Linux version 2.6.22.18-Netgear (mostafah@es5x86.axentra.com) (gcc version 4.2.1) #16 Sun Jun 13 19:54:46 EDT 2010 CPU: ARM926EJ-S [56251311] revision 1 (ARMv5TE), cr=00053977 Machine: Feroceon-KW Using UBoot passing parameters structure Memory policy: ECC disabled, Data cache writeback On node 0 totalpages: 32768 DMA zone: 256 pages used for memmap DMA zone: 0 pages reserved DMA zone: 32512 pages, LIFO batch:7 Normal zone: 0 pages used for memmap CPU0: D VIVT write-back cache CPU0: I cache: 16384 bytes, associativity 4, 32 byte lines, 128 sets CPU0: D cache: 16384 bytes, associativity 4, 32 byte lines, 128 sets Built 1 zonelists. Total pages: 32512 Kernel command line: console=ttyS0,115200 ubi.mtd=2,2048 root=ubi0:rootfs rootfstype=ubifs init=/linuxrc PID hash table entries: 512 (order: 9, 2048 bytes) Console: colour dummy device 80x30 Dentry cache hash table entries: 16384 (order: 4, 65536 bytes) Inode-cache hash table entries: 8192 (order: 3, 32768 bytes) Memory: 64MB 64MB 0MB 0MB = 128MB total Memory: 124800KB available (4048K code, 268K data, 692K init) Calibrating delay loop... 992.87 BogoMIPS (lpj=4964352) Mount-cache hash table entries: 512 CPU: Testing write buffer coherency: ok NET: Registered protocol family 16 CPU Interface ------------- SDRAM_CS0 ....base 00000000, size 64MB SDRAM_CS1 ....base 04000000, size 64MB SDRAM_CS2 ....disable SDRAM_CS3 ....disable PEX0_MEM ....base e8000000, size 128MB PEX0_IO ....base f2000000, size 1MB INTER_REGS ....base f1000000, size 1MB NFLASH_CS ....base fa000000, size 2MB SPI_CS ....base f4000000, size 16MB BOOT_ROM_CS ....no such DEV_BOOTCS ....no such CRYPT_ENG ....base f0000000, size 2MB Marvell Development Board (LSP Version KW_LSP_4.2.7_patch21)-- RD-88F6281A Soc: 88F6281 A1 LE Detected Tclk 200000000 and SysClk 333333333 MV Buttons Device Load Marvell USB EHCI Host controller #0: c063d600 PEX0 interface detected no Link. PCI: bus0: Fast back to back transfers enabled SCSI subsystem initialized usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb NET: Registered protocol family 2 Time: kw_clocksource clocksource has been installed. IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 4096 (order: 3, 32768 bytes) TCP bind hash table entries: 4096 (order: 2, 16384 bytes) TCP: Hash tables configured (established 4096 bind 4096) TCP reno registered RTC has been updated!!! RTC registered Use the XOR engines (acceleration) for enhancing the following functions: o RAID 5 Xor calculation o kernel memcpy o kenrel memzero Number of XOR engines to use: 4 cesadev_init(c000eed0) mvCesaInit: sessions=640, queue=64, pSram=f0000000 MV Buttons Driver Load JFFS2 version 2.2. (NAND) 2001-2006 Red Hat, Inc. io scheduler noop registered io scheduler anticipatory registered (default) Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing disabled serial8250.0: ttyS0 at MMIO 0xf1012000 (irq = 33) is a 16550A serial8250.0: ttyS1 at MMIO 0xf1012100 (irq = 34) is a 16550A loop: module loaded Loading Marvell Ethernet Driver: o Cached descriptors in DRAM o DRAM SW cache-coherency o Multi RX Queue support - 4 RX queues o Multi TX Queue support - 2 TX Queues o TCP segmentation offload enabled o Receive checksum offload enabled o Transmit checksum offload enabled o Network Fast Processing (Routing) supported o Network Fast Processing (NAT) supported o Driver ERROR statistics enabled o Driver INFO statistics enabled o Proc tool API enabled o Gateway support enabled o Using Marvell Header Mode o L2 IGMP support o Rx descripors: q0=128 q1=128 q2=128 q3=128 o Tx descripors: q0=532 q1=532 o Loading network interface(s): o eth0, ifindex = 1, GbE port = 0 o eth1, ifindex = 2, GbE port = 1 mvFpRuleDb (c7977000): 1024 entries, 4096 bytes Intel(R) PRO/1000 Network Driver - version 7.3.20-k2-NAPI Copyright (c) 1999-2006 Intel Corporation. e100: Intel(R) PRO/100 Network Driver, 3.5.17-k4-NAPI e100: Copyright(c) 1999-2006 Intel Corporation Integrated Sata device found scsi0 : Marvell SCSI to SATA adapter scsi1 : Marvell SCSI to SATA adapter scsi 0:0:0:0: Direct-Access Hitachi HDS721010CLA332 JP4O PQ: 0 ANSI: 5 scsi 1:0:0:0: Direct-Access Hitachi HDS721010CLA332 JP4O PQ: 0 ANSI: 5 sd 0:0:0:0: [sda] 1953525168 512-byte hardware sectors (1000205 MB) sd 0:0:0:0: [sda] Write Protect is off sd 0:0:0:0: [sda] Mode Sense: 23 00 10 00 sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, supports DPO and FUA sd 0:0:0:0: [sda] 1953525168 512-byte hardware sectors (1000205 MB) sd 0:0:0:0: [sda] Write Protect is off sd 0:0:0:0: [sda] Mode Sense: 23 00 10 00 sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, supports DPO and FUA sda: sda1 sd 0:0:0:0: [sda] Attached SCSI disk sd 1:0:0:0: [sdb] 1953525168 512-byte hardware sectors (1000205 MB) sd 1:0:0:0: [sdb] Write Protect is off sd 1:0:0:0: [sdb] Mode Sense: 23 00 10 00 sd 1:0:0:0: [sdb] Write cache: enabled, read cache: enabled, supports DPO and FUA sd 1:0:0:0: [sdb] 1953525168 512-byte hardware sectors (1000205 MB) sd 1:0:0:0: [sdb] Write Protect is off sd 1:0:0:0: [sdb] Mode Sense: 23 00 10 00 sd 1:0:0:0: [sdb] Write cache: enabled, read cache: enabled, supports DPO and FUA sdb: unknown partition table sd 1:0:0:0: [sdb] Attached SCSI disk sd 0:0:0:0: Attached scsi generic sg0 type 0 sd 1:0:0:0: Attached scsi generic sg1 type 0 NFTL driver: nftlcore.c $Revision: 1.98 $, nftlmount.c $Revision: 1.41 $ NAND device: Manufacturer ID: 0xec, Chip ID: 0xda (Samsung NAND 256MiB 3,3V 8-bit) Scanning device for bad blocks Bad eraseblock 258 at 0x02040000 Bad eraseblock 1251 at 0x09c60000 Using static partition definition Creating 3 MTD partitions on "nand_mtd": 0x00000000-0x00100000 : "u-boot" 0x00100000-0x00700000 : "uImage" 0x00700000-0x10000000 : "root" UBI: attaching mtd2 to ubi0 UBI: physical eraseblock size: 131072 bytes (128 KiB) UBI: logical eraseblock size: 126976 bytes UBI: smallest flash I/O unit: 2048 UBI: sub-page size: 512 UBI: VID header offset: 2048 (aligned 2048) UBI: data offset: 4096 UBI warning: ubi_eba_init_scan: cannot reserve enough PEBs for bad PEB handling, reserved 19, need 38 UBI: attached mtd2 to ubi0 UBI: MTD device name: "root" UBI: MTD device size: 249 MiB UBI: number of good PEBs: 1990 UBI: number of bad PEBs: 2 UBI: max. allowed volumes: 128 UBI: wear-leveling threshold: 4096 UBI: number of internal volumes: 1 UBI: number of user volumes: 1 UBI: available PEBs: 0 UBI: total number of reserved PEBs: 1990 UBI: number of PEBs reserved for bad PEB handling: 19 UBI: max/mean erase counter: 3/0 UBI: background thread "ubi_bgt0d" started, PID 296 ehci_marvell ehci_marvell.70059: Marvell Orion EHCI ehci_marvell ehci_marvell.70059: new USB bus registered, assigned bus number 1 ehci_marvell ehci_marvell.70059: irq 19, io base 0xf1050100 ehci_marvell ehci_marvell.70059: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004 usb usb1: configuration #1 chosen from 1 choice hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected ohci_hcd: 2006 August 04 USB 1.1 'Open' Host Controller (OHCI) Driver USB Universal Host Controller Interface driver v3.0 usbcore: registered new interface driver usblp drivers/usb/class/usblp.c: v0.13: USB Printer Device Class driver Initializing USB Mass Storage driver... usbcore: registered new interface driver usb-storage USB Mass Storage support registered. mice: PS/2 mouse device common for all mice i2c /dev entries driver md: linear personality registered for level -1 md: raid0 personality registered for level 0 md: raid1 personality registered for level 1 raid6: int32x1 81 MB/s raid6: int32x2 95 MB/s raid6: int32x4 102 MB/s raid6: int32x8 92 MB/s raid6: using algorithm int32x4 (102 MB/s) md: raid6 personality registered for level 6 md: raid5 personality registered for level 5 md: raid4 personality registered for level 4 raid5: measuring checksumming speed arm4regs : 903.600 MB/sec 8regs : 629.200 MB/sec 32regs : 750.000 MB/sec raid5: using function: arm4regs (903.600 MB/sec) device-mapper: ioctl: 4.11.0-ioctl (2006-10-12) initialised: dm-devel@redhat.com dm_crypt using the OCF package. sdhci: Secure Digital Host Controller Interface driver sdhci: Copyright(c) Pierre Ossman usbcore: registered new interface driver usbhid drivers/hid/usbhid/hid-core.c: v2.6:USB HID core driver Netfilter messages via NETLINK v0.30. nf_conntrack version 0.5.0 (1024 buckets, 8192 max) mvFpNatDb (c7fb0000): 1024 entries, 4096 bytes ip_tables: (C) 2000-2006 Netfilter Core Team TCP cubic registered NET: Registered protocol family 1 NET: Registered protocol family 17 NFP (fdb) init 256 entries, 1024 bytes Bridge firewalling registered 802.1Q VLAN Support v1.8 Ben Greear All bugs added by David S. Miller md: Autodetecting RAID arrays. md: autorun ... md: considering sda1 ... md: adding sda1 ... md: created md0 md: bind md: running: raid1: raid set md0 active with 1 out of 2 mirrors md: ... autorun DONE. Freeing init memory: 692K UBIFS: mounted UBI device 0, volume 0, name "rootfs" UBIFS: file system size: 239857664 bytes (234236 KiB, 228 MiB, 1889 LEBs) UBIFS: journal size: 9023488 bytes (8812 KiB, 8 MiB, 72 LEBs) UBIFS: media format: 4 (latest is 4) UBIFS: default compressor: zlib UBIFS: reserved for root: 0 bytes (0 KiB) mvsdmmc: irq =28 start f1090000 mvsdmmc: irq_detect=92