# nets
net Xdir stepgen.0.dir => parport.0.pin-04-out
net Xen axis.0.amp-enable-out => stepgen.0.enable
net Xpos-cmd axis.0.motor-pos-cmd => stepgen.0.position-cmd
net Xpos-fb stepgen.0.position-fb => axis.0.motor-pos-fb
net Xstep stepgen.0.step => parport.0.pin-05-out
net Ydir stepgen.1.dir => parport.0.pin-02-out
net Yen axis.1.amp-enable-out => stepgen.1.enable
net Ypos-cmd axis.1.motor-pos-cmd => stepgen.1.position-cmd
net Ypos-fb stepgen.1.position-fb => axis.1.motor-pos-fb
net Ystep stepgen.1.step => parport.0.pin-03-out
net Zdir stepgen.2.dir => parport.0.pin-06-out
net Zen axis.2.amp-enable-out => stepgen.2.enable
net Zpos-cmd axis.2.motor-pos-cmd => stepgen.2.position-cmd
net Zpos-fb stepgen.2.position-fb => axis.2.motor-pos-fb
net Zstep stepgen.2.step => parport.0.pin-07-out
net attiva_mandrino motion.spindle-on => parport.0.pin-01-out
net attiva_refrigerante iocontrol.0.coolant-mist => parport.0.pin-14-out
net finecorsa-x parport.0.pin-10-in-not => axis.0.pos-lim-sw-in
net finecorsa-y parport.0.pin-12-in-not => axis.1.pos-lim-sw-in
net finecorsa-z parport.0.pin-13-in-not => axis.2.pos-lim-sw-in
net hal_manualtoolchange.change iocontrol.0.tool-change => hal_manualtoolchange.change
net hal_manualtoolchange.changed hal_manualtoolchange.changed => iocontrol.0.tool-changed
net hal_manualtoolchange.number iocontrol.0.tool-prep-number => hal_manualtoolchange.number
net parport.0.pin-11-in parport.0.pin-11-in => iocontrol.0.emc-enable-in