Linux version 2.6.38.4 (alex@motard) (gcc version 4.6.0 (GCC) ) #10 Tue Apr 26 21:41:48 EEST 2011 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009fc00 (usable) BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved) BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 0000000004000000 (usable) BIOS-e820: 00000000fff00000 - 0000000100000000 (reserved) Notice: NX (Execute Disable) protection missing in CPU! DMI not present or invalid. last_pfn = 0x4000 max_arch_pfn = 0x100000 init_memory_mapping: 0000000000000000-0000000004000000 64MB LOWMEM available. mapped low ram: 0 - 04000000 low ram: 0 - 04000000 Zone PFN ranges: DMA 0x00000010 -> 0x00001000 Normal 0x00001000 -> 0x00004000 Movable zone start PFN for each node early_node_map[2] active PFN ranges 0: 0x00000010 -> 0x0000009f 0: 0x00000100 -> 0x00004000 Using APIC driver default No local APIC present or hardware disabled APIC: disable apic facility APIC: switched to apic NOOP Allocating PCI resources starting at 4000000 (gap: 4000000:fbf00000) Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16143 Kernel command line: block2mtd.block2mtd=/dev/sda2,131072,rootfs root=/dev/mtdblock0 rootfstype=jffs2 rootwait console=ttyS0,38400n8 noinitrd reboot=bios PID hash table entries: 256 (order: -2, 1024 bytes) Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) Initializing CPU#0 Memory: 62272k/65536k available (1382k kernel code, 2812k reserved, 474k data, 180k init, 0k highmem) virtual kernel memory layout: fixmap : 0xfffa3000 - 0xfffff000 ( 368 kB) vmalloc : 0xc4800000 - 0xfffa1000 ( 951 MB) lowmem : 0xc0000000 - 0xc4000000 ( 64 MB) .init : 0xc11d1000 - 0xc11fe000 ( 180 kB) .data : 0xc1159be6 - 0xc11d04f0 ( 474 kB) .text : 0xc1000000 - 0xc1159be6 (1382 kB) Checking if this processor honours the WP bit even in supervisor mode...Ok. NR_IRQS:288 console [ttyS0] enabled Calibrating delay loop... 66.35 BogoMIPS (lpj=331776) pid_max: default: 32768 minimum: 301 Mount-cache hash table entries: 512 CPU: AMD 486 DX/4-WB stepping 04 Checking 'hlt' instruction... OK. Performance Events: no PMU driver, software events only. devtmpfs: initialized NET: Registered protocol family 16 PCI: PCI BIOS revision 2.01 entry at 0xf7861, last bus=0 PCI: Using configuration type 1 for base access bio: create slab at 0 SCSI subsystem initialized PCI: Probing PCI hardware Switching to clocksource pit NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 2048 (order: 2, 16384 bytes) TCP bind hash table entries: 2048 (order: 1, 8192 bytes) TCP: Hash tables configured (established 2048 bind 2048) TCP reno registered UDP hash table entries: 256 (order: 0, 4096 bytes) UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) NET: Registered protocol family 1 platform rtc_cmos: registered platform RTC device (no PNP device found) scx200: NatSemi SCx200 Driver squashfs: version 4.0 (2009/01/31) Phillip Lougher JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc. msgmni has been set to 121 io scheduler noop registered io scheduler deadline registered (default) Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A serial8250: ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A Non-volatile memory driver v1.3 scx200_gpio: no SCx200 gpio present scsi0 : pata_legacy ata1: PATA max PIO4 cmd 0x1f0 ctl 0x3f6 irq 14 ata1.00: CFA: HYPERSTONE FLASH DISK, 30/06/03, max PIO2 ata1.00: 253952 sectors, multi 0: LBA ata1.00: configured for PIO scsi 0:0:0:0: Direct-Access ATA HYPERSTONE FLASH 30/0 PQ: 0 ANSI: 5 sd 0:0:0:0: [sda] 253952 512-byte logical blocks: (130 MB/124 MiB) sd 0:0:0:0: [sda] Write Protect is off sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA sda: sda1 sda2 sd 0:0:0:0: [sda] Attached SCSI removable disk scsi1 : pata_legacy ata2: PATA max PIO4 cmd 0x170 ctl 0x376 irq 15 Creating 1 MTD partitions on "rootfs": 0x000000000000-0x000003020000 : "rootfs" split_squashfs: no squashfs found in "rootfs" block2mtd: mtd0: [rootfs] erase_size = 128KiB [131072] natsemi dp8381x driver, version 2.1, Sept 11, 2006 originally by Donald Becker 2.4.x kernel port by Jeff Garzik, Tjeerd Mulder natsemi eth0: NatSemi DP8381[56] at 0xa0000000 (0000:00:14.0), 00:05:d5:01:23:4a, IRQ 10, port TP. rtc_cmos rtc_cmos: rtc core: registered rtc_cmos as rtc0 rtc0: alarms up to one day, 114 bytes nvram geodewdt: No timers were available sc520_wdt: WDT driver for SC520 initialised. timeout=30 sec (nowayout=0) sc1200wdt: build 20020303 sc1200wdt: io parameter must be specified cpuidle: using governor ladder cpuidle: using governor menu cs5535-clockevt: Could not allocate MFPGT timer TCP westwood registered NET: Registered protocol family 17 Using IPI Shortcut mode rtc_cmos rtc_cmos: setting system clock to 1980-01-01 00:00:24 UTC (315532824) JFFS2 notice: (1) jffs2_build_xattr_subsystem: complete building xattr subsystem, 0 of xdatum (0 unchecked, 0 orphan) and 0 of xref (0 dead, 0 orphan) found. VFS: Mounted root (jffs2 filesystem) readonly on device 31:0. devtmpfs: mounted Freeing unused kernel memory: 180k freed - preinit - Press the [f] key and hit [enter] to enter failsafe mode - regular preinit - - init - Please press Enter to activate this console. eth0: DSPCFG accepted after 0 usec. sc520_wdt: Watchdog timer is now enabled. sc520_wdt: Watchdog timer is now enabled. eth0: Autonegotiation advertising 0x5e1 partner 0x45e1. eth0: link up. eth0: Setting full-duplex based on negotiated link capability. BusyBox v1.18.4 (2011-04-25 10:40:01 EEST) built-in shell (ash) Enter 'help' for a list of built-in commands. _______ ________ __ | |.-----.-----.-----.| | | |.----.| |_ | - || _ | -__| || | | || _|| _| |_______|| __|_____|__|__||________||__| |____| |__| W I R E L E S S F R E E D O M ATTITUDE ADJUSTMENT (bleeding edge, r26751) ---------- * 1/4 oz Vodka Pour all ingredents into mixing * 1/4 oz Gin tin with ice, strain into glass. * 1/4 oz Amaretto * 1/4 oz Triple sec * 1/4 oz Peach schnapps * 1/4 oz Sour mix * 1 splash Cranberry juice ----------------------------------------------------- root@OpenWrt:/# cat /proc/cpuinfo processor : 0 vendor_id : AuthenticAMD cpu family : 4 model : 9 model name : 486 DX/4-WB stepping : 4 fdiv_bug : no hlt_bug : no f00f_bug : no coma_bug : no fpu : yes fpu_exception : yes cpuid level : 1 wp : yes flags : fpu bogomips : 66.35 clflush size : 32 cache_alignment : 32 address sizes : 32 bits physical, 32 bits virtual power management: root@OpenWrt:/# free total used free shared buffers Mem: 62452 9200 53252 0 4280 -/+ buffers: 4920 57532 Swap: 0 0 0 root@OpenWrt:/# df Filesystem 1K-blocks Used Available Use% Mounted on /dev/root 49280 2444 46836 5% / root@OpenWrt:/# opkg list_installed base-files - 68-r26751 busybox - 1.18.4-1 dropbear - 0.53.1-3 grub - 0.97-3 hotplug2 - 1.0-beta-4 libc - 0.9.32-68 libgcc - 4.6.0-68 librpc - 0.9.32-rc2-0a2179bbc0844928f2a0ec01dba93d9b5d6d41a7 libuci - 2011-03-27.2-1 mtd - 15 opkg - 618-1 uci - 2011-03-27.2-1 root@OpenWrt:/# cat /proc/interrupts CPU0 0: 7208 XT-PIC-XT-PIC timer 2: 0 XT-PIC-XT-PIC cascade 4: 246 XT-PIC-XT-PIC serial 8: 0 XT-PIC-XT-PIC rtc0 10: 7 XT-PIC-XT-PIC eth0 14: 8580 XT-PIC-XT-PIC platform NMI: 0 Non-maskable interrupts LOC: 0 Local timer interrupts SPU: 0 Spurious interrupts PMI: 0 Performance monitoring interrupts IWI: 0 IRQ work interrupts THR: 0 Threshold APIC interrupts MCE: 0 Machine check exceptions MCP: 0 Machine check polls ERR: 0 MIS: 0 root@OpenWrt:/#