Total memory = 512MB; using 1024kB for hash table (at c0400000)
Linux version 2.6.14-gentoo (root@livecd) (gcc version 3.4.4 (Gentoo 3.4.4-r1, ssp-3.4.4-1.0, pie-8.7.8)) #1 PREEMPT Wed Nov 2 06:36:39 EST 2005
Found UniNorth memory controller & host bridge, revision: 17
Mapped at 0xfdeb5000
Found a Keylargo mac-io controller, rev: 3, mapped at 0xfde35000
Processor NAP mode on idle enabled.
PowerMac motherboard: PowerBook Titanium III
Found UniNorth PCI host bridge at 0xf0000000. Firmware bus number: 0->1
Found UniNorth PCI host bridge at 0xf2000000. Firmware bus number: 0->1
Found UniNorth PCI host bridge at 0xf4000000. Firmware bus number: 0->1
via-pmu: Server Mode is disabled
PMU driver 2 initialized for Core99, firmware: 0c
nvram: Checking bank 0...
nvram: gen0=1497, gen1=1498
nvram: Active bank is: 1
nvram: OF partition at 0x410
nvram: XP partition at 0x1020
nvram: NR partition at 0x1120
On node 0 totalpages: 131072
  DMA zone: 131072 pages, LIFO batch:31
  Normal zone: 0 pages, LIFO batch:1
  HighMem zone: 0 pages, LIFO batch:1
Built 1 zonelists
Kernel command line: root=/dev/hda4 ro
PowerMac using OpenPIC irq controller at 0x80040000
OpenPIC Version 1.2 (4 CPUs and 64 IRQ sources) at fc5e4000
OpenPIC timer frequency is 4.166666 MHz
PID hash table entries: 4096 (order: 12, 65536 bytes)
GMT Delta read from XPRAM: 0 minutes, DST: off
time_init: decrementer frequency = 33.330978 MHz
Console: colour dummy device 80x25
Dentry cache hash table entries: 131072 (order: 7, 524288 bytes)
Inode-cache hash table entries: 65536 (order: 6, 262144 bytes)
Memory: 514560k available (2364k kernel code, 900k data, 164k init, 0k highmem)
AGP special page: 0xdffff000
Calibrating delay loop... 665.60 BogoMIPS (lpj=1331200)
Mount-cache hash table entries: 512
device-tree: property "l2-cache" name conflicts with node in /cpus/PowerPC,G4@0/l2-cache
device-tree: property "l2-cache" name conflicts with node in /cpus/PowerPC,G4@0
softlockup thread 0 started up.
NET: Registered protocol family 16
PCI: Probing PCI hardware
Can't get bus-range for /pci@f2000000/cardbus@1a, assuming it starts at 0
Registering openpic with sysfs...
usbcore: registered new driver usbfs
usbcore: registered new driver hub
Thermal assist unit not available
Registering PowerMac CPU frequency driver
Low: 667 Mhz, High: 800 Mhz, Boot: 667 Mhz
Initializing Cryptographic API
Generic RTC Driver v1.07
Macintosh non-volatile memory driver v1.1
PCI: Enabling device 0000:00:10.0 (0086 -> 0087)
radeonfb (0000:00:10.0): Invalid ROM signature 0 should be 0xaa55
radeonfb: Retreived PLL infos from Open Firmware
radeonfb: Reference=27.00 MHz (RefDiv=12) Memory=183.00 Mhz, System=230.00 MHz
radeonfb: PLL min 12000 max 35000
radeonfb: Monitor 1 type LCD found
radeonfb: EDID probed
radeonfb: Monitor 2 type no found
radeonfb: Using Firmware dividers 0x0002008e from PPLL 0
radeonfb: Dynamic Clock Power Management enabled
Console: switching to colour frame buffer device 160x53
Registered "ati" backlight controller,level: 15/15
radeonfb (0000:00:10.0): ATI Radeon LW
mice: PS/2 mouse device common for all mice
io scheduler noop registered
io scheduler anticipatory registered
RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize
loop: loaded (max 8 devices)
MacIO PCI driver attached to Keylargo chipset
input: Macintosh mouse button emulation
apm_emu: APM Emulation 0.5 initialized.
adb: starting probe task...
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
adb devices: [2]: 2 c3 [3]: 3 1 [7]: 7 1f
ADB keyboard at 2, handler 1
Detected ADB keyboard, type ANSI.
input: ADB keyboard on adb2:2.c3/input
input: ADB Powerbook buttons on adb7:7.1f/input
ADB mouse at 3, handler set to 4 (trackpad)
input: ADB mouse on adb3:3.01/input
adb: finished probe task...
ide0: Found Apple KeyLargo ATA-4 controller, bus ID 2, irq 19
Probing IDE interface ide0...
hda: IBM-IC25N040ATCS04-0, ATA DISK drive
hda: Enabling Ultra DMA 4
ide0 at 0xe1006000-0xe1006007,0xe1006160 on irq 19
ide1: Found Apple KeyLargo ATA-3 controller, bus ID 0, irq 20
Probing IDE interface ide1...
hdc: MATSHITACD-RW CW-8121, ATAPI CD/DVD-ROM drive
hdc: Enabling MultiWord DMA 2
ide1 at 0xe100c000-0xe100c007,0xe100c160 on irq 20
ide2: Found Apple KeyLargo ATA-3 controller, bus ID 1, irq 21
Probing IDE interface ide2...
ide2: Bus empty, interface released.
hda: max request size: 128KiB
hda: 78140160 sectors (40007 MB) w/1768KiB Cache, CHS=65535/16/63, UDMA(66)
hda: cache flushes not supported
 hda: [mac] hda1 hda2 hda3 hda4 hda5 hda6
hdc: ATAPI 24X DVD-ROM CD-R/RW drive, 2048kB Cache, DMA
Uniform CD-ROM driver Revision: 3.20
ohci_hcd: 2005 April 22 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI)
PCI: Enabling device 0001:10:18.0 (0000 -> 0002)
ohci_hcd 0001:10:18.0: OHCI Host Controller
ohci_hcd 0001:10:18.0: new USB bus registered, assigned bus number 1
ohci_hcd 0001:10:18.0: irq 27, io mem 0xa0002000
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
PCI: Enabling device 0001:10:19.0 (0000 -> 0002)
ohci_hcd 0001:10:19.0: OHCI Host Controller
ohci_hcd 0001:10:19.0: new USB bus registered, assigned bus number 2
ohci_hcd 0001:10:19.0: irq 28, io mem 0xa0001000
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 2 ports detected
usb 1-1: new low speed USB device using ohci_hcd and address 2
USB Universal Host Controller Interface driver v2.3
usbcore: registered new driver hiddev
input: USB HID v1.10 Mouse [USB OpticalWheel Mouse] on usb-0001:10:18.0-1
usbcore: registered new driver usbhid
drivers/usb/input/hid-core.c: v2.6:USB HID core driver
i2c /dev entries driver
NET: Registered protocol family 2
IP route cache hash table entries: 32768 (order: 5, 131072 bytes)
TCP established hash table entries: 131072 (order: 7, 524288 bytes)
TCP bind hash table entries: 65536 (order: 6, 262144 bytes)
TCP: Hash tables configured (established 131072 bind 65536)
TCP reno registered
TCP bic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
ReiserFS: hda4: found reiserfs format "3.6" with standard journal
ReiserFS: hda4: using ordered data mode
ReiserFS: hda4: journal params: device hda4, size 8192, journal first block 18, max trans len 1024, max batch 900, max commit age 30, max trans age 30
ReiserFS: hda4: checking transaction log (hda4)
ReiserFS: hda4: Using r5 hash to sort names
VFS: Mounted root (reiserfs filesystem) readonly.
Freeing unused kernel memory: 164k init 4k chrp 32k prep
Adding 1047768k swap on /dev/hda3.  Priority:-1 extents:1 across:1047768k
sungem.c:v0.98 8/24/03 David S. Miller (davem@redhat.com)
PHY ID: 2060e1, addr: 0
eth0: Sun GEM (PCI) 10/100/1000BaseT Ethernet 00:03:93:80:30:50
eth0: Found BCM5421 PHY
Linux agpgart interface v0.101 (c) Dave Jones
eth0: Link is up at 100 Mbps, full-duplex.
ReiserFS: hda4: warning: vs-2180: finish_unfinished: iget failed for [3101 3121 0x0 SD]
ReiserFS: hda4: warning: vs-5355: reiserfs_delete_solid_item: [-1 3121 0x1001 DIRECT] not found
ReiserFS: hda4: warning: vs-15011: reiserfs_release_objectid: tried to free free object id (3121)
eth0: Link is up at 100 Mbps, full-duplex.
eth0: Pause is enabled (rxfifo: 10240 off: 7168 on: 5632)
[drm] Initialized drm 1.0.0 20040925
[drm] Initialized radeon 1.17.0 20050311 on minor 0:
[drm:radeon_cp_init] *ERROR* radeon_cp_init called without lock held
[drm:drm_unlock] *ERROR* Process 5457 using kernel context 0