CPU:   MPC8245 Revision 1.4 at 266.666 MHz: 16 kB I-Cache 16 kB D-Cache
Board: Sandpoint 8245 Unity ##Test not implemented yet##
I2C:   ready
DRAM:  64 MB
FLASH: S29GL128N, 16 MB
In:    serial
Out:   serial
Err:   serial
Net:   No ethernet found.
Hit any key to stop autoboot:  0 
## Starting application at 0xFFE60100 ...


U-Boot 1.2.0 (Feb 18 2007 - 10:26:32) OpenTS(c)

CPU:   MPC8241 Revision 1.4 at 266.666 MHz: 16 kB I-Cache 16 kB D-Cache
Board: QNAP TS-101/TS-201 local bus at 133.333 MHz
I2C:   ready
DRAM:  64 MB
FLASH: 16 MB
In:    serial
Out:   serial
Err:   serial
Net:   RTL8169sc/8110sc... RTL8169#0
IDE:   Bus 0: OK Bus 1: not available  
  Device 0: Model: SAMSUNG SP2504C Firm: VT100-41 Ser#: S09QJ1GL709404
            Type: Hard Disk
            Supports 48-bit addressing
            Capacity: 238475.1 MB = 232.8 GB (488397168 x 512)
  Device 1: not available
Hit any key to stop autoboot:  0 
=> ext2load ide 0:1 300000 uImage

2013939 bytes read
=> bootm 300000
## Booting image at 00300000 ...
   Image Name:   Linux-2.6.20.1
   Created:      2007-02-25   5:19:47 UTC
   Image Type:   PowerPC Linux Kernel Image (gzip compressed)
   Data Size:    2013875 Bytes =  1.9 MB
   Load Address: 00000000
   Entry Point:  00000000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK
Linux version 2.6.20.1 (repvik@apollo) (gcc version 3.4.6) #1 Sun Feb 25 06:19:44 CET 2007
Motorola SPS Sandpoint Test Platform
Port by MontaVista Software, Inc. (source@mvista.com)
Zone PFN ranges:
  DMA             0 ->    16384
  Normal      16384 ->    16384
early_node_map[1] active PFN ranges
    0:        0 ->    16384
Built 1 zonelists.  Total pages: 16256
Kernel command line: console=ttyS0,115200n8 root=/dev/ram
OpenPIC Version 1.2 (1 CPUs and 10 IRQ sources) at fdf40000
PID hash table entries: 256 (order: 8, 1024 bytes)
Console: colour dummy device 80x25
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 60800k available (2736k kernel code, 1248k data, 124k init, 0k highmem)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
PCI: Probing PCI hardware
PCI: Cannot allocate resource region 1 of device 0000:00:00.0
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 2048 bind 1024)
TCP reno registered
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
Installing knfsd (copyright (C) 1996 okir@monad.swb.de).
NTFS driver 2.1.28 [Flags: R/W].
io scheduler noop registered
io scheduler anticipatory registered (default)
io scheduler deadline registered
io scheduler cfq registered
Serial: 8250/16550 driver $Revision: 1.90 $ 1 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0x0 (irq = 25) is a 16550A
serial8250 serial8250.0: unable to register port at index 0 (IO0 MEMfdf04500 IRQ25): -28
RAMDISK driver initialized: 16 RAM disks of 40960K size 1024 blocksize
loop: loaded (max 8 devices)
Intel(R) PRO/1000 Network Driver - version 7.3.15-k2
Copyright (c) 1999-2006 Intel Corporation.
physmap platform flash device: 01000000 at ff000000
physmap-flash.0: Found 1 x16 devices at 0x0 in 8-bit bank
 Amd/Fujitsu Extended Query Table at 0x0040
physmap-flash.0: CFI does not contain boot bank location. Assuming top.
number of CFI chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
cmdlinepart partition parsing not available
RedBoot partition parsing not available
ehci_hcd 0000:00:0e.2: EHCI Host Controller
ehci_hcd 0000:00:0e.2: new USB bus registered, assigned bus number 1
IRQ handler type mismatch for IRQ 17
Call Trace:
[C04ADD70] [C000BB4C] show_stack+0x48/0x194 (unreliable)
[C04ADDA0] [C0039A54] setup_irq+0x164/0x23c
[C04ADDC0] [C0039CE8] request_irq+0xac/0xdc
[C04ADDF0] [C01F25E0] usb_add_hcd+0x334/0x5e0
[C04ADE20] [C01FC2D8] usb_hcd_pci_probe+0x210/0x2d0
[C04ADE50] [C018752C] pci_device_probe+0x80/0xa0
[C04ADE70] [C01B1618] really_probe+0xcc/0x144
[C04ADE90] [C01B1790] driver_probe_device+0xe0/0xe8
[C04ADEB0] [C01B1920] __driver_attach+0xcc/0xf8
[C04ADED0] [C01B058C] bus_for_each_dev+0x54/0x98
[C04ADF00] [C01B1970] driver_attach+0x24/0x34
[C04ADF10] [C01B0CE8] bus_add_driver+0x70/0x1e0
[C04ADF30] [C01B1F40] driver_register+0xc8/0xec
[C04ADF40] [C0187230] __pci_register_driver+0x6c/0xfc
[C04ADF70] [C03E2C28] ehci_hcd_init+0x1c/0x2c
[C04ADF80] [C00037B8] init+0x88/0x2e8
[C04ADFF0] [C0006298] kernel_thread+0x44/0x60
ehci_hcd 0000:00:0e.2: request interrupt 17 failed
ehci_hcd 0000:00:0e.2: USB bus 1 deregistered
ehci_hcd 0000:00:0e.2: init 0000:00:0e.2 fail, -16
ehci_hcd: probe of 0000:00:0e.2 failed with error -16
ohci_hcd 0000:00:0e.0: OHCI Host Controller
ohci_hcd 0000:00:0e.0: new USB bus registered, assigned bus number 1
IRQ handler type mismatch for IRQ 17
Call Trace:
[C04ADD70] [C000BB4C] show_stack+0x48/0x194 (unreliable)
[C04ADDA0] [C0039A54] setup_irq+0x164/0x23c
[C04ADDC0] [C0039CE8] request_irq+0xac/0xdc
[C04ADDF0] [C01F25E0] usb_add_hcd+0x334/0x5e0
[C04ADE20] [C01FC2D8] usb_hcd_pci_probe+0x210/0x2d0
[C04ADE50] [C018752C] pci_device_probe+0x80/0xa0
[C04ADE70] [C01B1618] really_probe+0xcc/0x144
[C04ADE90] [C01B1790] driver_probe_device+0xe0/0xe8
[C04ADEB0] [C01B1920] __driver_attach+0xcc/0xf8
[C04ADED0] [C01B058C] bus_for_each_dev+0x54/0x98
[C04ADF00] [C01B1970] driver_attach+0x24/0x34
[C04ADF10] [C01B0CE8] bus_add_driver+0x70/0x1e0
[C04ADF30] [C01B1F40] driver_register+0xc8/0xec
[C04ADF40] [C0187230] __pci_register_driver+0x6c/0xfc
[C04ADF70] [C03E2C78] ohci_hcd_pci_init+0x40/0x58
[C04ADF80] [C00037B8] init+0x88/0x2e8
[C04ADFF0] [C0006298] kernel_thread+0x44/0x60
ohci_hcd 0000:00:0e.0: request interrupt 17 failed
ohci_hcd 0000:00:0e.0: USB bus 1 deregistered
ohci_hcd 0000:00:0e.0: init 0000:00:0e.0 fail, -16
ohci_hcd: probe of 0000:00:0e.0 failed with error -16
ohci_hcd 0000:00:0e.1: OHCI Host Controller
ohci_hcd 0000:00:0e.1: new USB bus registered, assigned bus number 1
IRQ handler type mismatch for IRQ 17
Call Trace:
[C04ADD70] [C000BB4C] show_stack+0x48/0x194 (unreliable)
[C04ADDA0] [C0039A54] setup_irq+0x164/0x23c
[C04ADDC0] [C0039CE8] request_irq+0xac/0xdc
[C04ADDF0] [C01F25E0] usb_add_hcd+0x334/0x5e0
[C04ADE20] [C01FC2D8] usb_hcd_pci_probe+0x210/0x2d0
[C04ADE50] [C018752C] pci_device_probe+0x80/0xa0
[C04ADE70] [C01B1618] really_probe+0xcc/0x144
[C04ADE90] [C01B1790] driver_probe_device+0xe0/0xe8
[C04ADEB0] [C01B1920] __driver_attach+0xcc/0xf8
[C04ADED0] [C01B058C] bus_for_each_dev+0x54/0x98
[C04ADF00] [C01B1970] driver_attach+0x24/0x34
[C04ADF10] [C01B0CE8] bus_add_driver+0x70/0x1e0
[C04ADF30] [C01B1F40] driver_register+0xc8/0xec
[C04ADF40] [C0187230] __pci_register_driver+0x6c/0xfc
[C04ADF70] [C03E2C78] ohci_hcd_pci_init+0x40/0x58
[C04ADF80] [C00037B8] init+0x88/0x2e8
[C04ADFF0] [C0006298] kernel_thread+0x44/0x60
ohci_hcd 0000:00:0e.1: request interrupt 17 failed
ohci_hcd 0000:00:0e.1: USB bus 1 deregistered
ohci_hcd 0000:00:0e.1: init 0000:00:0e.1 fail, -16
ohci_hcd: probe of 0000:00:0e.1 failed with error -16
usbcore: registered new interface driver usblp
drivers/usb/class/usblp.c: v0.13: USB Printer Device Class driver
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
i8042.c: i8042 controller self test timeout.
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
NET: Registered protocol family 4
NET: Registered protocol family 5