Zapata Telephony Interface Registered on major 196
Zaptel Version: 1.4.0 Echo Canceller: MG2
Found TE2XXP at base address f2000000, remapped to f887c000
TE2XXP version c01a016a, burst OFF, slip debug: OFF
Octasic optimized!
FALC version: 00000005, Board ID: 00
Reg 0: 0x37207400
Reg 1: 0x37207000
Reg 2: 0xffffffff
Reg 3: 0x00000000
Reg 4: 0x00000101
Reg 5: 0x00000000
Reg 6: 0xc01a016a
Reg 7: 0x00001000
Reg 8: 0x010200ff
Reg 9: 0x00fd0001
Reg 10: 0x0000004a
TE2XXP: Launching card: 0
TE2XXP: Setting up global serial parameters
Found a Wildcard: Wildcard TE210P (3rd Gen)
About to enter spanconfig!
Done with spanconfig!
Registered tone zone 0 (United States / North America)
About to enter startup!
TE2XXP: Span 1 configured for ESF/B8ZS
wct2xxp: Setting yellow alarm on span 1
timing source auto card 0!
SPAN 1: Primary Sync Source
VPM400: Not Present
VPM450: echo cancellation for 64 channels
Before chip open!
After chip open!
Failed to open chip, code 00103042!
VPM450: echo cancellation for 64 channels
Before chip open!
After chip open!
VPM450: hardware DTMF disabled.
VPM450: Present and operational servicing 2 span(s)
Completed startup!


Zaptel Version: 1.4.0
Echo Canceller: MG2
Configuration
======================

SPAN 1: ESF/B8ZS Build-out: 0 db (CSU)/0-133 feet (DSX-1)

Channel map:

Channel 01: Clear channel (Default) (Slaves: 01)
Channel 02: Clear channel (Default) (Slaves: 02)
Channel 03: Clear channel (Default) (Slaves: 03)
Channel 04: Clear channel (Default) (Slaves: 04)
Channel 05: Clear channel (Default) (Slaves: 05)
Channel 06: Clear channel (Default) (Slaves: 06)
Channel 07: Clear channel (Default) (Slaves: 07)
Channel 08: Clear channel (Default) (Slaves: 08)
Channel 09: Clear channel (Default) (Slaves: 09)
Channel 10: Clear channel (Default) (Slaves: 10)
Channel 11: Clear channel (Default) (Slaves: 11)
Channel 12: Clear channel (Default) (Slaves: 12)
Channel 24: D-channel (Default) (Slaves: 24)