RedBoot> go
Uncompressing Linux................................................................. done, booting the kernel.
Linux version 2.6.15 (repvik@dev) (gcc version 3.4.4) #1 Fri Jan 20 11:11:13 CET 2006
CPU: XScale-IXP42x Family [690541f1] revision 1 (ARMv5TE)
Machine: Iomega NAS 100d
Warning: bad configuration page, trying to continue
Ignoring unrecognised tag 0x00000000
Memory policy: ECC disabled, Data cache writeback
CPU0: D VIVT undefined 5 cache
CPU0: I cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
CPU0: D cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
Built 1 zonelists
Kernel command line: root=/dev/hde1 init=/linuxrc pcf8563.hctosys=1  noirqdebug console=ttyS0,115200n8
PID hash table entries: 512 (order: 9, 8192 bytes)
IXP4xx: FREQ=66666600 COUNT=666665
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 64MB = 64MB total
Memory: 62756KB available (1791K code, 176K data, 88K init)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
NET: Registered protocol family 16
PCI: IXP4xx is host
PCI: IXP4xx Using indirect access for memory space
PCI: bus0: Fast back to back transfers disabled
dmabounce: registered device 0000:00:01.0 on pci bus
dmabounce: registered device 0000:00:02.0 on pci bus
dmabounce: registered device 0000:00:02.1 on pci bus
dmabounce: registered device 0000:00:02.2 on pci bus
SCSI subsystem initialized
usbcore: registered new driver usbfs
usbcore: registered new driver hub
NetWinder Floating Point Emulator V0.97 (double precision)
JFFS2 version 2.2. (NAND) (C) 2001-2003 Red Hat, Inc.
Initializing Cryptographic API
io scheduler noop registered
io scheduler deadline registered
pcf8563-rtc: real time clock
IXP4xx Watchdog Timer: heartbeat 60 sec
Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0xc8000000 (irq = 15) is a XScale
serial8250.0: ttyS1 at MMIO 0xc8001000 (irq = 13) is a XScale
RAMDISK driver initialized: 4 RAM disks of 10240K size 1024 blocksize
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
AEC6880: IDE controller at PCI slot 0000:00:01.0
PCI: enabling device 0000:00:01.0 (0140 -> 0141)
AEC6880: chipset revision 7
AEC6880: ROM enabled at 0x48000000
AEC6880: 100% native mode on irq 28
    ide2: BM-DMA at 0x1040-0x1047, BIOS settings: hde:pio, hdf:pio
    ide3: BM-DMA at 0x1048-0x104f, BIOS settings: hdg:pio, hdh:pio
hde: Maxtor 6L160P0, ATA DISK drive
ide2 at 0x1050-0x1057,0x1062 on irq 28
hde: max request size: 1024KiB
hde: lost interrupt
hde: lost interrupt
hde: lost interrupt
hde: 312581808 sectors (160041 MB) w/8192KiB Cache, CHS=19457/255/63
hde: lost interrupt
hde: cache flushes supported
 hde:<4>hde: lost interrupt
hde: lost interrupt
hde: lost interrupt
hde: lost interrupt
hde: lost interrupt
hde: lost interrupt
hde: lost interrupt
hde: lost interrupt
 hde1 hde2 hde3 hde4
hde: lost interrupt
INFTL: inftlcore.c $Revision: 1.19 $, inftlmount.c $Revision: 1.18 $
IXP4XXFlash: map_probe failed
No recognised DiskOnChip devices found
PCI: enabling device 0000:00:02.2 (0140 -> 0142)
ehci_hcd 0000:00:02.2: Found HC with no IRQ.  Check BIOS/PCI 0000:00:02.2 setup!
ehci_hcd 0000:00:02.2: init 0000:00:02.2 fail, -19
Initializing USB Mass Storage driver...
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
i2c /dev entries driver
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 4096 (order: 2, 16384 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
TCP reno registered
TCP bic registered
NET: Registered protocol family 1
Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(33,1)