U-Boot 1.1.4 (Mar 3 2008 - 16:51:36) U-Boot code: 00000000 -> 0001A410 BSS: -> 0001F354 IRQ Stack: 00e6ff7c FIQ Stack: 00e6ef7c RAM Configuration: Bank #0: 00000000 32 MB Flash Manufacturer: Unknown(0x1c) Flash: 0 kB *** Warning - bad CRC, using default environment In: serial Out: serial Err: serial PLL clock at 250MHz CPU clock at 250MHz AHB clock at 125MHz APB clock at 62MHz Hit any key to stop autoboot: 3 kernel:30060000-301e0000 0 Star Equuleus # setenv serverip 192.168.1.254; setenv ipaddr 192.168.1.1 Star Equuleus # tftp 0x1000000 openwrt-cns21xx-ns-k330-zImage-initramfs; go 0x1000000 Check Link Status .....Up Waiting 3 seconds .. TFTP from server 192.168.1.254; our IP address is 192.168.1.1 Filename 'openwrt-cns21xx-ns-k330-zImage-initramfs'. Load address: 0x1000000 Loading: ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################# done Bytes transferred = 1832544 (1bf660 hex) ## Starting application at 0x01000000 ... Uncompressing Linux... done, booting the kernel. Linux version 2.6.37-rc7 (juhosg@idared) (gcc version 4.3.5 (GCC) ) #1 Wed Dec 29 11:05:24 CET 2010 CPU: FA526 [66015261] revision 1 (ARMv4), cr=0000397f CPU: VIVT data cache, VIVT instruction cache Machine: NS-K330 NAS Ignoring unrecognised tag 0x00000000 Memory policy: ECC disabled, Data cache writeback pcpu-alloc: s0 r0 d32768 u32768 alloc=1*32768 pcpu-alloc: [0] 0 Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128 Kernel command line: console=ttyS0,38400 rootfstype=squashfs,jffs2 noinitrd PID hash table entries: 128 (order: -3, 512 bytes) Dentry cache hash table entries: 4096 (order: 2, 16384 bytes) Inode-cache hash table entries: 2048 (order: 1, 8192 bytes) Memory: 32MB = 32MB total Memory: 27232k/27232k available, 5536k reserved, 0K highmem Virtual kernel memory layout: vector : 0xffff0000 - 0xffff1000 ( 4 kB) fixmap : 0xfff00000 - 0xfffe0000 ( 896 kB) DMA : 0xffc00000 - 0xffe00000 ( 2 MB) vmalloc : 0xc2800000 - 0xd0000000 ( 216 MB) lowmem : 0xc0000000 - 0xc2000000 ( 32 MB) modules : 0xbf000000 - 0xc0000000 ( 16 MB) .init : 0xc0008000 - 0xc02c9000 (2820 kB) .text : 0xc02c9000 - 0xc04f8000 (2236 kB) .data : 0xc04f8000 - 0xc05090a0 ( 69 kB) NR_IRQS:96 Calibrating delay loop... 191.69 BogoMIPS (lpj=958464) pid_max: default: 32768 minimum: 301 Mount-cache hash table entries: 512 CPU: Testing write buffer coherency: ok NET: Registered protocol family 16 bio: create slab at 0 NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 1024 (order: 1, 8192 bytes) TCP bind hash table entries: 1024 (order: 0, 4096 bytes) TCP: Hash tables configured (established 1024 bind 1024) TCP reno registered UDP hash table entries: 256 (order: 0, 4096 bytes) UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) NET: Registered protocol family 1 squashfs: version 4.0 (2009/01/31) Phillip Lougher Registering mini_fo version $Id$ JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc. msgmni has been set to 53 io scheduler noop registered io scheduler deadline registered (default) Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled serial8250.0: ttyS0 at MMIO 0x78000000 (irq = 9) is a 16550A console [ttyS0] enabled m25p80 spi0.0: found en25p32, expected m25p80 m25p80 spi0.0: en25p32 (4096 Kbytes) Creating 5 MTD partitions on "spi0.0": 0x000000000000-0x000000040000 : "boot" 0x000000040000-0x000000060000 : "config" 0x000000060000-0x000000160000 : "kernel" 0x000000160000-0x0000003f0000 : "rootfs" mtd: partition "rootfs" set to be root filesystem split_squashfs: no squashfs found in "spi0.0" 0x000000060000-0x0000003f0000 : "firmware" cns21xx-spi cns21xx-spi: iomem at 71000000 net eth0: Internal PHY TCP westwood registered NET: Registered protocol family 17 802.1Q VLAN Support v1.8 Ben Greear All bugs added by David S. Miller Freeing init memory: 2820K input: gpio-keys as /devices/platform/gpio-keys/input/input0 Button Hotplug driver version 0.4.1 - preinit - Press the [f] key and hit [enter] to enter failsafe mode - regular preinit - - preinit ip deconfig - - init - Please press Enter to activate this console. device eth0 entered promiscuous mode br-lan: port 1(eth0) entering forwarding state br-lan: port 1(eth0) entering forwarding state net eth0: link up (100Mbps/Full duplex) SCSI subsystem initialized usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb PPP generic driver version 2.4.2 ip_tables: (C) 2000-2006 Netfilter Core Team NET: Registered protocol family 24 ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver cns21xx-ehci cns21xx-ehci: cns21xx-ehci cns21xx-ehci cns21xx-ehci: new USB bus registered, assigned bus number 1 cns21xx-ehci cns21xx-ehci: irq 24, io mem 0xcc000000 cns21xx-ehci cns21xx-ehci: USB 2.0 started, EHCI 1.00 hub 1-0:1.0: USB hub found hub 1-0:1.0: 2 ports detected nf_conntrack version 0.5.0 (469 buckets, 1876 max) ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver cns21xx-ohci cns21xx-ohci: cns21xx-ohci cns21xx-ohci cns21xx-ohci: new USB bus registered, assigned bus number 2 cns21xx-ohci cns21xx-ohci: irq 23, io mem 0xc4000000 hub 2-0:1.0: USB hub found hub 2-0:1.0: 2 ports detected Initializing USB Mass Storage driver... usbcore: registered new interface driver usb-storage USB Mass Storage support registered. usb 2-1: new full speed USB device using cns21xx-ohci and address 2 usb 2-1: not running at top speed; connect to a high speed hub scsi0 : usb-storage 2-1:1.0 scsi 0:0:0:0: Direct-Access Kingston DataTraveler 2.0 1.00 PQ: 0 ANSI: 2 sd 0:0:0:0: [sda] 7856128 512-byte logical blocks: (4.02 GB/3.74 GiB) sd 0:0:0:0: [sda] Write Protect is off sd 0:0:0:0: [sda] Assuming drive cache: write through sd 0:0:0:0: [sda] Assuming drive cache: write through sda: sda1 sd 0:0:0:0: [sda] Assuming drive cache: write through sd 0:0:0:0: [sda] Attached SCSI removable disk BusyBox v1.17.3 (2010-12-27 13:46:44 CET) built-in shell (ash) Enter 'help' for a list of built-in commands. _______ ________ __ | |.-----.-----.-----.| | | |.----.| |_ | - || _ | -__| || | | || _|| _| |_______|| __|_____|__|__||________||__| |____| |__| W I R E L E S S F R E E D O M KAMIKAZE (bleeding edge, r24843) ------------------ * 10 oz Vodka Shake well with ice and strain * 10 oz Triple sec mixture into 10 shot glasses. * 10 oz lime juice Salute! --------------------------------------------------- root@OpenWrt:/#