Uncompressing Linux....................................................................................... done, booting the kernel.
Linux version 2.6.26 (andrea@mizar) (gcc version 4.3.3 (GCC) ) #1 PREEMPT Sat Aug 15 11:24:17 CEST 2009
CPU: XScale-PXA255 [69052d06] revision 6 (ARMv5TE), cr=0000397f
Machine: SHARP Husky
Memory policy: ECC disabled, Data cache writeback
On node 0 totalpages: 16384
  DMA zone: 128 pages used for memmap
  DMA zone: 0 pages reserved
  DMA zone: 16256 pages, LIFO batch:3
  Normal zone: 0 pages used for memmap
  Movable zone: 0 pages used for memmap
Memory clock: 99.53MHz (*27)
Run Mode clock: 199.07MHz (*2)
Turbo Mode clock: 398.13MHz (*2.0, active)
CPU0: D VIVT undefined 5 cache
CPU0: I cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
CPU0: D cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 16256
Kernel command line: console=tty1 console=ttyS0,115200n8 noinitrd    debug root=/dev/mmcblk0p1 rootfstype=ext2 rootwait
PID hash table entries: 256 (order: 8, 1024 bytes)
Console: colour dummy device 80x30
console [tty1] enabled
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 64MB = 64MB total
Memory: 62092KB available (2496K code, 189K data, 84K init)
Calibrating delay loop... 397.31 BogoMIPS (lpj=1986560)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
net_namespace: 624 bytes
NET: Registered protocol family 16
Sharp Scoop Device found at 0x10800000 -> 0xc4806000
Switched to high resolution mode on CPU 0
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
NET: Registered protocol family 1
PXA CPU frequency change support initialized
JFFS2 version 2.2. (NAND) (SUMMARY)   2001-2006 Red Hat, Inc.
msgmni has been set to 121
io scheduler noop registered
io scheduler anticipatory registered (default)
Corgi Backlight Driver Initialized.
Found w100 at 0x08000000.
Console: switching to colour frame buffer device 80x30
fb0: w100fb frame buffer device
pxa2xx-uart.0: ttyS0 at MMIO 0x40100000 (irq = 22) is a FFUART
console [ttyS0] enabled
pxa2xx-uart.1: ttyS1 at MMIO 0x40200000 (irq = 21) is a BTUART
pxa2xx-uart.2: ttyS2 at MMIO 0x40700000 (irq = 20) is a STUART
pxa2xx-uart.3: ttyS3 at MMIO 0x41600000 (irq = 7) is a HWUART
loop: module loaded
Uniform Multi-Platform E-IDE driver
ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
Sharp SL series flash device: 800000 at 0
Using static partition definition
Creating 1 MTD partitions on "sharpsl-flash":
0x00120000-0x007f0000 : "Boot PROM Filesystem"
pccard: PCMCIA card inserted into slot 0
pcmcia: registering new device pcmcia0.0
NAND device: Manufacturer ID: 0xec, Chip ID: 0x79 (Samsung NAND 128MiB 3,3V 8-bit)
Scanning device for bad blocks
Bad eraseblock 32 at 0x00080000
Bad eraseblock 1440 at 0x01680000
Creating 3 MTD partitions on "sharpsl-nand":
0x00000000-0x00700000 : "System Area"
0x00700000-0x03c00000 : "Root Filesystem"
0x03c00000-0x08000000 : "Home Filesystem"
pxa2xx_udc: version 30-June-2007
input: Corgi Keyboard as /devices/platform/corgi-keyboard/input/input0
sharpsl_rc_init
input: Corgi Touchscreen as /devices/platform/sharp-scoop/corgi-ssp/corgi-ts/input/input1
sa1100-rtc sa1100-rtc: rtc core: registered sa1100-rtc as rtc0
I2C: i2c-0: PXA I2C adapter
Registered led device: corgi:amber:charge
Registered led device: corgi:green:mail
TCP cubic registered
XScale DSP coprocessor detected.
sa1100-rtc sa1100-rtc: setting system clock to 1970-01-01 00:01:56 UTC (116)
Waiting for root device /dev/mmcblk0p1...
mmc0: new SD card at address b368
mmcblk0: mmc0:b368 SMI   501248KiB 
 mmcblk0: p1
VFS: Mounted root (ext2 filesystem) readonly.
Freeing init memory: 84K

INIT: version 2.86 booting

Loading /etc/keymap-2.6.map
Please wait: booting...
Starting udevNET: Registered protocol family 23
Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing disabled
ttyS0: detected caps 00000700 should be 00000100
0.0: ttyS4 at I/O 0xc48203f8 (irq = 81) is a 16C950/954

Remounting root file system...
EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
Bluetooth: Core ver 2.11
NET: Registered protocol family 31
Bluetooth: HCI device and connection manager initialized
Bluetooth: HCI socket layer initialized
Bluetooth: L2CAP ver 2.9
Bluetooth: L2CAP socket layer initialized
Bluetooth: HIDP (Human Interface Emulation) ver 1.2
IrCOMM protocol (Dag Brattli)
Bluetooth: RFCOMM socket layer initialized
Bluetooth: RFCOMM TTY layer initialized
Bluetooth: RFCOMM ver 1.8
ASoC version 0.13.2
wm8731: WM8731 Audio Codec 0.13
asoc: WM8731 <-> pxa2xx-i2s mapping ok
Unknown HZ value! (83) Assume 100.
ALSA: Restoring mixer settings...
Configuring network interfaces... ifconfig: SIOCGIFFLAGS: No such device
ifconfig: SIOCGIFFLAGS: No such device
eth0      No such device

ifconfig: SIOCGIFFLAGS: No such device
done.
Starting portmap daemon: portmap.
Unknown HZ value! (85) Assume 100.
net.ipv4.conf.default.rp_filter = 1
net.ipv4.conf.all.rp_filter = 1
Sat Aug 15 14:39:00 UTC 2009

INIT: Entering runlevel: 5

Starting system message bus: dbus.
Starting Dropbear SSH server: dropbear.
Starting advanced power management daemon: apmd[1062]: apmd 3.2.1 interfacing with apm driver 1.13 and APM BIOS 1.2

apmd.
Starting syslogd/klogd: done
 * Starting Avahi mDNS/DNS-SD Daemon: avahi-daemon
[ ok ]
Loading [g_ether]
ether gadget: using random self ethernet address
ether gadget: using random host ethernet address
usb0: Ethernet Gadget, version: May Day 2005
usb0: using pxa2xx_udc, OUT ep2out-bulk IN ep1in-bulk STATUS ep6in-bulk
usb0: MAC 22:b3:43:32:ed:d7
usb0: HOST MAC 32:7e:81:b3:bb:88
usb0: RNDIS ready
Starting Zaurusd
NET: Registered protocol family 17
Unknown HZ value! (84) Assume 100.
input: Touchscreen offscreen keys as /devices/virtual/input/input2
Using [corgi-bl] backlight driver
### on 31 ###
cat: can't open '/var/run/last-screen-rotation': No such file or directory
Unknown HZ value! (84) Assume 100.
Unknown HZ value! (84) Assume 100.
Unknown HZ value! (84) Assume 100.

.-------.                                           
|       |                  .-.                      
|   |   |-----.-----.-----.| |   .----..-----.-----.
|       |     | __  |  ---'| '--.|  .-'|     |     |
|   |   |  |  |     |---  ||  --'|  |  |  '  | | | |
'---'---'--'--'--.  |-----''----''--'  '-----'-'-'-'
                -'  |
                '---'

The Angstrom Distribution c7x0 ttyS0

Angstrom 2009.X-test-20090815 c7x0 ttyS0

c7x0 login: root
root@c7x0:~# /us
root@c7x0:~# /usr/[Jbin[8D
root@c7x0:~# /usr/bin/[Jkexec[14D
root@c7x0:~# /usr/bin/kexecboot [J
kexecboot 0.5 starting
Unknown keyword: 'CONSOLE'
Can't parse keyword console!
Unknown keyword: 'CONSOLE'
Can't parse keyword console!
Unknown keyword: 'NOINITRD    DEBUG ROOT'
Can't parse keyword noinitrd    debug root!
Unknown keyword: 'DEBUG ROOT'
Can't parse keyword debug root!
Unknown keyword: 'ROOT'
Can't parse keyword root!
FB angle is 0, input device is /dev/event0
Going to fb mode
Got device '/dev/mtdblock0' (31, 0) of size 6Mb
Recreating device node /dev/mtdblock0 (31, 0)
Probing /dev/mtdblock0
FS cound not be identified
Can't detect FS type
Got device '/dev/mtdblock1' (31, 1) of size 7Mb
Recreating device node /dev/mtdblock1 (31, 1)
Probing /dev/mtdblock1
FS cound not be identified
Can't detect FS type
Got device '/dev/mtdblock2' (31, 2) of size 53Mb
Recreating device node /dev/mtdblock2 (31, 2)
Probing /dev/mtdblock2
+ FS on device is jffs2
Can't open config file '/mnt/boot/boot.cfg'
No kernels found
Can't get device boot information
Got device '/dev/mtdblock3' (31, 3) of size 68Mb
Recreating device node /dev/mtdblock3 (31, 3)
Probing /dev/mtdblock3
FS cound not be identified
Can't detect FS type
Got device '/dev/mmcblk0' (179, 0) of size 489Mb
Recreating device node /dev/mmcblk0 (179, 0)
Probing /dev/mmcblk0
FS cound not be identified
Can't detect FS type
Got device '/dev/mmcblk0p1' (179, 1) of size 486Mb
Recreating device node /dev/mmcblk0p1 (179, 1)
Probing /dev/mmcblk0p1
+ FS on device is ext2
mount: Device or resource busy
Can't read next device line
[?25l
+ found evdev: event2
Supported event types:
  Event type 0x00  (Unknown event type: 0x0000)
  Event type 0x01  (Keys or Buttons)
+ found evdev: event1
Supported event types:
  Event type 0x00  (Unknown event type: 0x0000)
  Event type 0x01  (Keys or Buttons)
  Event type 0x03  (Absolute Axes)
+ found evdev: event0
Supported event types:
  Event type 0x00  (Unknown event type: 0x0000)
  Event type 0x01  (Keys or Buttons)
  Event type 0x05  (Switch)
  Event type 0x14  (Repeat)
  Event type 0x16  (Power)
+ opened event device '/dev/input/event2', fd: 5
+ opened event device '/dev/input/event1', fd: 6
+ opened event device '/dev/input/event0', fd: 7
evdev ioctl: Function not implemented
evdev ioctl: Function not implemented