0
ivtv:  In case of problems please include the debug info between
ivtv:  the START INIT IVTV and END INIT IVTV lines, along with
ivtv:  any module options, when mailing the ivtv-users mailinglist.
ivtv0: Autodetected Hauppauge WinTV PVR-250 card (cx23416 based)
ACPI: PCI Interrupt Link [APC1] enabled at IRQ 16
ACPI: PCI Interrupt 0000:01:06.0[A] -> Link [APC1] -> GSI 16 (level, low) -> IRQ 201
ivtv0: Unreasonably low latency timer, setting to 64 (was 32)
ACPI: PCI Interrupt Link [APCJ] enabled at IRQ 21
ACPI: PCI Interrupt 0000:00:06.0[A] -> Link [APCJ] -> GSI 21 (level, high) -> IRQ 177
PCI: Setting latency timer of device 0000:00:06.0 to 64
tveeprom 2-0050: Hauppauge model 32062, rev C182, serial# 7913003
tveeprom 2-0050: tuner model is LG TAPC H791F (idx 82, type 39)
tveeprom 2-0050: TV standards NTSC(M) (eeprom 0x08)
tveeprom 2-0050: audio processor is MSP3445 (idx 12)
tveeprom 2-0050: decoder processor is SAA7115 (idx 19)
tveeprom 2-0050: has no radio, has IR remote
ivtv0: Failed to load module tuner
ivtv0: Failed to load module tda9887
saa7115 2-0021: saa7115 found @ 0x42 (ivtv i2c driver #0)
ivtv0: Failed to load module msp3400
intel8x0_measure_ac97_clock: measured 53577 usecs
intel8x0: clocking to 47477
ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
ivtv0: Encoder revision: 0x02050032
ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total)
ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total)
ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total)
ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total)
ivtv0: i2c hardware 0x00000008 not found for command 0xc008561c!
ivtv0: i2c addr 0x40 not found for command 0x40086d11!
ivtv0: i2c addr 0x40 not found for command 0xc008561c!
ivtv0: i2c hardware 0x00000008 not found for command 0xc008561c!
ivtv0: i2c hardware 0x00000008 not found for command 0xc008561c!
ivtv0: i2c hardware 0x00000008 not found for command 0xc008561c!
ivtv0: Initialized Hauppauge WinTV PVR-250, card #0
ivtv:  ====================  END INIT IVTV  ====================