smartctl 6.2 2013-11-07 r3856 [x86_64-linux-4.1.15-8-default] (SUSE RPM) Copyright (C) 2002-13, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Seagate Constellation ES (SATA 6Gb/s) Device Model: ST1000NM0011 Serial Number: LU WWN Device Id: 5 000c50 035106cc9 Firmware Version: SN03 User Capacity: 1,000,204,886,016 bytes [1.00 TB] Sector Size: 512 bytes logical/physical Rotation Rate: 7202 rpm Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS T13/1699-D revision 4 SATA Version is: SATA 3.0, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Tue Feb 2 18:43:05 2016 MSK SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 609) seconds. Offline data collection capabilities: (0x7b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 1) minutes. Extended self-test routine recommended polling time: ( 155) minutes. Conveyance self-test routine recommended polling time: ( 2) minutes. SCT capabilities: (0x10bd) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 10 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000f 080 051 044 Pre-fail Always - 107572489 3 Spin_Up_Time 0x0003 097 092 000 Pre-fail Always - 0 4 Start_Stop_Count 0x0032 099 099 020 Old_age Always - 1300 5 Reallocated_Sector_Ct 0x0033 091 091 036 Pre-fail Always - 397 7 Seek_Error_Rate 0x000f 091 060 030 Pre-fail Always - 1498448616 9 Power_On_Hours 0x0032 064 064 000 Old_age Always - 31552 10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0 12 Power_Cycle_Count 0x0032 099 099 020 Old_age Always - 1254 184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0 187 Reported_Uncorrect 0x0032 038 038 000 Old_age Always - 62 188 Command_Timeout 0x0032 100 099 000 Old_age Always - 4295098413 189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0 190 Airflow_Temperature_Cel 0x0022 066 050 045 Old_age Always - 34 (Min/Max 21/35) 191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 825 192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 244 193 Load_Cycle_Count 0x0032 100 100 000 Old_age Always - 1674 194 Temperature_Celsius 0x0022 034 050 000 Old_age Always - 34 (0 12 0 0 0) 195 Hardware_ECC_Recovered 0x001a 116 099 000 Old_age Always - 107572489 197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 0 198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 0 199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 1 SMART Error Log Version: 1 ATA Error Count: 132 (device log contains only the most recent five errors) CR = Command Register [HEX] FR = Features Register [HEX] SC = Sector Count Register [HEX] SN = Sector Number Register [HEX] CL = Cylinder Low Register [HEX] CH = Cylinder High Register [HEX] DH = Device/Head Register [HEX] DC = Device Command Register [HEX] ER = Error register [HEX] ST = Status register [HEX] Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 132 occurred at disk power-on lifetime: 31500 hours (1312 days + 12 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 00 78 ff ff ff 4f 00 22:16:36.831 READ FPDMA QUEUED 60 00 08 ff ff ff 4f 00 22:16:36.831 READ FPDMA QUEUED 60 00 08 ff ff ff 4f 00 22:16:36.831 READ FPDMA QUEUED 60 00 08 ff ff ff 4f 00 22:16:36.831 READ FPDMA QUEUED 60 00 08 ff ff ff 4f 00 22:16:36.831 READ FPDMA QUEUED Error 131 occurred at disk power-on lifetime: 31066 hours (1294 days + 10 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 25 9d ba 00 Error: WP at LBA = 0x00ba9d25 = 12229925 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 61 00 08 c0 92 65 40 00 00:00:48.866 WRITE FPDMA QUEUED 61 00 08 28 3f 5e 40 00 00:00:48.866 WRITE FPDMA QUEUED 61 00 08 38 8e 65 40 00 00:00:48.866 WRITE FPDMA QUEUED 61 00 08 f0 84 5e 40 00 00:00:48.866 WRITE FPDMA QUEUED 61 00 08 58 4b 06 40 00 00:00:48.866 WRITE FPDMA QUEUED Error 130 occurred at disk power-on lifetime: 31066 hours (1294 days + 10 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 1c 9d ba 00 Error: WP at LBA = 0x00ba9d1c = 12229916 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 61 00 08 78 78 65 40 00 00:00:39.542 WRITE FPDMA QUEUED 61 00 08 18 48 76 47 00 00:00:39.542 WRITE FPDMA QUEUED 61 00 08 40 4b 06 40 00 00:00:39.541 WRITE FPDMA QUEUED 61 00 08 f0 77 65 40 00 00:00:39.541 WRITE FPDMA QUEUED 61 00 08 e8 83 5e 40 00 00:00:39.541 WRITE FPDMA QUEUED Error 129 occurred at disk power-on lifetime: 31066 hours (1294 days + 10 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 10 9d ba 00 Error: WP at LBA = 0x00ba9d10 = 12229904 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 61 00 08 f0 77 65 40 00 00:00:29.146 WRITE FPDMA QUEUED 61 00 08 e8 83 5e 40 00 00:00:29.145 WRITE FPDMA QUEUED 61 00 08 78 77 65 40 00 00:00:29.145 WRITE FPDMA QUEUED 61 00 08 a8 d0 8d 40 00 00:00:29.145 WRITE FPDMA QUEUED 61 00 08 18 3f 5e 40 00 00:00:29.144 WRITE FPDMA QUEUED Error 128 occurred at disk power-on lifetime: 31066 hours (1294 days + 10 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 d8 9c ba 00 Error: WP at LBA = 0x00ba9cd8 = 12229848 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 61 00 08 50 80 58 44 00 00:00:18.708 WRITE FPDMA QUEUED 61 00 d8 10 83 5e 40 00 00:00:18.708 WRITE FPDMA QUEUED 61 00 70 88 05 30 45 00 00:00:18.698 WRITE FPDMA QUEUED 61 00 88 d8 6e f5 45 00 00:00:18.698 WRITE FPDMA QUEUED 61 00 70 ff ff ff 4f 00 00:00:18.698 WRITE FPDMA QUEUED SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 31493 - # 2 Short offline Completed without error 00% 31493 - # 3 Short offline Completed without error 00% 23611 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay.