Voltage: 217
        Status: 0
        Percentage: 100 (at time ffff8b80)
Toggling Charger at time: ffff8b82
val 0 = 122
val 1 = 121
val 2 = 122
val 3 = 121
val 4 = 122
val = 365(121)
Temperature: 121
val 0 = 111
val 1 = 111
val 2 = 111
val 3 = 112
val 4 = 111
val = 333(111)
jkvad: 111
Charge LED On
Charge Full at time: ffff8ba5
Turning Charger Off
Charge LED Off
Charge Full: Charging Finished
ttyS1 at MMIO 0x40200000 (irq = 14) is a BTUART
ttyS2 at MMIO 0x40700000 (irq = 13) is a STUART
input: Corgi Keyboard Registered
input: Corgi Touchscreen Registered
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered
loop: loaded (max 8 devices)
PPP generic driver version 2.4.2
PPP BSD Compression module registered
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
Sharp SL series flash device: 800000 at 0
Using static partision definition
Creating 1 MTD partitions on "sharpsl-flash":
0x00120000-0x007f0000 : "Boot PROM Filesystem"
NAND device: Manufacturer ID: 0xec, Chip ID: 0x79 (Samsung NAND 128MiB 3,3V 8-bit)
Scanning device for bad blocks
Bad eraseblock 32 at 0x00080000
Bad eraseblock 4918 at 0x04cd8000
Bad eraseblock 4930 at 0x04d08000
Creating 3 MTD partitions on "sharpsl-nand":
0x00000000-0x00700000 : "System Area"
0x00700000-0x03c00000 : "Root Filesystem"
0x03c00000-0x08000000 : "Home Filesystem"
pxa2xx_udc: version 4-May-2005
i2c_pxa_transfer: called in slave mode
I2C: i2c-0: PXA I2C adapter
corgi_mci_setpower: on
i2c: error: exhausted retries
i2c: msg_num: 0 msg_idx: -2000 msg_ptr: 0
i2c: ICR: 000007e0 ISR: 00000002
i2c: log: [00000446:000007e0] 
corgi_mci_setpower: on
wm8731_reg_write: writing f, 0
wm8731_reg_write: writing 6, 7f
Corgi audio driver initialize
corgi_mci_setpower: off
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 4096 (order: 3, 32768 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
TCP reno registered
TCP bic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
Empty flash at 0x0041781c ends at 0x00417a00
Charge Full at time: ffff8d30
Turning Charger Off
Charge LED Off
Charge Full: Charging Finished
Empty flash at 0x006d52fc ends at 0x006d5400
jffs2_scan_dirent_node(): Name CRC failed on node at 0x02f739dc: Read 0xffffffff, calculated 0xd3088d4f
Empty flash at 0x02f73a14 ends at 0x02f73c00
Eep. Child "net" (ino #13625) of dir ino #17127 doesn't exist!
Eep. Child "usb" (ino #17155) of dir ino #17129 doesn't exist!
Eep. Child "irda" (ino #19940) of dir ino #17135 doesn't exist!
Inode #22959 was a directory with children - removing those too...
Inode #17127 was a directory with children - removing those too...
Cannot remove child "net", ino #13625, because it doesn't exist
Inode #17128 was a directory with children - removing those too...
Inode #17129 was a directory with children - removing those too...
Cannot remove child "usb", ino #17155, because it doesn't exist
Inode #17135 was a directory with children - removing those too...
Cannot remove child "irda", ino #19940, because it doesn't exist
Inode #19316 was a directory with children - removing those too...
VFS: Mounted root (jffs2 filesystem) readonly.
Freeing init memory: 76K
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffff96b3)
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffff98b0)
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffff9aad)
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffff9caa)
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffff9ea6)
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffa0a2)
usb0: Ethernet Gadget, version: May Day 2005
usb0: using pxa2xx_udc, OUT ep2out-bulk IN ep1in-bulk STATUS ep6in-bulk
usb0: MAC 96:db:b1:3f:cd:d2
usb0: HOST MAC 6e:b1:3a:23:d1:63
usb0: RNDIS ready
usb0: full speed config #1: 100 mA, Ethernet Gadget, using CDC Ethernet Subset
usb0: full speed config #1: 100 mA, Ethernet Gadget, using CDC Ethernet Subset
Eep. Child "vcard" (ino #7846) of dir ino #7796 doesn't exist!
Eep. Child "settings" (ino #7818) of dir ino #7796 doesn't exist!
Inode #3787 was a directory with children - removing those too...
Inode #7796 was a directory with children - removing those too...
Cannot remove child "vcard", ino #7846, because it doesn't exist
Cannot remove child "settings", ino #7818, because it doesn't exist
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffb048)
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffb244)
jffs2_get_inode_nodes(): Data CRC failed on node at 0x0041779c: Read 0x088bcb54, calculated 0xbf74493d
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffb440)
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffb63a)
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffb835)
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffba2f)
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffbc29)
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffbe23)
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffc01f)
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffc21a)
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffc416)
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffc611)
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffc80c)
Probing IDE interface ide0...
hda: Hitachi XX.V.3.3.0.0, CFA DISK drive
ide0 at 0xc4820000-0xc4820007,0xc482000e on irq 40
hda: max request size: 128KiB
hda: 500400 sectors (256 MB) w/1KiB Cache, CHS=695/15/48
hda: cache flushes not supported
 hda: hda1
ide-cs: hda: Vcc = 3.3, Vpp = 0.0
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffca07)
 hda: hda1
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffcc03)
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffcdff)
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffcffc)
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffd1ff)
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffd3f8)
wm8731_reg_write: writing 2, 63
wm8731_reg_write: writing 3, 63
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffd5ec)
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffd7e0)
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffd9d4)
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffdbc8)
Battery Voltage: 216
        Status: 0
        Percentage: 100 (at time ffffddbc)
Battery Voltage: 215
        Status: 0
        Percentage: 100 (at time ffffdfb0)
Battery Voltage: 215
        Status: 0
        Percentage: 100 (at time ffffe1a4)
Battery Voltage: 215
        Status: 0
        Percentage: 100 (at time ffffe398)
Battery Voltage: 215
        Status: 0
        Percentage: 100 (at time ffffe58c)
Battery Voltage: 215
        Status: 0
        Percentage: 100 (at time ffffe780)