smartctl 5.42 2011-10-20 r3458 [x86_64-linux-3.0.0-16-generic] (local build) Copyright (C) 2002-11 by Bruce Allen, http://smartmontools.sourceforge.net === START OF INFORMATION SECTION === Model Family: Seagate Barracuda 7200.12 Device Model: ST31000524AS Serial Number: 6VPG4P29 LU WWN Device Id: 5 000c50 03e6c8aa1 Firmware Version: JC4B User Capacity: 1,000,204,886,016 bytes [1.00 TB] Sector Size: 512 bytes logical/physical Device is: In smartctl database [for details use: -P show] ATA Version is: 8 ATA Standard is: ATA-8-ACS revision 4 Local Time is: Fri Mar 23 23:20:41 2012 CET SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 609) seconds. Offline data collection capabilities: (0x7b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 1) minutes. Extended self-test routine recommended polling time: ( 173) minutes. Conveyance self-test routine recommended polling time: ( 2) minutes. SCT capabilities: (0x103f) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 10 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000f 102 099 006 Pre-fail Always - 95019053 3 Spin_Up_Time 0x0003 100 100 000 Pre-fail Always - 0 4 Start_Stop_Count 0x0032 100 100 020 Old_age Always - 64 5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail Always - 0 7 Seek_Error_Rate 0x000f 073 060 030 Pre-fail Always - 22383974 9 Power_On_Hours 0x0032 097 097 000 Old_age Always - 3214 10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0 12 Power_Cycle_Count 0x0032 100 100 020 Old_age Always - 65 183 Runtime_Bad_Block 0x0032 100 100 000 Old_age Always - 0 184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0 187 Reported_Uncorrect 0x0032 080 080 000 Old_age Always - 20 188 Command_Timeout 0x0032 100 099 000 Old_age Always - 17180131332 189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0 190 Airflow_Temperature_Cel 0x0022 063 052 045 Old_age Always - 37 (Min/Max 29/40) 194 Temperature_Celsius 0x0022 037 048 000 Old_age Always - 37 (0 16 0 0 0) 195 Hardware_ECC_Recovered 0x001a 035 026 000 Old_age Always - 95019053 197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 0 198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 0 199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0 240 Head_Flying_Hours 0x0000 100 253 000 Old_age Offline - 268435456003343 241 Total_LBAs_Written 0x0000 100 253 000 Old_age Offline - 340216966 242 Total_LBAs_Read 0x0000 100 253 000 Old_age Offline - 1794132039 SMART Error Log Version: 1 ATA Error Count: 20 (device log contains only the most recent five errors) CR = Command Register [HEX] FR = Features Register [HEX] SC = Sector Count Register [HEX] SN = Sector Number Register [HEX] CL = Cylinder Low Register [HEX] CH = Cylinder High Register [HEX] DH = Device/Head Register [HEX] DC = Device Command Register [HEX] ER = Error register [HEX] ST = Status register [HEX] Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 20 occurred at disk power-on lifetime: 3208 hours (133 days + 16 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 00 01 ff ff ff 4f 00 00:11:56.923 READ FPDMA QUEUED ef 02 00 00 00 00 00 00 00:11:56.905 SET FEATURES [Enable write cache] 00 00 00 00 00 00 00 ff 00:11:56.789 NOP [Abort queued commands] 60 00 01 ff ff ff 4f 00 00:11:54.034 READ FPDMA QUEUED ef 02 00 00 00 00 00 00 00:11:54.019 SET FEATURES [Enable write cache] Error 19 occurred at disk power-on lifetime: 3208 hours (133 days + 16 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 00 01 ff ff ff 4f 00 00:11:54.034 READ FPDMA QUEUED ef 02 00 00 00 00 00 00 00:11:54.019 SET FEATURES [Enable write cache] 00 00 00 00 00 00 00 ff 00:11:53.908 NOP [Abort queued commands] 60 00 01 ff ff ff 4f 00 00:11:51.165 READ FPDMA QUEUED ef 02 00 00 00 00 00 00 00:11:51.164 SET FEATURES [Enable write cache] Error 18 occurred at disk power-on lifetime: 3208 hours (133 days + 16 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 00 01 ff ff ff 4f 00 00:11:51.165 READ FPDMA QUEUED ef 02 00 00 00 00 00 00 00:11:51.164 SET FEATURES [Enable write cache] 00 00 00 00 00 00 00 ff 00:11:51.052 NOP [Abort queued commands] 60 00 01 ff ff ff 4f 00 00:11:48.309 READ FPDMA QUEUED ef 02 00 00 00 00 00 00 00:11:48.309 SET FEATURES [Enable write cache] Error 17 occurred at disk power-on lifetime: 3208 hours (133 days + 16 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 00 01 ff ff ff 4f 00 00:11:48.309 READ FPDMA QUEUED ef 02 00 00 00 00 00 00 00:11:48.309 SET FEATURES [Enable write cache] 00 00 00 00 00 00 00 ff 00:11:48.197 NOP [Abort queued commands] 60 00 01 ff ff ff 4f 00 00:11:45.459 READ FPDMA QUEUED ef 02 00 00 00 00 00 00 00:11:45.438 SET FEATURES [Enable write cache] Error 16 occurred at disk power-on lifetime: 3208 hours (133 days + 16 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 00 01 ff ff ff 4f 00 00:11:45.459 READ FPDMA QUEUED ef 02 00 00 00 00 00 00 00:11:45.438 SET FEATURES [Enable write cache] 00 00 00 00 00 00 00 ff 00:11:45.324 NOP [Abort queued commands] 60 00 01 ff ff ff 4f 00 00:11:42.556 READ FPDMA QUEUED ef 02 00 00 00 00 00 00 00:11:42.536 SET FEATURES [Enable write cache] SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 3211 - # 2 Extended offline Completed without error 00% 3211 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay.