## Booting image at ff000000 ...
   Image Name:   Linux-2.6.20.1-opents
   Image Type:   PowerPC Linux Kernel Image (gzip compressed)
   Data Size:    1408957 Bytes =  1.3 MB
   Load Address: 00000000
   Entry Point:  00000000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK
Linux version 2.6.20.1-opents (repvik@apollo) (gcc version 4.1.1) #1 Thu Mar 1 18:35:00 CET 2007
Motorola SPS Sandpoint Test Platform
Port by MontaVista Software, Inc. (source@mvista.com)
Zone PFN ranges:
  DMA             0 ->    32768
  Normal      32768 ->    32768
early_node_map[1] active PFN ranges
    0:        0 ->    32768
Built 1 zonelists.  Total pages: 32512
Kernel command line: console=ttyS0,115200n8 root=/dev/mtdblock2 rootfstype=jffs2 rw init=/linuxrc
OpenPIC Version 1.2 (1 CPUs and 10 IRQ sources) at fdf40000
PID hash table entries: 512 (order: 9, 2048 bytes)
Console: colour dummy device 80x25
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 126976k available (2160k kernel code, 660k data, 120k init, 0k highmem)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
PCI: Probing PCI hardware
PCI: Cannot allocate resource region 1 of device 0000:00:00.0
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 4096 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 4096 bind 2048)
TCP reno registered
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
JFFS2 version 2.2. (NAND) (SUMMARY)  (C) 2001-2006 Red Hat, Inc.
io scheduler noop registered
io scheduler anticipatory registered (default)
io scheduler deadline registered
io scheduler cfq registered
Serial: 8250/16550 driver $Revision: 1.90 $ 1 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0x0 (irq = 25) is a 16550A
serial8250 serial8250.0: unable to register port at index 0 (IO0 MEMfdf04500 IRQ25): -28
RAMDISK driver initialized: 16 RAM disks of 40960K size 1024 blocksize
loop: loaded (max 8 devices)
Intel(R) PRO/1000 Network Driver - version 7.3.15-k2
Copyright (c) 1999-2006 Intel Corporation.
eth0: r10001.05, the Linux device driver for Realtek Ethernet Controllers at 0xbffe00, 00:e0:4c:69:20:01, IRQ 18
Realtek RTL8169/8110 Family Gigabit Ethernet Network Adapter
Driver version:1.05
Released date:2006/10/25
Link Status:Linked
Link Speed:100Mbps
Duplex mode:Full-Duplex
I/O Base:0xBFFE00(I/O port)
IRQ:18
sata_sil 0000:00:0d.0: cache line size not set.  Driver may not function
sata_sil 0000:00:0d.0: Applying R_ERR on DMA activate FIS errata fix
ata1: SATA max UDMA/100 cmd 0xC9050E80 ctl 0xC9050E8A bmdma 0xC9050E00 irq 16
ata2: SATA max UDMA/100 cmd 0xC9050EC0 ctl 0xC9050ECA bmdma 0xC9050E08 irq 16
scsi0 : sata_sil
ata1: SATA link up 1.5 Gbps (SStatus 113 SControl 310)
ata1.00: ATA-7, max UDMA/133, 625142448 sectors: LBA48 NCQ (depth 0/32)
ata1.00: configured for UDMA/100
scsi1 : sata_sil
ata2: SATA link up 1.5 Gbps (SStatus 113 SControl 310)
ata2.00: ATA-7, max UDMA/133, 625142448 sectors: LBA48 NCQ (depth 0/32)
ata2.00: configured for UDMA/100
scsi 0:0:0:0: Direct-Access     ATA      ST3320620AS      3.AA PQ: 0 ANSI: 5
SCSI device sda: 625142448 512-byte hdwr sectors (320073 MB)
sda: Write Protect is off
SCSI device sda: write cache: enabled, read cache: enabled, doesn't support DPO or FUA
SCSI device sda: 625142448 512-byte hdwr sectors (320073 MB)
sda: Write Protect is off
SCSI device sda: write cache: enabled, read cache: enabled, doesn't support DPO or FUA
 sda: sda1 sda2 sda3
sd 0:0:0:0: Attached scsi disk sda
sd 0:0:0:0: Attached scsi generic sg0 type 0
scsi 1:0:0:0: Direct-Access     ATA      ST3320620AS      3.AA PQ: 0 ANSI: 5
SCSI device sdb: 625142448 512-byte hdwr sectors (320073 MB)
sdb: Write Protect is off
SCSI device sdb: write cache: enabled, read cache: enabled, doesn't support DPO or FUA
SCSI device sdb: 625142448 512-byte hdwr sectors (320073 MB)
sdb: Write Protect is off
SCSI device sdb: write cache: enabled, read cache: enabled, doesn't support DPO or FUA
 sdb: sdb1 sdb2 sdb3
sd 1:0:0:0: Attached scsi disk sdb
sd 1:0:0:0: Attached scsi generic sg1 type 0
physmap platform flash device: 01000000 at ff000000
physmap-flash.0: Found 1 x16 devices at 0x0 in 8-bit bank
 Amd/Fujitsu Extended Query Table at 0x0040
physmap-flash.0: CFI does not contain boot bank location. Assuming top.
number of CFI chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
RedBoot partition parsing not available
Using physmap partition information
Creating 7 MTD partitions on "physmap-flash.0":
0x00f00000-0x00f40000 : "U-Boot"
0x00000000-0x00200000 : "Kernel"
0x00200000-0x00b00000 : "RootFS1"
0x00b00000-0x00e00000 : "RootFS2"
0x00e00000-0x00f00000 : "Vendor"
0x00f40000-0x00f60000 : "U-Boot Config"
0x00f60000-0x01000000 : "NAS Config"
ehci_hcd 0000:00:0e.2: EHCI Host Controller
ehci_hcd 0000:00:0e.2: new USB bus registered, assigned bus number 1
ehci_hcd 0000:00:0e.2: irq 17, io mem 0xbfffcf00
ehci_hcd 0000:00:0e.2: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 5 ports detected
ohci_hcd 0000:00:0e.0: OHCI Host Controller
ohci_hcd 0000:00:0e.0: new USB bus registered, assigned bus number 2
ohci_hcd 0000:00:0e.0: irq 17, io mem 0xbfffe000
usb usb2: configuration #1 chosen from 1 choice
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 3 ports detected
ohci_hcd 0000:00:0e.1: OHCI Host Controller
ohci_hcd 0000:00:0e.1: new USB bus registered, assigned bus number 3
ohci_hcd 0000:00:0e.1: irq 17, io mem 0xbfffd000
usb usb3: configuration #1 chosen from 1 choice
hub 3-0:1.0: USB hub found
hub 3-0:1.0: 2 ports detected
usbcore: registered new interface driver usblp
drivers/usb/class/usblp.c: v0.13: USB Printer Device Class driver
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
drivers/rtc/hctosys.c: unable to open rtc device (rtc0)
Empty flash at 0x0000fffc ends at 0x00010000
Empty flash at 0x0002fffc ends at 0x00030000
Empty flash at 0x0004fffc ends at 0x00050000
Empty flash at 0x0008fffc ends at 0x00090000
Empty flash at 0x000afffc ends at 0x000b0000
Empty flash at 0x000cff60 ends at 0x000d0000
Empty flash at 0x000efffc ends at 0x000f0000
Empty flash at 0x0010fffc ends at 0x00110000
Empty flash at 0x0012fffc ends at 0x00130000
Empty flash at 0x0014fffc ends at 0x00150000
Empty flash at 0x0016fffc ends at 0x00170000
Empty flash at 0x0018fffc ends at 0x00190000
Empty flash at 0x001afffc ends at 0x001b0000
Empty flash at 0x001cfffc ends at 0x001d0000
Empty flash at 0x001efffc ends at 0x001f0000
Empty flash at 0x0022fffc ends at 0x00230000
Empty flash at 0x0024fffc ends at 0x00250000
Empty flash at 0x0026fffc ends at 0x00270000
Empty flash at 0x0028fffc ends at 0x00290000
Empty flash at 0x002afffc ends at 0x002b0000
Empty flash at 0x002cfffc ends at 0x002d0000
Empty flash at 0x002efffc ends at 0x002f0000
Empty flash at 0x0030fffc ends at 0x00310000
Empty flash at 0x0032fffc ends at 0x00330000
Empty flash at 0x0034ff90 ends at 0x00350000
Empty flash at 0x0036fffc ends at 0x00370000
Empty flash at 0x0038fffc ends at 0x00390000
JFFS2 notice: (1) jffs2_build_xattr_subsystem: complete building xattr subsystem, 0 of xdatum (0 unchecked, 0 orphan) and 0 of xref (0 dead, 0 orphan) found.
VFS: Mounted root (jffs2 filesystem).
Freeing unused kernel memory: 120k init
Warning: unable to open an initial console.
Failed to execute /linuxrc.  Attempting defaults...
Kernel panic - not syncing: No init found.  Try passing init= option to kernel.
 <0>Rebooting in 180 seconds..