dmesg
Linux version 2.6.8-3-686 (pbuilder@dl360-g3) (gcc version 3.3.5 (Debian 1:3.3.5-13)) #1 Thu Sep 7 03:38:22 UTC 2006
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 00000000000a0000 (usable)
 BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 0000000003ef0000 (usable)
 BIOS-e820: 0000000003ef0000 - 0000000003ef3000 (ACPI NVS)
 BIOS-e820: 0000000003ef3000 - 0000000003f00000 (ACPI data)
 BIOS-e820: 00000000ffb00000 - 0000000100000000 (reserved)
0MB HIGHMEM available.
62MB LOWMEM available.
On node 0 totalpages: 16112
  DMA zone: 4096 pages, LIFO batch:1
  Normal zone: 12016 pages, LIFO batch:2
  HighMem zone: 0 pages, LIFO batch:1
DMI 2.2 present.
Built 1 zonelists
Kernel command line: auto BOOT_IMAGE=Linux ro root=301 noapic nolapic acpi=off
Initializing CPU#0
PID hash table entries: 256 (order 8: 2048 bytes)
Detected 1002.309 MHz processor.
Using tsc for high-res timesource
Console: colour VGA+ 80x25
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 56272k/64448k available (1553k kernel code, 7720k reserved, 689k data, 148k init, 0k highmem)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Calibrating delay loop... 1982.46 BogoMIPS
Security Scaffold v1.0.0 initialized
Mount-cache hash table entries: 512 (order: 0, 4096 bytes)
CPU: After generic identify, caps: 0387f9ff 00000000 00000000 00000000
CPU: After vendor identify, caps:  0387f9ff 00000000 00000000 00000000
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 256K
CPU serial number disabled.
CPU: After all inits, caps:        0383f9ff 00000000 00000000 00000040
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU: Intel Pentium III (Coppermine) stepping 0a
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
checking if image is initramfs...it isn't (ungzip failed); looks like an initrd
Freeing initrd memory: 4528k freed
NET: Registered protocol family 16
PCI: PCI BIOS revision 2.10 entry at 0xfb100, last bus=1
PCI: Using configuration type 1
mtrr: v2.0 (20020519)
ACPI: Subsystem revision 20040326
ACPI: Interpreter disabled.
Linux Plug and Play Support v0.97 (c) Adam Belay
PnPBIOS: Scanning system for PnP BIOS support...
PnPBIOS: Found PnP BIOS installation structure at 0xc00fbab0
PnPBIOS: PnP BIOS version 1.0, entry 0xf0000:0xbae0, dseg 0xf0000
pnp: 00:0c: ioport range 0x800-0x805 has been reserved
PnPBIOS: 17 nodes reported by PnP BIOS; 17 recorded by driver
PCI: Probing PCI hardware
PCI: Probing PCI hardware (bus 00)
PCI: Transparent bridge - 0000:00:1e.0
PCI: Using IRQ router PIIX/ICH [8086/2440] at 0000:00:1f.0
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
devfs: 2004-01-31 Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x0
Initializing Cryptographic API
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Serial: 8250/16550 driver $Revision: 1.90 $ 48 ports, IRQ sharing enabled
ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A
RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize
serio: i8042 AUX port at 0x60,0x64 irq 12
serio: i8042 KBD port at 0x60,0x64 irq 1
input: AT Translated Set 2 keyboard on isa0060/serio0
NET: Registered protocol family 2
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 4096 bind 8192)
NET: Registered protocol family 8
NET: Registered protocol family 20
RAMDISK: cramfs filesystem found at block 0
RAMDISK: Loading 4528 blocks [1 disk] into ram disk... done.
VFS: Mounted root (cramfs filesystem) readonly.
Freeing unused kernel memory: 148k freed
vesafb: probe of vesafb0 failed with error -6
NET: Registered protocol family 1
SCSI subsystem initialized
libata version 1.02 loaded.
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ICH2: IDE controller at PCI slot 0000:00:1f.1
ICH2: chipset revision 2
ICH2: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:pio, hdd:pio
hda: OEM80-72A 80GB 7200RPM, ATA DISK drive
Using anticipatory io scheduler
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: max request size: 128KiB
hda: Host Protected Area detected.
        current capacity is 156299375 sectors (80025 MB)
        native  capacity is 156301488 sectors (80026 MB)
hda: 156299375 sectors (80025 MB) w/2048KiB Cache, CHS=65535/16/63, UDMA(100)
 /dev/ide/host0/bus0/target0/lun0: p1 p2 < p5 >
kjournald starting.  Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
Adding 514040k swap on /dev/hda5.  Priority:-1 extents:1
EXT3 FS on hda1, internal journal
Generic RTC Driver v1.07
Capability LSM initialized
device-mapper: 4.1.0-ioctl (2003-12-10) initialised: dm@uk.sistina.com
Linux agpgart interface v0.100 (c) Dave Jones
via-rhine.c:v1.10-LK1.1.20-2.6 May-23-2004 Written by Donald Becker
PCI: Found IRQ 11 for device 0000:01:01.0
PCI: Sharing IRQ 11 with 0000:00:1f.5
eth0: VIA Rhine III at 0xc000, 00:40:f4:89:b5:1e, IRQ 11.
eth0: MII PHY found at address 1, status 0x7849 advertising 05e1 Link 0000.
8139too Fast Ethernet driver 0.9.27
PCI: Found IRQ 5 for device 0000:01:02.0
eth1: RealTek RTL8139 at 0xc400, 00:e0:4c:10:3b:6d, IRQ 5
eth1:  Identified 8139 chip type 'RTL-8100B/8139D'
e100: Intel(R) PRO/100 Network Driver, 3.0.18
e100: Copyright(c) 1999-2004 Intel Corporation
PCI: Found IRQ 12 for device 0000:01:03.0
PCI: Sharing IRQ 12 with 0000:00:1f.2
e100: eth2: e100_probe: addr 0xd6000000, irq 12, MAC addr 00:A0:C9:AA:F3:60
Intel 810 + AC97 Audio, version 1.01, 03:56:22 Sep  7 2006
PCI: Found IRQ 11 for device 0000:00:1f.5
PCI: Sharing IRQ 11 with 0000:01:01.0
PCI: Setting latency timer of device 0000:00:1f.5 to 64
i810: Intel ICH2 found at IO 0xdc00 and 0xd800, MEM 0x0000 and 0x0000, IRQ 11
i810_audio: Audio Controller supports 6 channels.
i810_audio: Defaulting to base 2 channel mode.
i810_audio: Resetting connection 0
ac97_codec: AC97 Audio codec, id: ALG16 (ALC200/200P)
i810_audio: AC'97 codec 0 supports AMAP, total channels = 2
i810_audio: setting clocking to 48525
usbcore: registered new driver usbfs
usbcore: registered new driver hub
USB Universal Host Controller Interface driver v2.2
PCI: Found IRQ 12 for device 0000:00:1f.2
PCI: Sharing IRQ 12 with 0000:01:03.0
uhci_hcd 0000:00:1f.2: Intel Corp. 82801BA/BAM USB (Hub #1)
PCI: Setting latency timer of device 0000:00:1f.2 to 64
uhci_hcd 0000:00:1f.2: irq 12, io base 0000d000
uhci_hcd 0000:00:1f.2: new USB bus registered, assigned bus number 1
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
PCI: Found IRQ 5 for device 0000:00:1f.4
PCI: Sharing IRQ 5 with 0000:01:02.0
uhci_hcd 0000:00:1f.4: Intel Corp. 82801BA/BAM USB (Hub #2)
PCI: Setting latency timer of device 0000:00:1f.4 to 64
uhci_hcd 0000:00:1f.4: irq 9, io base 0000d400
uhci_hcd 0000:00:1f.4: new USB bus registered, assigned bus number 2
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 2 ports detected
agpgart: Detected an Intel i815 Chipset.
agpgart: Maximum main memory to use for agp memory: 26M
agpgart: AGP aperture is 64M @ 0xd0000000
hw_random: RNG not detected
cpci_hotplug: CompactPCI Hot Plug Core version: 0.2
pci_hotplug: PCI Hot Plug PCI Core version: 0.5
pciehp: acpi_pciehprm:get_device PCI ROOT HID fail=0x1001
shpchp: acpi_shpchprm:get_device PCI ROOT HID fail=0x1001
8139cp: 10/100 PCI Ethernet driver v1.2 (Mar 22, 2004)
input: PC Speaker
inserting floppy driver for 2.6.8-3-686
FDC 0 is a post-1991 82077
parport: PnPBIOS parport detected.
parport0: PC-style at 0x378 (0x778), irq 7, dma 3 [PCSPP,TRISTATE,COMPAT,ECP,DMA]
eth1: link up, 100Mbps, full-duplex, lpa 0x45E1
NET: Registered protocol family 10
Disabled Privacy Extensions on device c0300140(lo)
IPv6 over IPv4 tunneling driver
eth1: no IPv6 routers present
eth0: no IPv6 routers present