usb 1-1: new full speed USB device using address 2 Initializing USB Mass Storage driver... scsi2 : SCSI emulation for USB Mass Storage devices Vendor: Maxtor Model: 5000LE v01.00.00 Rev: 0100 Type: Direct-Access ANSI SCSI revision: 02 SCSI device sdc: 160084992 512-byte hdwr sectors (81964 MB) sdc: assuming drive cache: write through SCSI device sdc: 160084992 512-byte hdwr sectors (81964 MB) sdc: assuming drive cache: write through sdc: sdc1 Attached scsi disk sdc at scsi2, channel 0, id 0, lun 0 USB Mass Storage device found at 2 usbcore: registered new driver usb-storage USB Mass Storage support registered. ACPI: Power Button (FF) [PWRF] EXT3 FS on dm-0, internal journal cdrom: open failed. kjournald starting. Commit interval 5 seconds EXT3 FS on sda1, internal journal EXT3-fs: mounted filesystem with ordered data mode. kjournald starting. Commit interval 5 seconds EXT3 FS on sda2, internal journal EXT3-fs: mounted filesystem with ordered data mode. NTFS driver 2.1.20 [Flags: R/W MODULE]. Adding 1310712k swap on /dev/VolGroup00/LogVol01. Priority:-1 extents:1 IA-32 Microcode Update Driver: v1.14 microcode: CPU0 already at revision 0xe (current=0xe) microcode: No new microdata for cpu 0 IA-32 Microcode Update Driver v1.14 unregistered parport0: PC-style at 0x378 (0x778) [PCSPP,TRISTATE,EPP] parport0: irq 7 detected ieee1394: Initialized config rom entry `ip1394' ip_tables: (C) 2000-2002 Netfilter core team ip_tables: (C) 2000-2002 Netfilter core team ACPI: PCI interrupt 0000:00:11.0[A] -> GSI 20 (level, low) -> IRQ 185 ip_tables: (C) 2000-2002 Netfilter core team NTFS volume version 3.1. NTFS-fs error (device sdc1): load_system_files(): Volume is dirty. Mounting read-only. Run chkdsk and mount in Windows. parport0: PC-style at 0x378 (0x778) [PCSPP,TRISTATE,EPP] parport0: irq 7 detected lp0: using parport0 (polling). lp0: console ready NET: Registered protocol family 10 Disabled Privacy Extensions on device c03955e0(lo) IPv6 over IPv4 tunneling driver divert: not allocating divert_blk for non-ethernet device sit0 Installing knfsd (copyright (C) 1996 okir@monad.swb.de). eth0: no IPv6 routers present [root@mikes ~]#