Linux version 2.6.32.20 (juhosg@idared) (gcc version 4.3.3 (GCC) ) #1 Sun Sep 26 21:22:28 CEST 2010 prom: fw_arg0=00000003, fw_arg1=a1f87fb0, fw_arg2=a1f883d0, fw_arg3=00000004 MyLoader: sysp=f0f0f0f0, boardp=f0f0f0f0, parts=f0f0f0f0 bootconsole [early0] enabled CPU revision is: 00019374 (MIPS 24Kc) Atheros AR7241 rev 1, CPU:400.000 MHz, AHB:200.000 MHz, DDR:400.000 MHz Determined physical RAM map: memory: 02000000 @ 00000000 (usable) Initrd not found or empty - disabling initrd Zone PFN ranges: Normal 0x00000000 -> 0x00002000 Movable zone start PFN for each node early_node_map[1] active PFN ranges 0: 0x00000000 -> 0x00002000 On node 0 totalpages: 8192 free_area_init_node: node 0, pgdat 802a9590, node_mem_map 81000000 Normal zone: 64 pages used for memmap Normal zone: 0 pages reserved Normal zone: 8128 pages, LIFO batch:0 Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128 Kernel command line: rootfstype=squashfs,jffs2 noinitrd console=ttyS0,115200 board=TL-MR3420 PID hash table entries: 128 (order: -3, 512 bytes) Dentry cache hash table entries: 4096 (order: 2, 16384 bytes) Inode-cache hash table entries: 2048 (order: 1, 8192 bytes) Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes. Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes Writing ErrCtl register=00000000 Readback ErrCtl register=00000000 Memory: 27928k/32768k available (1972k kernel code, 4840k reserved, 371k data, 1696k init, 0k highmem) SLUB: Genslabs=7, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 Hierarchical RCU implementation. NR_IRQS:56 Calibrating delay loop... 266.24 BogoMIPS (lpj=1331200) Mount-cache hash table entries: 512 NET: Registered protocol family 16 MIPS: machine is TP-LINK TL-MR3420 registering PCI controller with io_map_base unset bio: create slab at 0 pci 0000:00:00.0: fixup device configuration pci 0000:00:00.0: reg 10 64bit mmio: [0x000000-0x00ffff] pci 0000:00:00.0: supports D1 pci 0000:00:00.0: PME# supported from D0 D1 D3hot pci 0000:00:00.0: PME# disabled PCI: mapping irq 48 to pin1@0000:00:00.0 Switching to clocksource MIPS NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 1024 (order: 1, 8192 bytes) TCP bind hash table entries: 1024 (order: 0, 4096 bytes) TCP: Hash tables configured (established 1024 bind 1024) TCP reno registered NET: Registered protocol family 1 squashfs: version 4.0 (2009/01/31) Phillip Lougher Registering mini_fo version $Id$ JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 RedHat, Inc. msgmni has been set to 54 io scheduler noop registered io scheduler deadline registered (default) Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A console [ttyS0] enabled, bootconsole disabled Atheros AR71xx SPI Controller driver version 0.2.4 m25p80 spi0.0: s25sl032a (4096 Kbytes) spi0.0: searching for MyLoader partition table at offset 0x10000 spi0.0: searching for MyLoader partition table at offset 0x20000 spi0.0: searching for MyLoader partition table at offset 0x30000 spi0.0: searching for MyLoader partition table at offset 0x40000 spi0.0: no MyLoader partition table found Searching for RedBoot partition table in spi0.0 at offset 0x3e0000 Searching for RedBoot partition table in spi0.0 at offset 0x3f0000 No RedBoot partition table detected in spi0.0 spi0.0: no WRT160NL signature found Creating 5 MTD partitions on "spi0.0": 0x000000000000-0x000000020000 : "u-boot" 0x000000020000-0x000000160000 : "kernel" 0x000000160000-0x0000003f0000 : "rootfs" mtd: partition "rootfs" set to be root filesystem split_squashfs: no squashfs found in "spi0.0" 0x0000003f0000-0x000000400000 : "art" 0x000000020000-0x0000003f0000 : "firmware" ag71xx_mdio: probed eth0: Atheros AG71xx at 0xba000000, irq 5 eth0: Found an AR7240 built-in switch eth1: Atheros AG71xx at 0xb9000000, irq 4 eth1: using fixed link parameters Atheros AR71xx hardware watchdog driver version 0.1.0 ar71xx-wdt: timeout=15 secs (max=21) TCP westwood registered NET: Registered protocol family 17 802.1Q VLAN Support v1.8 Ben Greear All bugs added by David S. Miller Freeing unused kernel memory: 1696k freed gpio-buttons driver version 0.1.2 input: gpio-buttons as /devices/platform/gpio-buttons/input/input0 Button Hotplug driver version 0.4.1 eth0: link up (1000Mbps/Full duplex) Registered led device: tl-mr3420:green:system Registered led device: tl-mr3420:green:qss Registered led device: tl-mr3420:green:3g eth0: link down eth0: link up (1000Mbps/Full duplex) device eth0 entered promiscuous mode br-lan: port 1(eth0) entering forwarding state eth1: link up (100Mbps/Full duplex) Compat-wireless backport release: compat-wireless--2010-09-02-9-gf63dbfd Backport based on wireless-2.6.git v2.6.36-rc4-47529-g4697e4e cfg80211: Calling CRDA to update world regulatory domain SCSI subsystem initialized cfg80211: World regulatory domain updated: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb PCI: Setting latency timer of device 0000:00:00.0 to 64 ath: EEPROM regdomain: 0x0 ath: EEPROM indicates default country code should be used ath: doing EEPROM country->regdmn map search ath: country maps to regdmn code: 0x3a ath: Country alpha2 being used: US ath: Regpair used: 0x3a phy0: Selected rate control algorithm 'minstrel_ht' Registered led device: ath9k-phy0::radio Registered led device: ath9k-phy0::assoc Registered led device: ath9k-phy0::tx Registered led device: ath9k-phy0::rx phy0: Atheros AR9287 Rev:2 mem=0xb0000000, irq=48 cfg80211: Calling CRDA for country: US PPP generic driver version 2.4.2 cfg80211: Regulatory domain changed to country: US (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm) (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 1700 mBm) (5250000 KHz - 5330000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) (5490000 KHz - 5600000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) (5650000 KHz - 5710000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 3000 mBm) ip_tables: (C) 2000-2006 Netfilter Core Team NET: Registered protocol family 24 ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver ar71xx-ehci ar71xx-ehci: Atheros AR91xx built-in EHCI controller ar71xx-ehci ar71xx-ehci: new USB bus registered, assigned bus number 1 ar71xx-ehci ar71xx-ehci: irq 3, io mem 0x1b000000 ar71xx-ehci ar71xx-ehci: USB 2.0 started, EHCI 1.00 usb usb1: configuration #1 chosen from 1 choice hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected nf_conntrack version 0.5.0 (462 buckets, 1848 max) usb 1-1: new high speed USB device using ar71xx-ehci and address 2 ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver Initializing USB Mass Storage driver... usbcore: registered new interface driver usb-storage USB Mass Storage support registered. usb 1-1: configuration #1 chosen from 1 choice scsi0 : SCSI emulation for USB Mass Storage devices usb-storage: device found at 2 usb-storage: waiting for device to settle before scanning ar71xx-wdt: enabling watchdog timer scsi 0:0:0:0: Direct-Access Kingston DataTraveler 2.0 1.00 PQ: 0 ANSI: 2 usb-storage: device scan complete sd 0:0:0:0: [sda] 7856128 512-byte logical blocks: (4.02 GB/3.74 GiB) sd 0:0:0:0: [sda] Write Protect is off sd 0:0:0:0: [sda] Mode Sense: 23 00 00 00 sd 0:0:0:0: [sda] Assuming drive cache: write through sd 0:0:0:0: [sda] Assuming drive cache: write through sda: sda1 sd 0:0:0:0: [sda] Assuming drive cache: write through sd 0:0:0:0: [sda] Attached SCSI removable disk root@OpenWrt:/#