Linux version 2.6.20 (rwhitby@take.astc-design.net) (gcc version 4.1.1) #1 PREEM
PT Sun Apr 1 20:48:01 CST 2007
CPU: XScale-IXP42x Family [690541f1] revision 1 (ARMv5TE), cr=000039ff
Machine: Linksys NSLU2
Memory policy: ECC disabled, Data cache writeback
CPU0: D VIVT undefined 5 cache
CPU0: I cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
CPU0: D cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
Built 1 zonelists.  Total pages: 8128
Kernel command line: rtc-x1205.probe=0,0x6f console=ttyS0,115200n8 root=/dev/mtd
block4 rootfstype=jffs2 init=/linuxrc rw noirqde
PID hash table entries: 128 (order: 7, 512 bytes)
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Memory: 32MB = 32MB total
Memory: 30228KB available (1964K code, 162K data, 92K init)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
NET: Registered protocol family 16
IXP4xx: Using 16MiB expansion bus window size
PCI: IXP4xx is host
PCI: IXP4xx Using direct access for memory space
PCI: bus0: Fast back to back transfers disabled
dmabounce: registered device 0000:00:01.0 on pci bus
dmabounce: registered device 0000:00:01.1 on pci bus
dmabounce: registered device 0000:00:01.2 on pci bus
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 0, 4096 bytes)
TCP bind hash table entries: 512 (order: -1, 2048 bytes)
TCP: Hash tables configured (established 1024 bind 512)
TCP reno registered
NetWinder Floating Point Emulator V0.97 (double precision)
JFFS2 version 2.2. (NAND) (C) 2001-2006 Red Hat, Inc.
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0xc8000000 (irq = 15) is a XScale
serial8250.0: ttyS1 at MMIO 0xc8001000 (irq = 13) is a XScale
RAMDISK driver initialized: 4 RAM disks of 10240K size 1024 blocksize
IXP4XX Q Manager 0.2.1 initialized.
IXP4XX NPE driver Version 0.3.0 initialized
NFTL driver: nftlcore.c $Revision: 1.98 $, nftlmount.c $Revision: 1.41 $
IXP4XX-Flash.0: Found 1 x16 devices at 0x0 in 16-bit bank
 Intel/Sharp Extended Query Table at 0x0031
Using buffer write method
cfi_cmdset_0001: Erase suspend on write enabled
Searching for RedBoot partition table in IXP4XX-Flash.0 at offset 0x7e0000
6 RedBoot partitions found on MTD device IXP4XX-Flash.0
Creating 6 MTD partitions on "IXP4XX-Flash.0":
0x00000000-0x00040000 : "RedBoot"
nslu2 mac: 00:04:5a:0f:b2:c6
0x00040000-0x00060000 : "SysConf"
0x00060000-0x00160000 : "Kernel"
0x00160000-0x00180000 : "Ramdisk"
0x00180000-0x007e0000 : "Flashdisk"
0x007e0000-0x00800000 : "FIS directory"
npe: searching for firmware...
npe: found at 0x1c010, IXP425/NPE-B func: 00, rev: 2.1, size: 11964, id: 0100020
1
Image loaded to NPE-B Func:0, Rel: 2:1, Status: 82c00000
PCI: enabling device 0000:00:01.2 (0140 -> 0142)
ehci_hcd 0000:00:01.2: EHCI Host Controller
ehci_hcd 0000:00:01.2: new USB bus registered, assigned bus number 1
ehci_hcd 0000:00:01.2: irq 26, io mem 0x48002000
ehci_hcd 0000:00:01.2: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 5 ports detected
Initializing USB Mass Storage driver...
usb 1-1: new high speed USB device using ehci_hcd and address 2
usb 1-1: configuration #1 chosen from 1 choice
usb 1-2: new high speed USB device using ehci_hcd and address 3
usb 1-2: configuration #1 chosen from 1 choice
hub 1-2:1.0: USB hub found
hub 1-2:1.0: 4 ports detected
scsi0 : SCSI emulation for USB Mass Storage devices
usb 1-2.1: new full speed USB device using ehci_hcd and address 4
scsi 0:0:0:0: Direct-Access     Imation  Flash Drive      1.00 PQ: 0 ANSI: 2
SCSI device sda: 1003520 512-byte hdwr sectors (514 MB)
sda: Write Protect is off
sda: assuming drive cache: write through
SCSI device sda: 1003520 512-byte hdwr sectors (514 MB)
sda: Write Protect is off
sda: assuming drive cache: write through
 sda: sda1 sda2
sd 0:0:0:0: Attached scsi removable disk sda
usb 1-2.1: configuration #1 chosen from 1 choice
usb 1-2.4: new high speed USB device using ehci_hcd and address 5
usb 1-2.4: configuration #1 chosen from 1 choice
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
input: ixp4xx beeper as /class/input/input0
i2c /dev entries driver
x1205 0-006f: chip found, driver version 1.0.7
x1205 0-006f: rtc core: registered x1205 as rtc0
Registered led device: ready
Registered led device: status
Registered led device: disk-1
Registered led device: disk-2
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
XScale DSP coprocessor detected.
Time: OSTS clocksource has been installed.
ixp4xx_mac driver 0.3.1: eth0 on NPE-B with PHY[1] initialized
x1205 0-006f: setting the system clock to 2007-04-01 10:47:43 (1175424463)
VFS: Mounted root (jffs2 filesystem).
Freeing init memory: 92K
Failed to execute /linuxrc.  Attempting defaults...
/sbin/ini: error while loading shared libraKernel panic - not syncing: Attempted
 to kill init!
 ies: /e/l///libc.so.6siinvalid ELF heade/li//l/bc./o.6isibsb