BIOS-e820: 0000000007ec0000 - 0000000007ef8000 (ACPI data)
 BIOS-e820: 0000000007ef8000 - 0000000007f00000 (ACPI NVS)
ACPI disabled because your bios is from 2000 and too old
ACPI: Subsystem revision 20040326
ACPI: Interpreter disabled.

and dmesg for the hell of it.

andrew@DownStairsComputer:~$ dmesg
Linux version 2.6.8-2-686 (horms@tabatha.lab.ultramonkey.org) (gcc version 3.3.5 (Debian 1:3.3.5-13)) #1 Tue Aug 16 13:22:48 UTC 2005
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
 BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
 BIOS-e820: 00000000000e0000 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 0000000007ec0000 (usable)
 BIOS-e820: 0000000007ec0000 - 0000000007ef8000 (ACPI data)
 BIOS-e820: 0000000007ef8000 - 0000000007f00000 (ACPI NVS)
 BIOS-e820: 00000000ffb80000 - 00000000ffc00000 (reserved)
 BIOS-e820: 00000000fff00000 - 0000000100000000 (reserved)
0MB HIGHMEM available.
126MB LOWMEM available.
On node 0 totalpages: 32448
  DMA zone: 4096 pages, LIFO batch:1
  Normal zone: 28352 pages, LIFO batch:6
  HighMem zone: 0 pages, LIFO batch:1
DMI 2.3 present.
ACPI disabled because your bios is from 2000 and too old
You can enable it with acpi=force
Built 1 zonelists
Kernel command line: root=/dev/hda2 ro
Local APIC disabled by BIOS -- reenabling.
Found and enabled local APIC!
Initializing CPU#0
PID hash table entries: 512 (order 9: 4096 bytes)
Detected 797.581 MHz processor.
Using tsc for high-res timesource
Console: colour VGA+ 80x25
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 120972k/129792k available (1551k kernel code, 8284k reserved, 690k data, 148k init, 0k highmem)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Calibrating delay loop... 1576.96 BogoMIPS
Security Scaffold v1.0.0 initialized
Mount-cache hash table entries: 512 (order: 0, 4096 bytes)
CPU: After generic identify, caps: 0383fbff 00000000 00000000 00000000
CPU: After vendor identify, caps:  0383fbff 00000000 00000000 00000000
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 256K
CPU: After all inits, caps:        0383fbff 00000000 00000000 00000040
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU: Intel Pentium III (Coppermine) stepping 06
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
enabled ExtINT on CPU#0
ESR value before enabling vector: 00000000
ESR value after enabling vector: 00000000
Using local APIC timer interrupts.
calibrating APIC timer ...
..... CPU clock speed is 797.0294 MHz.
..... host bus clock speed is 132.0882 MHz.
checking if image is initramfs...it isn't (ungzip failed); looks like an initrd
Freeing initrd memory: 4528k freed
NET: Registered protocol family 16
PCI: PCI BIOS revision 2.10 entry at 0xfda95, last bus=1
PCI: Using configuration type 1
mtrr: v2.0 (20020519)
ACPI: Subsystem revision 20040326
ACPI: Interpreter disabled.
Linux Plug and Play Support v0.97 (c) Adam Belay
PnPBIOS: Scanning system for PnP BIOS support...
PnPBIOS: Found PnP BIOS installation structure at 0xc00f2c80
PnPBIOS: PnP BIOS version 1.0, entry 0xf0000:0x253a, dseg 0xf0000
pnp: 00:09: ioport range 0x4d0-0x4d1 has been reserved
pnp: 00:09: ioport range 0xcf8-0xcff could not be reserved
pnp: 00:0b: ioport range 0x800-0x87f has been reserved
PnPBIOS: 20 nodes reported by PnP BIOS; 20 recorded by driver
PCI: Probing PCI hardware
PCI: Probing PCI hardware (bus 00)
PCI: Transparent bridge - 0000:00:1e.0
PCI: Using IRQ router PIIX/ICH [8086/2410] at 0000:00:1f.0
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
devfs: 2004-01-31 Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x0
Initializing Cryptographic API
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Serial: 8250/16550 driver $Revision: 1.90 $ 48 ports, IRQ sharing enabled
ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A
RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize
serio: i8042 AUX port at 0x60,0x64 irq 12
serio: i8042 KBD port at 0x60,0x64 irq 1
input: AT Translated Set 2 keyboard on isa0060/serio0
NET: Registered protocol family 2
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 8192 bind 16384)
NET: Registered protocol family 8
NET: Registered protocol family 20
RAMDISK: cramfs filesystem found at block 0
RAMDISK: Loading 4528 blocks [1 disk] into ram disk... done.
VFS: Mounted root (cramfs filesystem) readonly.
Freeing unused kernel memory: 148k freed
vesafb: probe of vesafb0 failed with error -6
NET: Registered protocol family 1
SCSI subsystem initialized
libata version 1.02 loaded.
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ICH: IDE controller at PCI slot 0000:00:1f.1
ICH: chipset revision 2
ICH: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0xffa0-0xffa7, BIOS settings: hda:DMA, hdb:pio
hda: WDC WD200EB-11BHF0, ATA DISK drive
Using anticipatory io scheduler
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: max request size: 128KiB
hda: 39102336 sectors (20020 MB) w/2048KiB Cache, CHS=38792/16/63, UDMA(66)
 /dev/ide/host0/bus0/target0/lun0: p1 p2 p3 < p5 >
ext3: No journal on filesystem on hda2
Adding 265032k swap on /dev/hda5.  Priority:-1 extents:1
input: ImPS/2 Generic Wheel Mouse on isa0060/serio1
Capability LSM initialized
mice: PS/2 mouse device common for all mice
ts: Compaq touchscreen protocol output
Linux agpgart interface v0.100 (c) Dave Jones
Intel 810 + AC97 Audio, version 1.01, 13:45:23 Aug 16 2005
PCI: Found IRQ 10 for device 0000:00:1f.5
PCI: Sharing IRQ 10 with 0000:00:1f.3
PCI: Setting latency timer of device 0000:00:1f.5 to 64
i810: Intel ICH 82801AA found at IO 0xef00 and 0xe800, MEM 0x0000 and 0x0000, IRQ 10
i810_audio: Audio Controller supports 2 channels.
i810_audio: Defaulting to base 2 channel mode.
i810_audio: Resetting connection 0
ac97_codec: AC97 Audio codec, id: CRY52 (Cirrus Logic CS4299 rev D)
i810_audio: AC'97 codec 0 supports AMAP, total channels = 2
i810_audio: setting clocking to 48566
usbcore: registered new driver usbfs
usbcore: registered new driver hub
USB Universal Host Controller Interface driver v2.2
PCI: Found IRQ 9 for device 0000:00:1f.2
PCI: Sharing IRQ 9 with 0000:01:0b.0
uhci_hcd 0000:00:1f.2: Intel Corp. 82801AA USB
PCI: Setting latency timer of device 0000:00:1f.2 to 64
uhci_hcd 0000:00:1f.2: irq 9, io base 0000ef80
uhci_hcd 0000:00:1f.2: new USB bus registered, assigned bus number 1
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
usb 1-1: new full speed USB device using address 2
usb 1-2: new full speed USB device using address 3
Linux video capture interface: v1.00
drivers/usb/media/ov511.c: USB OV511+ video device found
drivers/usb/media/ov511.c: model: Generic Camera (no ID)
drivers/usb/media/ov511.c: i2c write retries exhausted
drivers/usb/media/ov511.c: Sensor is an OV6620
drivers/usb/media/ov511.c: Device at usb-0000:00:1f.2-1 registered to minor 0
usbcore: registered new driver ov511
drivers/usb/media/ov511.c: v1.64 for Linux 2.5 : ov511 USB Camera Driver
eth0: register usbnet at usb-0000:00:1f.2-2, ASIX AX8817x USB 2.0 Ethernet
usbcore: registered new driver usbnet
agpgart: Detected an Intel i810 E Chipset.
agpgart: Maximum main memory to use for agp memory: 93M
agpgart: AGP aperture is 64M @ 0xf8000000
hw_random hardware driver 1.0.0 loaded
cpci_hotplug: CompactPCI Hot Plug Core version: 0.2
pci_hotplug: PCI Hot Plug PCI Core version: 0.5
pciehp: acpi_pciehprm:get_device PCI ROOT HID fail=0x1001
shpchp: acpi_shpchprm:get_device PCI ROOT HID fail=0x1001
usb 1-2: control timeout on ep0in
usb 1-2: control timeout on ep0in
Real Time Clock Driver v1.12
input: PC Speaker
parport: PnPBIOS parport detected.
parport0: PC-style at 0x378 (0x778), irq 7, dma 3 [PCSPP,TRISTATE,COMPAT,ECP,DMA]
parport0: Printer, HEWLETT-PACKARD DESKJET 840C
inserting floppy driver for 2.6.8-2-686
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
NET: Registered protocol family 10
Disabled Privacy Extensions on device c0300140(lo)
IPv6 over IPv4 tunneling driver
usb 1-2: control timeout on ep0in
usb 1-2: control timeout on ep0in
Adding 65528k swap on /mnt/hda1/swap/swap1.  Priority:-2 extents:14
Adding 65528k swap on /mnt/hda1/swap/swap2.  Priority:-3 extents:7
Adding 65528k swap on /mnt/hda1/swap/swap3.  Priority:-4 extents:2
Disabled Privacy Extensions on device c11a6800(sit0)
usb 1-2: control timeout on ep0in
NET: Registered protocol family 17
usb 1-2: control timeout on ep0in
usb 1-2: control timeout on ep0in
eth0: no IPv6 routers present
[drm] Initialized i810 1.4.0 20030605 on minor 0: Intel Corp. 82810E DC-133 CGC [Chipset Graphics Controller]
mtrr: base(0xf8000000) is not aligned on a size(0x360000) boundary
[drm:i810_unlock] *ERROR* Process 3243 using kernel context 0
usb 1-2: control timeout on ep0in
usb 1-2: control timeout on ep0in
usb 1-2: control timeout on ep0in
usb 1-2: control timeout on ep0in