Booting 'OpenWrt' root (hd0,0) Filesystem type is ext2fs, partition type 0x83 kernel /boot/openwrt-x86-2.6-vmlinuz blkmtd_device=/dev/hda2 blkmtd_sync=1 roo t=/dev/mtdblock0 init=/etc/preinit noinitrd console=ttyS0,115200n8 [Linux-bzImage, setup=0x1200, size=0xd63a4] boot Linux version 2.6.12.5 (nthill@debian) (gcc version 3.3.5 (Debian 1:3.3.5-13)) #2 Mon Oct 31 22:05 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009fc00 (usable) BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved) BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 0000000008000000 (usable) BIOS-e820: 00000000fff00000 - 0000000100000000 (reserved) 128MB LOWMEM available. DMI not present. Allocating PCI resources starting at 08000000 (gap: 08000000:f7f00000) Built 1 zonelists Kernel command line: blkmtd_device=/dev/hda2 blkmtd_sync=1 root=/dev/mtdblock0 init=/etc/preinit 8 Initializing CPU#0 PID hash table entries: 1024 (order: 10, 16384 bytes) scx200hr: timer not yet accessible; will probe later. Detected 266.655 MHz processor. Using tsc for high-res timesource Dentry cache hash table entries: 32768 (order: 5, 131072 bytes) Inode-cache hash table entries: 16384 (order: 4, 65536 bytes) Memory: 127288k/131072k available (1113k kernel code, 3328k reserved, 526k data, 104k init, 0k hi) Checking if this processor honours the WP bit even in supervisor mode... Ok. Mount-cache hash table entries: 512 CPU: NSC Unknown stepping 01 Checking 'hlt' instruction... OK. NET: Registered protocol family 16 PCI: PCI BIOS revision 2.01 entry at 0xf7861, last bus=0 PCI: Using configuration type 1 Linux Plug and Play Support v0.97 (c) Adam Belay PCI: Probing PCI hardware PCI: Probing PCI hardware (bus 00) scx200: NatSemi SCx200 Driver scx200: GPIO base 0x6100 scx200: Configuration Block base 0x6000 switching to scx200 high-resolution timer (255961 cpt) Squashfs 2.2 (released 2005/07/03) (C) 2002-2005 Phillip Lougher devfs: 2004-01-31 Richard Gooch (rgooch@atnf.csiro.au) devfs: boot_options: 0x1 JFFS2 version 2.2. (C) 2001-2003 Red Hat, Inc. Initializing Cryptographic API isapnp: Scanning for PnP cards... isapnp: No Plug & Play device found Real Time Clock Driver v1.12 Non-volatile memory driver v1.2 Serial: 8250/16550 driver $Revision: 1.90 $ 6 ports, IRQ sharing disabled ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A Booting 'OpenWrt' root (hd0,0) Filesystem type is ext2fs, partition type 0x83 kernel /boot/openwrt-x86-2.6-vmlinuz blkmtd_device=/dev/hda2 blkmtd_sync=1 roo t=/dev/mtdblock0 init=/etc/preinit noinitrd console=ttyS0,115200n8 [Linux-bzImage, setup=0x1200, size=0xd63a4] boot Linux version 2.6.12.5 (nthill@debian) (gcc version 3.3.5 (Debian 1:3.3.5-13)) #2 Mon Oct 31 22:00 :23 CET 2005 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009fc00 (usable) BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved) BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 0000000008000000 (usable) BIOS-e820: 00000000fff00000 - 0000000100000000 (reserved) 128MB LOWMEM available. DMI not present. Allocating PCI resources starting at 08000000 (gap: 08000000:f7f00000) Built 1 zonelists Kernel command line: blkmtd_device=/dev/hda2 blkmtd_sync=1 root=/dev/mtdblock0 init=/etc/preinit n oinitrd console=ttyS0,115200n8 Initializing CPU#0 PID hash table entries: 1024 (order: 10, 16384 bytes) scx200hr: timer not yet accessible; will probe later. Detected 266.663 MHz processor. Using tsc for high-res timesource Dentry cache hash table entries: 32768 (order: 5, 131072 bytes) Inode-cache hash table entries: 16384 (order: 4, 65536 bytes) Memory: 127288k/131072k available (1113k kernel code, 3328k reserved, 526k data, 104k init, 0k hig hmem) Checking if this processor honours the WP bit even in supervisor mode... Ok. Mount-cache hash table entries: 512 CPU: NSC Unknown stepping 01 Checking 'hlt' instruction... OK. NET: Registered protocol family 16 PCI: PCI BIOS revision 2.01 entry at 0xf7861, last bus=0 PCI: Using configuration type 1 Linux Plug and Play Support v0.97 (c) Adam Belay PCI: Probing PCI hardware PCI: Probing PCI hardware (bus 00) scx200: NatSemi SCx200 Driver scx200: GPIO base 0x6100 scx200: Configuration Block base 0x6000 switching to scx200 high-resolution timer (255961 cpt) Squashfs 2.2 (released 2005/07/03) (C) 2002-2005 Phillip Lougher devfs: 2004-01-31 Richard Gooch (rgooch@atnf.csiro.au) devfs: boot_options: 0x1 JFFS2 version 2.2. (C) 2001-2003 Red Hat, Inc. Initializing Cryptographic API isapnp: Scanning for PnP cards... isapnp: No Plug & Play device found Real Time Clock Driver v1.12 Non-volatile memory driver v1.2 Serial: 8250/16550 driver $Revision: 1.90 $ 6 ports, IRQ sharing disabled ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A io scheduler noop registered io scheduler anticipatory registered Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx SC1200: IDE controller at PCI slot 0000:00:12.2 SC1200: chipset revision 1 SC1200: not 100% native mode: will probe irqs later ide0: BM-DMA at 0xe000-0xe007, BIOS settings: hda:pio, hdb:pio ide1: BM-DMA at 0xe008-0xe00f, BIOS settings: hdc:pio, hdd:pio hda: PQI ATA Rev6.0, CFA DISK drive SC1200: set xfer mode failure ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 hda: max request size: 128KiB hda: 256000 sectors (131 MB) w/0KiB Cache, CHS=1000/16/16 hda: cache flushes not supported /dev/ide/host0/bus0/target0/lun0: p1 p2 p3 blkmtd: version $Revision: 1.24 $ /dev/ide/host0/bus0/target0/lun0: p1 p2 p3 blkmtd: mtd0: [/dev/hda2] erase_size = 128KiB NET: Registered protocol family 2 IP: routing cache hash table of 1024 buckets, 8Kbytes TCP established hash table entries: 8192 (order: 4, 65536 bytes) TCP bind hash table entries: 8192 (order: 3, 32768 bytes) TCP: Hash tables configured (established 8192 bind 8192) ip_conntrack version 2.1 (1024 buckets, 8192 max) - 256 bytes per conntrack ip_tables: (C) 2000-2002 Netfilter core team NET: Registered protocol family 1 NET: Registered protocol family 17 802.1Q VLAN Support v1.8 Ben Greear All bugs added by David S. Miller Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(31,0)