PC Engines WRAP.2B/2C v1.10 640 KB Base Memory 15360 31744 48128 64512 80896 97280 113664 130048 KB Extended Memory 01F0 Master 848A SanDisk SDCFB-2048 Phys C/H/S 3970/16/63 Log C/H/S 992/64/63 GRUB Loading stage1.5. GRUB loading, please wait...  GNU GRUB version 0.95 (640K lower / 130048K upper memory) +-------------------------------------------------------------------------+||||||||||||||||||||||||+-------------------------------------------------------------------------+ Use the ^ and v keys to select which entry is highlighted. Press enter to boot the selected OS, 'e' to edit the commands before booting, 'a' to modify the kernel arguments before booting, or 'c' for a command-line.  OpenWrt             The highlighted entry will be booted automatically in 5 seconds. The highlighted entry will be booted automatically in 4 seconds. The highlighted entry will be booted automatically in 3 seconds. The highlighted entry will be booted automatically in 2 seconds. The highlighted entry will be booted automatically in 1 seconds.  Booting 'OpenWrt' root (hd0,0) Filesystem type is ext2fs, partition type 0x83 kernel /boot/openwrt-x86-2.4-vmlinuz blkmtd_device=/dev/hda2 blkmtd_sync=1 roo t=/dev/mtdblock0 rootfstype=jffs2 init=/etc/preinit noinitrd console=ttyS0,3840 0n8 reboot=bios [Linux-bzImage, setup=0xa00, size=0xaa810] boot Linux version 2.4.30 (nthill@debian) (gcc version 3.4.4) #2 Tue Nov 1 23:46:36 CET 2005 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 00000000000a0000 (usable) BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 0000000008000000 (usable) BIOS-e820: 00000000fff00000 - 0000000100000000 (reserved) 128MB LOWMEM available. On node 0 totalpages: 32768 zone(0): 4096 pages. zone(1): 28672 pages. zone(2): 0 pages. DMI not present. Kernel command line: blkmtd_device=/dev/hda2 blkmtd_sync=1 root=/dev/mtdblock0 rootfstype=jffs2 init=/etc/preinit noinitrd console=ttyS0,38400n8 reboot=bios Initializing CPU#0 Detected 266.637 MHz processor. Calibrating delay loop... 532.48 BogoMIPS Memory: 127520k/131072k available (1070k kernel code, 3168k reserved, 208k data, 64k init, 0k highmem) Checking if this processor honours the WP bit even in supervisor mode... Ok. Dentry cache hash table entries: 16384 (order: 5, 131072 bytes) Inode cache hash table entries: 8192 (order: 4, 65536 bytes) Mount cache hash table entries: 512 (order: 0, 4096 bytes) Buffer cache hash table entries: 8192 (order: 3, 32768 bytes) Page-cache hash table entries: 32768 (order: 5, 131072 bytes) CPU: NSC Unknown stepping 01 Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX PCI: PCI BIOS revision 2.10 entry at 0xfc46b, last bus=0 PCI: Using configuration type 1 PCI: Probing PCI hardware PCI: Probing PCI hardware (bus 00) PCI: Device 00:95 not found by BIOS Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket Starting kswapd devfs: v1.12c (20020818) Richard Gooch (rgooch@atnf.csiro.au) devfs: boot_options: 0x1 JFFS2 version 2.1. (C) 2001 Red Hat, Inc., designed by Axis Communications AB. Squashfs 2.2 (released 2005/07/03) (C) 2002-2004, 2005 Phillip Lougher pty: 256 Unix98 ptys configured Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A Software Watchdog Timer: 0.05, timer margin: 60 sec Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx SC1200: IDE controller at PCI slot 00:12.2 SC1200: chipset revision 1 SC1200: not 100% native mode: will probe irqs later ide0: BM-DMA at 0xfc00-0xfc07, BIOS settings: hda:pio, hdb:pio ide1: BM-DMA at 0xfc08-0xfc0f, BIOS settings: hdc:pio, hdd:pio hdb: C/H/S=0/0/0 from BIOS ignored hda: SanDisk SDCFB-2048, CFA DISK drive hda: sc1200_set_xfer_mode(MW DMA 2) blk: queue c028b400, I/O limit 4095Mb (mask 0xffffffff) ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 hda: attached ide-disk driver. hda: 4001760 sectors (2049 MB) w/1KiB Cache, CHS=992/64/63, DMA Partition check: /dev/ide/host0/bus0/target0/lun0:<4>hda: dma_timer_expiry: dma status == 0x21 ide_dma_end dma_stat=21 err=1 newerr=0 hda: error waiting for DMA ide_dma_end dma_stat=0 err=1 newerr=0 hda: dma timeout retry: status=0x58 { DriveReady SeekComplete DataRequest } p1 p2 /dev/ide/host0/bus0/target0/lun0:<4>hda: dma_timer_expiry: dma status == 0x21 ide_dma_end dma_stat=21 err=1 newerr=0 hda: error waiting for DMA ide_dma_end dma_stat=0 err=1 newerr=0 hda: dma timeout retry: status=0x58 { DriveReady SeekComplete DataRequest } p1 p2 blkmtd: mtd0: [/dev/hda2] erase_size = 128KiB blkmtd: version 1.10 Initializing Cryptographic API NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 1024 buckets, 8Kbytes TCP: Hash tables configured (established 8192 bind 16384) ip_conntrack version 2.1 (5953 buckets, 5953 max) - 320 bytes per conntrack ip_tables: (C) 2000-2002 Netfilter core team NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. NET4: Ethernet Bridge 008 for NET4.0 802.1Q VLAN Support v1.8 Ben Greear All bugs added by David S. Miller hda: dma_timer_expiry: dma status == 0x21 ide_dma_end dma_stat=21 err=1 newerr=0 hda: error waiting for DMA ide_dma_end dma_stat=0 err=1 newerr=0 hda: dma timeout retry: status=0x58 { DriveReady SeekComplete DataRequest } hda: dma_timer_expiry: dma status == 0x21 ide_dma_end dma_stat=21 err=1 newerr=0 hda: error waiting for DMA ide_dma_end dma_stat=0 err=1 newerr=0 hda: dma timeout retry: status=0x58 { DriveReady SeekComplete DataRequest } VFS: Mounted root (jffs2 filesystem) readonly. Mounted devfs on /dev Freeing unused kernel memory: 64k freed insmod: diag.o: no module by that name found Could not open mtd device: rootfs init started: BusyBox v1.01 (2005.10.24-06:58+0000) multi-call binary Please press Enter to activate this console. jffs2.bbc: SIZE compression mode activated. natsemi dp8381x driver, version 1.07+LK1.0.17, Sep 27, 2002 originally by Donald Becker http://www.scyld.com/network/natsemi.html 2.4.x kernel port by Jeff Garzik, Tjeerd Mulder eth0: NatSemi DP8381[56] at 0xc88ab000, 00:0d:b9:01:cb:e8, IRQ 10. device eth0 entered promiscuous mode BusyBox v1.01 (2005.10.24-06:58+0000) Built-in shell (ash) Enter 'help' for a list of built-in commands. _______ ________ __ | |.-----.-----.-----.| | | |.----.| |_ | - || _ | -__| || | | || _|| _| |_______|| __|_____|__|__||________||__| |____| |__| W I R E L E S S F R E E D O M bleeding edge, r2313 ;) root@OpenWrt:/#