Sun Cobalt - Smaller, Bluer, Better Firmware version 2.10.1 ROM kernel 2.4.19C5 (XFS + ext3) Current date: Apr 28 18:15:16 UTC 2004 ROM build info: Tue Mar 11 13:05:33 MST 2003 rom.cobalt.sun.com System serial number: invalid csum! System type: 3000 series system, Version 1 board Silicon serial number: 24000007661c3d01 Monitor: 154752 bytes Memory: 256 MB CPU: 1 processor(s) detected CPU 0: AuthenticAMD 448MHz (4.5 x 100MHz host bus) [BSP] Initializing flash: done Flash Bank 0: AMD AM29F080B 1024KB (01:d5) Flash Bank 1: not installed. Mounting ROM fs: done Initializing PCI: done Initializing ethernet: 2 controller(s) found Initializing IDE: found ALI M5229 at 00:78 scanning ide0: scanning ide1: Checking Memory: done Press spacebar to enter ROM mode Cobalt:Main Menu> bfn First stage kernel (Linux): Decompressing - done Linux version 2.4.19C5_ROM (root@purpleguy) (gcc version 2.96 20000731 (Red Hat Linux 7.2 2.96-108.7.2)) #1 Fri Feb3 BIOS-provided physical RAM map: BIOS-e801: 0000000000000000 - 000000000009f000 (usable) BIOS-e801: 0000000000100000 - 0000000010000000 (usable) 0MB HIGHMEM available. 256MB LOWMEM available. On node 0 totalpages: 65536 zone(0): 4096 pages. zone(1): 61440 pages. zone(2): 0 pages. Kernel command line: console=ttyS0,115200 ip=on root=/dev/nfs nfsroot=/nfsroot-x86,rsize=8192 Initializing CPU#0 Detected 448.219 MHz processor. Calibrating delay loop... 894.56 BogoMIPS Memory: 254056k/262144k available (1453k kernel code, 5652k reserved, 245k data, 100k init, 0k highmem) Dentry cache hash table entries: 32768 (order: 6, 262144 bytes) Inode cache hash table entries: 16384 (order: 5, 131072 bytes) Mount-cache hash table entries: 4096 (order: 3, 32768 bytes) Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes) Page-cache hash table entries: 65536 (order: 6, 262144 bytes) Enabling new style K6 write allocation for 256 Mb CPU: L1 I Cache: 32K (32 bytes/line), D cache 32K (32 bytes/line) CPU: L2 Cache: 128K (32 bytes/line) CPU: AMD-K6(tm)-III Processor stepping 04 Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au) mtrr: detected mtrr type: AMD K6 PCI: Using configuration type 1 PCI: Probing PCI hardware PCI: Probing PCI hardware (bus 00) Unknown bridge resource 0: assuming transparent Unknown bridge resource 1: assuming transparent Unknown bridge resource 2: assuming transparent Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket Starting kswapd Journalled Block Device driver loaded SGI XFS snapshot 2.4.19-2002-08-03_04:15_UTC with no debug enabled pty: 256 Unix98 ptys configured Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A ttyS01 at 0x02f8 (irq = 3) is a 16550A Real Time Clock Driver v1.10e Non-volatile memory driver v1.2 Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx ALI15X3: IDE controller on PCI bus 00 dev 78 ALI15X3: chipset revision 193 ALI15X3: 100% native mode on irq 14 ide0: BM-DMA at 0xfdd0-0xfdd7, BIOS settings: hda:DMA, hdb:DMA ide1: BM-DMA at 0xfdd8-0xfddf, BIOS settings: hdc:DMA, hdd:DMA loop: loaded (max 8 devices) eepro100.c:v1.09j-t 9/29/99 Donald Becker http://www.scyld.com/network/eepro100.html eepro100.c: $Revision: 1.24 $ 2000/11/17 Modified by Andrey V. Savochkin and others eth0: Invalid EEPROM checksum 0x532f, check settings before activating this device! eth0: PCI device 8086:1209, 00:10:E0:02:4F:40, IRQ 11. Receiver lock-up bug exists -- enabling work-around. Board assembly 000000-000, Physical connectors present: Primary interface chip None PHY #0. General self-test: passed. Serial sub-system self-test: passed. Internal registers self-test: passed. ROM checksum self-test: passed (0xdbd8681d). Receiver lock-up workaround activated. eth1: Invalid EEPROM checksum 0x542f, check settings before activating this device! eth1: PCI device 8086:1209, 00:10:E0:02:4F:41, IRQ 10. Receiver lock-up bug exists -- enabling work-around. Board assembly 000000-000, Physical connectors present: Primary interface chip None PHY #0. General self-test: passed. Serial sub-system self-test: passed. Internal registers self-test: passed. ROM checksum self-test: passed (0xdbd8681d). Receiver lock-up workaround activated. md: linear personality registered as nr 1 md: raid0 personality registered as nr 2 md: raid1 personality registered as nr 3 md: raid5 personality registered as nr 4 raid5: measuring checksumming speed 8regs : 617.600 MB/sec 32regs : 352.400 MB/sec pII_mmx : 836.000 MB/sec p5_mmx : 820.800 MB/sec raid5: using function: pII_mmx (836.000 MB/sec) md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27 md: Autodetecting RAID arrays. md: autorun ... md: ... autorun DONE. NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP IP: routing cache hash table of 2048 buckets, 16Kbytes TCP: Hash tables configured (established 16384 bind 16384) Sending DHCP and RARP requests ., OK IP-Config: Got DHCP answer from 10.0.0.60, my address is 10.0.0.85 IP-Config: Complete: device=eth0, addr=10.0.0.85, mask=255.255.255.0, gw=10.0.0.1, host=cobalt, domain=, nis-domain=(none), bootserver=10.0.0.60, rootserver=10.0.0.60, rootpath=/nfsroot-x86 NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. Looking up port of RPC 100003/2 on 10.0.0.60 Looking up port of RPC 100005/1 on 10.0.0.60 VFS: Mounted root (nfs filesystem). Freeing unused kernel memory: 100k freed INIT: version 2.86 booting Gentoo Linux; http://www.gentoo.org/ Copyright 1999-2005 Gentoo Foundation; Distributed under the GPLv2 * Mounting proc at /proc ... [ ok ] * Activating (possible) swap ... [ ok ] * Remounting root filesystem read/write ... [ ok ] * Skipping /etc/mtab initialization (ro root?) * Setting hostname to localhost ... [ ok ] * Checking all filesystems ... [ ok ] * Mounting local filesystems ...mount: wrong fs type, bad option, bad superblock on shm, missing codepage or other error In some cases useful info is found in syslog - try dmesg | tail or so * Some local filesystem failed to mount [ !! ] * Activating (possibly) more swap ... [ ok ] * Setting system clock using the hardware clock [UTC] ... [ ok ] * Configuring kernel parameters ... [ ok ] * Skipping /var and /tmp initialization (ro root?) * Caching service dependencies ... [ ok ] * Caching service dependencies ... [ ok ] * Skipping /var/run/utmp initialization (ro root?) * Caching service dependencies ... [ ok ] Couldnt get a file descriptor referring to the console * Loading key mappings ...Couldnt get a file descriptor referring to the console * Error loading key mappings [ !! ] Couldnt get a file descriptor referring to the console Couldnt get a file descriptor referring to the console * Setting terminal encoding to UTF-8 .../etc/init.d/keymaps: line 73: /dev/tty1: No such device /etc/init.d/keymaps: line 73: /dev/tty2: No such device /etc/init.d/keymaps: line 73: /dev/tty3: No such device /etc/init.d/keymaps: line 73: /dev/tty4: No such device /etc/init.d/keymaps: line 73: /dev/tty5: No such device /etc/init.d/keymaps: line 73: /dev/tty6: No such device /etc/init.d/keymaps: line 73: /dev/tty7: No such device /etc/init.d/keymaps: line 73: /dev/tty8: No such device /etc/init.d/keymaps: line 73: /dev/tty9: No such device /etc/init.d/keymaps: line 73: /dev/tty10: No such device /etc/init.d/keymaps: line 73: /dev/tty11: No such device [ ok ] * Setting user font ...Couldnt open //dev/tty1 Couldnt open //dev/tty2 Couldnt open //dev/tty3 Couldnt open //dev/tty4 Couldnt open //dev/tty5 Couldnt open //dev/tty6 Couldnt open //dev/tty7 Couldnt open //dev/tty8 Couldnt open //dev/tty9 Couldnt open //dev/tty10 Couldnt open //dev/tty11 * Failed to set user font [ !! ] * Starting lo * Bringing up lo ... [ ok ] * Initializing random number generator ... [ ok ] INIT: Entering runlevel: 3 * Caching service dependencies ... [ ok ] * Mounting network filesystems ... [ ok ] * Starting local ... [ ok ] INIT: Id "c1" respawning too fast: disabled for 5 minutes INIT: Id "c2" respawning too fast: disabled for 5 minutes INIT: Id "c3" respawning too fast: disabled for 5 minutes INIT: Id "c4" respawning too fast: disabled for 5 minutes INIT: Id INIT: Id "c6" respawning too fast: disabled for 5 minutes INIT: no more processes left in this runlevel