Freeing unused kernel memory: 104k freed ^[[10;1Rinsmod: diag.ko: no module by that name found Could not open mtd device: rootfs init started: BusyBox v1.01 (2005.11.01-16:50+0000) multi-call binary Please press Enter to activate this console. natsemi dp8381x driver, version 1.07+LK1.0.17, Sep 22 originally by Donald Becker http://www.scyld.com/network/natsemi.html 2.4.x kernel port by Jeff Garzik, Tjeerd Mulder natsemi eth0: NatSemi DP8381[56] at 0xa0000000 (0000:00:06.0), 00:00:24:c4:f2:28, IRQ 10, port TP. natsemi eth1: NatSemi DP8381[56] at 0xa0001000 (0000:00:07.0), 00:00:24:c4:f2:29, IRQ 10, port TP. natsemi eth2: NatSemi DP8381[56] at 0xa0002000 (0000:00:08.0), 00:00:24:c4:f2:2a, IRQ 10, port TP. wlan: version magic '2.6.12.5 GEODEGX1 gcc-3.3' should be '2.6.12.5 GEODEGX1 gcc-3.4' ath_hal: version magic '2.6.12.5 GEODEGX1 gcc-3.3' should be '2.6.12.5 GEODEGX1 gcc-3.4' ath_rate_onoe: version magic '2.6.12.5 GEODEGX1 gcc-3.3' should be '2.6.12.5 GEODEGX1 gcc-3.4' ath_pci: version magic '2.6.12.5 GEODEGX1 gcc-3.3' should be '2.6.12.5 GEODEGX1 gcc-3.4' wlan_acl: version magic '2.6.12.5 GEODEGX1 gcc-3.3' should be '2.6.12.5 GEODEGX1 gcc-3.4' wlan_ccmp: version magic '2.6.12.5 GEODEGX1 gcc-3.3' should be '2.6.12.5 GEODEGX1 gcc-3.4' wlan_tkip: version magic '2.6.12.5 GEODEGX1 gcc-3.3' should be '2.6.12.5 GEODEGX1 gcc-3.4' wlan_wep: version magic '2.6.12.5 GEODEGX1 gcc-3.3' should be '2.6.12.5 GEODEGX1 gcc-3.4' wlan_xauth: version magic '2.6.12.5 GEODEGX1 gcc-3.3' should be '2.6.12.5 GEODEGX1 gcc-3.4' device eth0 entered promiscuous mode eth1: DSPCFG accepted after 0 usec. eth1: link up. eth1: Setting full-duplex based on negotiated link capability. eth1: Promiscuous mode enabled. device eth1 entered promiscuous mode eth2: DSPCFG accepted after 0 usec. eth2: Promiscuous mode enabled. device eth2 entered promiscuous mode br0: port 1(eth1) entering learning state br0: topology change detected, propagating