Section "InputDevice"

# Identifier and driver

    Identifier	"Mouse1"
    Driver	"mouse"

# The mouse protocol and device.  The device is normally set to /dev/mouse,
# which is usually a symbolic link to the real device.

    Option	"Protocol"	"Imps/2"
    Option	"Device"	"/dev/input/mice"

# On platforms where PnP mouse detection is supported the following
# protocol setting can be used when using a newer PnP mouse:

#    Option	"Protocol"	"Auto"

# When using mouse connected to a PS/2 port (aka "MousePort"), set the
# the protocol as follows.  On some platforms some other settings may
# be available.

#    Option "Protocol"	"PS/2"

# When using XQUEUE (only for SVR3 and SVR4, but not Solaris), use
# the following instead of any of the lines above.  The Device line
# is not required in this case.

#    Option	"Protocol"	"Xqueue"

# Baudrate and SampleRate are only for some older Logitech mice.  In
# almost every case these lines should be omitted.

#    Option	"BaudRate"	"9600"
#    Option	"SampleRate"	"150"

# Emulate3Buttons is an option for 2-button mice
# Emulate3Timeout is the timeout in milliseconds (default is 50ms)

#    Option	"Emulate3Buttons"
#    Option	"Emulate3Timeout"	"50"

# ChordMiddle is an option for some 3-button Logitech mice, or any
# 3-button mouse where the middle button generates left+right button
# events.

#    Option	"ChordMiddle"

EndSection