<4>htcblueangel_wlan_init: acx-mem platform_device_register <4>acx: this driver is still EXPERIMENTAL <4>acx: reading README file and/or Craig's HOWTO is recommended, visit http://acx100.sf.net in case of further questions/discussion <4>acx: compiled to use 32bit I/O access. I/O timing issues might occur, such as non-working firmware upload. Report them <4>running on a little-endian CPU <4>PCI module v0.3.35 initialized, waiting for cards to probe... <4>htcblueangel_wlan_start <4>acx: found ACX100-based wireless network card <4>initial debug setting is 0x000A <4>using IRQ 40 <4>ACX radio type 0x0d <4>requesting firmware image 'WLANGEN.BIN' <5>pccard: PCMCIA card inserted into slot 0 <4>acx_write_fw (main):0 <4>acx_validate_fw (main):0 <4>requesting firmware image 'RADIO0d.BIN' <4>acx_write_fw (radio): 0 <4>acx_validate_fw (radio): 0 <4>acx100_s_init_wep: writing WEP options <4>initializing max packet templates <4>NVS_vendor_offs:0000 probe_delay:500 eof_memory:65536 <4>CCAModes:04 Diversity:01 ShortPreOpt:01 PBCC:01 ChanAgil:00 PHY:05 Temp:01 <4>AntennaID:01 Len:02 Data:1E 00 <4>PowerLevelID:0A Len:00 Data: <4>DataRatesID:02 Len:05 Data:02 04 11 22 44 <4>DomainID:03 Len:07 Data:30 20 30 31 32 40 41 <4>ProductID:04 Len:09 Data:TI ACX100 <4>ManufacturerID:05 Len:07 Data:TI Tes~ <4>get_mask 0x00004D82, set_mask 0x00000000 <4>acx copy_from_slavemem: warning! destination not word-aligned! <4>got sensitivity value 176 <4>acx copy_from_slavemem: warning! destination not word-aligned! <4>got antenna value 0x8D <4>acx copy_from_slavemem: warning! destination not word-aligned! <4>got Energy Detect (ED) threshold 112 <4>acx copy_from_slavemem: warning! destination not word-aligned! <4>got Channel Clear Assessment (CCA) value 13 <4>got regulatory domain 0x30 <4>get_mask 0x00000000, set_mask 0x00000000 - after update <4>new ratevector: 82 84 0B 16 2C <4>setting RXconfig to 2010:0FDD <4>acx: form factor 0x03 (Compact Flash), radio type 0x0D (Maxim), EEPROM version 0x05, uploaded firmware 'Rev 1.10.7.K' (0x01030505) <4>creating /proc entry driver/acx_wlan0 <4>creating /proc entry driver/acx_wlan0_diag <4>creating /proc entry driver/acx_wlan0_eeprom <4>creating /proc entry driver/acx_wlan0_phy <4>acx v0.3.35: net device wlan0, driver compiled against wireless extensions 21 and Linux 2.6.19-hh4 and iWconfig root@htcblueangel:~$ iwconfig lo no wireless extensions. usb0 no wireless extensions. wlan0 IEEE 802.11b+ ESSID:"STA1059C7" Nickname:"acx v0.3.35" Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated Bit Rate:22 Mb/s Tx-Power=18 dBm Sensitivity=176/255 Retry min limit:7 RTS thr:off Encryption key:off Power Management:off Link Quality:0 Signal level:0 Noise level:0 Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0 irda0 no wireless extensions.