The sWDT device closed unexpectedly. WDT will not stop!ulti-call binary memory: 0 Sending SIGKILL to all processes.lgorithmics/MIPS FPU Emulator v1. Please stand by while rebooting the system. press Enter to activate this console. jffs Restarting system.: End of fil +PHY ID is xxxx:xxxx Ker Ethernet eth0: MAC address xx:xx:xx:xx:xx:ecker found at 0x02 IP: 192.168.1.254/255.255.255.0, Gateway: 0.0.0.0... done.h precision timer. Default server: 0.0.0.02_build_filesystem(): e RedBoot(tm) bootstrap and debug environment [ROMRAM]emory: 14188k/16384k available (1327k kernel code, 2 Non-certified release, version v1.3.0 - built 16:57:58, Aug 7 2006 k init, 0k highmem) Copyright (C) 2000, 2001, 2002, 2003, 2004 Red Hat, Inc.2, 16384 bytes) Board: ap51 Ino RAM: 0x80000000-0x81000000, [0x800 Now booting linux kernel:nce testing by UNIFIX Base address 0x80030000 Entry 0x80041000.0 for Linux 2.4 Cmdline :n Swansea CPU revision is: 00019064y NET3.039 Primary instruction cache 16kB, physically tagged, 4-way, linesize 16 bytes. Starting kswapd devfs: v1.12c (20020 Primary data cache 16kB, 4-way, linesize 16 bytes. Linux version 2.4.32 (iurgi@ropero) (gcc version 3.4.6 (OpenWrt On node 0 totalpages: 4096ougher zone(0): 4096 pages. pty: 256 U zone(1): 0 pages.red zone(2): 0 pages.Serial driver ver Kernel command line: console=ttyS0,9600 rootfstype=squashfs,jffs2 ttyS0 Using 92.000 MHz high precision timer. Calibrating delay loop... 183.50 BogoMIPSecksum feature. Memory: 14188k/16384k available (1327k kernel code, 2196k reserved, 92k data, 68 MTD driver for SPI flash. k init, 0k highmem)Probing for Serial Dentry cache hash table entries: 2048 (order: 2, 16384 bytes)d SPI serial Flash. 8388608: Inode cache hash table entries: 1024titions o 0x00730000-0x007e Checking for 'wait' instruction... available. 0x007e0000-0x007ef000 : "FIS POSIX conformance testing by UNIFIX mtd: partition "FIS d Linux NET4.0 for Linux 2.4 erase block -- force read Based upon Swansea University Computer Society NET3.039 0x007ef000-0x007f0000 : "R Initializing RT netlink socket mtd: p Starting kswapdt config" doesn devfs: v1.12c (20020818) Richard Gooch (rgooch@atnf.csiro.au) devfs: boot_options: 0x1x007f0000-0x00800000 : " ttyS00 at 0xb1100003 (irq = 37) is a 16550A eth0: Dropping NETIF_F_SG since no checksum feature.re team eth0: Atheros AR2313: xx:xx:xx:xx:xx:xx, irq 44.0. MTD driver for SPI flash.ridge 008 for NET4.0 spiflash: Probing for Serial flash ...VLAN Support v1.8 Ben Greear hw queue 2 for WME_AC_VI traffic All bugs added by David S. Miller < for WM Please press Enter to activate this console. jffs2_scan_eraseblock(): End of fil Enter 'help' for a list of bu esystem marker found at 0x0 jffs2_build_filesystem(): unlocking the mtd device... done. mini_fo: using base directory: / mini_fo: using storage directory: /jffs jffs2.bbc: SIZE compression mode activated. wlan: 0.8.4.2 (0.9.0) ath_hal: 0.9.17.1 (AR5212, AR5312, RF5112, RF2316, RF2317, TX_DESC_SWAP) wlan: mac acl policy registered ath_rate_sample: 1.2 (0.9.0) ath_ahb: 0.9.4.5 (0.9.0) ath_pci: switching rfkill capability off wifi0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps wifi0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36 Mbps 48Mbps 54Mbps wifi0: H/W encryption support: WEP AES AES_CCM TKIP wifi0: mac 11.0 phy 4.8 radio 7.0 wifi0: Use hw queue 1 for WME_AC_BE traffic wifi0: Use hw queue 0 for WME_AC_BK traffic wifi0: Use hw queue 2 for WME_AC_VI traffic wifi0: Use hw queue 3 for WME_AC_VO traffic wifi0: Use hw queue 8 for CAB traffic wifi0: Use hw queue 9 for beacons wifi0: Atheros 2315 WiSoC: mem=0xb0000000, irq=3 Universal TUN/TAP device driver 1.5 (C)1999-2002 Maxim Krasnyansky device eth0 entered promiscuous mode