After a power-cycle (and reseating the GBIC in the HBA that A0 connects to):



                                   SENA
                                 DISK STATUS
SLOT   FRONT DISKS       (Node WWN)          REAR DISKS        (Node WWN)
0      On (O.K.)         20000020374f031b    Not Installed
1      Not Installed                         Not Installed
2      Not Installed                         Not Installed
3      Not Installed                         Not Installed
4      Not Installed                         Not Installed
5      Not Installed                         Not Installed
6      Not Installed                         Not Installed
7      Not Installed                         Not Installed
8      Not Installed                         Not Installed
9      Not Installed                         Not Installed
10     On (O.K.)         20000020379df599    Not Installed
                                SUBSYSTEM STATUS
FW Revision:1.09   Box ID:0   Node WWN:50800200000ece88   Enclosure Name:osvaldo
Power Supplies (0,2 in front, 1 in rear)
        0 O.K.(rev.-02) 1 O.K.(rev.-02) 2 O.K.(rev.-02)
Fans (0 in front, 1 in rear)
        0 O.K.(rev.-04) 1 O.K.(rev.-00)
ESI Interface board(IB) (A top, B bottom)
        A: O.K.(rev.-04)

 GBIC module (1 on left, 0 on right in IB)
                0 O.K.(mod.-05)
                1 O.K.(mod.-05)
        B: O.K.(rev.-04)
                GBIC module (1 on left, 0 on right in IB)
                0 Not Installed
                1 Not Installed
Disk backplane (0 in front, 1 in rear)
        Front Backplane: O.K.(rev.-04)
          Temperature sensors (on front backplane)
          0:34\272C 1:33\272C 2:34\272C 3:34\272C 4:34\272C 5:34\272C
          6:34\272C 7:34\272C 8:34\272C 9:34\272C 10:36\272C  (All temperatures
are NORMAL.)
        Rear Backplane:  O.K.(rev.-04)
          Temperature sensors (on rear backplane)
          0:34\272C 1:34\272C 2:34\272C 3:34\272C 4:34\272C 5:34\272C
          6:34\272C 7:34\272C 8:34\272C 9:34\272C 10:34\272C  (All temperatures
are NORMAL.)
Interconnect assembly
        O.K.(rev.-02)
Loop  configuration
        Loop A is configured as two separate loops.
        Loop B is configured as two separate loops.

  Searching directory /dev/es for links to enclosures

Link Error Status information for loop:/devices/sbus@1f,0/SUNW,socal@0,0:0
al_pa   lnk fail    sync loss   signal loss   sequence err   invalid word   CRC
1       720896      0           0             0              0              0

d2      0           0           5             0              0              0

ef      0           133         0             0              0              0

d5      0           0           0             0              0              0

NOTE: These LESB counts are not cleared by a reset, only power cycles.
These counts must be compared to previously read counts.


# luxadm -e dump_map /devices/sbus@1f,0/SUNW,socal@0,0:0
Host Adapter AL_PA: 1
Pos AL_PA
0     1 
1     d2
2     ef
3     d5
#