voyage:~# dmesg Linux version 2.6.15-486-voyage (2.0-10) (root@punknix-uml) (gcc version 3.3.5 (Debian 1:3.3.5-13)) #1 PREEMPT Mon Mar 27 07:45:05 GMT 2006 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009fc00 (usable) BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved) BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 0000000008000000 (usable) BIOS-e820: 00000000fff00000 - 0000000100000000 (reserved) 128MB LOWMEM available. On node 0 totalpages: 32768 DMA zone: 4096 pages, LIFO batch:0 DMA32 zone: 0 pages, LIFO batch:0 Normal zone: 28672 pages, LIFO batch:7 HighMem zone: 0 pages, LIFO batch:0 DMI not present. Allocating PCI resources starting at 10000000 (gap: 08000000:f7f00000) Built 1 zonelists Kernel command line: auto BOOT_IMAGE=Linux ro root=301 console=ttyS0,9600n8 No local APIC present or hardware disabled mapped APIC to ffffd000 (01101000) Initializing CPU#0 PID hash table entries: 1024 (order: 10, 16384 bytes) Detected 266.665 MHz processor. Using tsc for high-res timesource Console: colour dummy device 80x25 Dentry cache hash table entries: 32768 (order: 5, 131072 bytes) Inode-cache hash table entries: 16384 (order: 4, 65536 bytes) Memory: 126696k/131072k available (1606k kernel code, 3956k reserved, 598k data, 140k init, 0k highmem) Checking if this processor honours the WP bit even in supervisor mode... Ok. Calibrating delay using timer specific routine.. 534.51 BogoMIPS (lpj=1069036) Mount-cache hash table entries: 512 CPU: After generic identify, caps: 00808131 01818131 00000000 00000000 00000000 00000000 00000000 CPU: After vendor identify, caps: 00808131 01818131 00000000 00000000 00000000 00000000 00000000 CPU: After all inits, caps: 00808131 00818131 00000000 00000001 00000000 00000000 00000000 CPU: NSC Unknown stepping 01 Checking 'hlt' instruction... OK. NET: Registered protocol family 16 PCI: PCI BIOS revision 2.01 entry at 0xf7861, last bus=0 PCI: Using configuration type 1 PCI: Probing PCI hardware PCI: Probing PCI hardware (bus 00) Initializing Cryptographic API io scheduler noop registered io scheduler anticipatory registered io scheduler deadline registered io scheduler cfq registered i8042.c: Can't read CTR while initializing i8042. Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing enabled serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A serial8250: ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx Probing IDE interface ide0... hda: Hitachi XX.V.3.4.0.0, CFA DISK drive Probing IDE interface ide1... ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 hda: max request size: 128KiB hda: 1000944 sectors (512 MB) w/1KiB Cache, CHS=993/16/63 hda: cache flushes not supported hda: hda1 hda2 mice: PS/2 mouse device common for all mice padlock: VIA PadLock not detected. NET: Registered protocol family 2 IP route cache hash table entries: 2048 (order: 1, 8192 bytes) TCP established hash table entries: 8192 (order: 3, 32768 bytes) TCP bind hash table entries: 8192 (order: 3, 32768 bytes) TCP: Hash tables configured (established 8192 bind 8192) TCP reno registered TCP bic registered NET: Registered protocol family 1 NET: Registered protocol family 10 lo: Disabled Privacy Extensions IPv6 over IPv4 tunneling driver NET: Registered protocol family 17 NET: Registered protocol family 15 Using IPI Shortcut mode hda: hda1 hda2 kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. VFS: Mounted root (ext3 filesystem) readonly. Freeing unused kernel memory: 140k freed EXT3 FS on hda1, internal journal natsemi dp8381x driver, version 1.07+LK1.0.17, Sep 27, 2002 originally by Donald Becker http://www.scyld.com/network/natsemi.html 2.4.x kernel port by Jeff Garzik, Tjeerd Mulder natsemi eth0: NatSemi DP8381[56] at 0xa0000000 (0000:00:06.0), 00:00:24:c3:88:a4, IRQ 10, port TP. natsemi eth1: NatSemi DP8381[56] at 0xa0001000 (0000:00:07.0), 00:00:24:c3:88:a5, IRQ 10, port TP. natsemi eth2: NatSemi DP8381[56] at 0xa0002000 (0000:00:08.0), 00:00:24:c3:88:a6, IRQ 10, port TP. ieee80211_crypt: registered algorithm 'NULL' hostap_pci: 0.4.4-kernel (Jouni Malinen ) SC1x00 Watchdog driver by Inprimis Technolgies. wd1100.c: a few hacks by erich.titl@think.ch : probe failed device-mapper: 4.4.0-ioctl (2005-01-12) initialised: dm-devel@redhat.com EXT3-fs: mounted filesystem with ordered data mode. kjournald starting. Commit interval 5 seconds scx200: NatSemi SCx200 Driver scx200: GPIO base 0x6100 scx200: Configuration Block base 0x6000 SC1200: IDE controller at PCI slot 0000:00:12.2 SC1200: chipset revision 1 SC1200: not 100% native mode: will probe irqs later SC1200: port 0x01f0 already claimed by ide0 ide1: BM-DMA at 0xe008-0xe00f, BIOS settings: hdc:pio, hdd:pio Probing IDE interface ide1... usbcore: registered new driver usbfs usbcore: registered new driver hub ohci_hcd: 2005 April 22 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI) ohci_hcd 0000:00:13.0: OHCI Host Controller ohci_hcd 0000:00:13.0: new USB bus registered, assigned bus number 1 ohci_hcd 0000:00:13.0: irq 5, io mem 0xa0004000 hub 1-0:1.0: USB hub found hub 1-0:1.0: 3 ports detected eth0: DSPCFG accepted after 0 usec. eth0: link up. eth0: Setting full-duplex based on negotiated link capability. WANPIPE(tm) Hardware Support Module Beta10-2.3.4 (c) 1994-2006 Sangoma Technologies Inc WANPIPE(tm) Interface Support Module Beta10-2.3.4 (c) 1994-2006 Sangoma Technologies Inc WANPIPE(tm) PPP/Cisco HDLC Protocol Beta10-2.3.4 (c) 1994-2006 Sangoma Technologies Inc WANPIPE(tm) Multi-Protocol WAN Driver Module Beta10-2.3.4 (c) 1994-2006 Sangoma Technologies Inc wanpipe: Probing for WANPIPE hardware. wanpipe: AFT-A101u T1/E1 card found (HDLC rev.22), cpu(s) 1, bus #0, slot #10, irq #11 wanpipe: Allocating maximum 1 devices: wanpipe1 - wanpipe1. WANPIPE: TDM Codecs Initialized WANPIPE(tm) Socket API Module Beta10-2.3.4 (c) 1994-2006 Sangoma Technologies Inc NET: Registered protocol family 25 WANPIPE(tm) L.I.P Network Layer Beta10-2.3.4 (c) 1995-2004 Sangoma Technologies Inc. WanpipeLIP: Protocols: FR PPP CHDLC LIP_ATM WANPIPE(tm) WANEC Layer Beta10-2.3.4 (c) 1995-2006 Sangoma Technologies Inc. wanec_create_dev: Registering Wanpipe ECDEV Device! wanpipe1: Starting WAN Setup Processing WAN device wanpipe1... wanpipe1: Locating: A101/2 card, CPU A, PciSlot=Auto, PciBus=Auto wanpipe1: Found: A101/2 card, CPU A, PciSlot=10, PciBus=0 wanpipe1: AFT PCI memory at 0xA0003000 wanpipe1: IRQ 11 allocated to the AFT PCI card wanpipe1: Starting AFT Hardware Init. wanpipe1: Enabling front end link monitor wanpipe1: Hardware Adapter Type 0x41 Scurity 0x00 wanpipe1: Security 1 Line UnCh wanpipe1: Configuring PMC COMET T1 Front End (Port 1)! wanpipe1: All channels enabled wanpipe1: Configuring Device :wanpipe1 FrmVr=22 wanpipe1: Global MTU = 1500 eth0: no IPv6 routers present wanpipe1: Global MRU = 1500 wanpipe1: RBS Signal = Off wanpipe1: T1 connected! wanpipe1: FE Ref Clock = Osc wanpipe1: TDMV Span = 1 : Enabled wanpipe1: Configuring Interface: w1g1 wanpipe1: UsedBy :TDM_VOICE_API wp_tdmapi_reg_globals: Registering Wanpipe TDM Device! wanpipe1: MRU :184 wanpipe1: MTU :184 wanpipe1: HDLC Eng :Off (Transparent) wanpipe1: Slot Sync :Enabled wanpipe1: Timeslot Map :0xFF7FFFFF wanpipe1: Idle Flag :0x00 wanpipe1: Idle Buf Len :184 wanpipe1: Data Mux :On wanpipe1: DMA MRU :512 wanpipe1: RX DMA Per Ch :10 wanpipe1: Net Gateway :No wanpipe1: Configuring Interface: w1g1 wanpipe1: UsedBy :TDM_VOICE_DCHAN_API wanpipe1: MRU :1500 wanpipe1: MTU :1500 wanpipe1: Enabling T1 Interrupts wanpipe1: HDLC Eng :On wanpipe1: Timeslot Map :0x00800000 wanpipe1: DMA MRU :2048 wanpipe1: RX DMA Per Ch :10 wanpipe1: Net Gateway :No w1g1: Interface resynching! ADDRCONF(NETDEV_CHANGE): w1g1: link becomes ready