Linux version 2.6.20-gentoo-r8 (root@myhost) (gcc version 4.1.1 (Gentoo 4.1.1-r3)) #1 Wed May 9 10:18:44 Local time zone must be set--see zic manua BIOS-provided physical RAM map: sanitize start sanitize end copy_e820_map() start: 0000000000000000 size: 00000000000a0000 end: 00000000000a0000 type: 1 copy_e820_map() type is E820_RAM copy_e820_map() start: 00000000000f0000 size: 0000000000010000 end: 0000000000100000 type: 2 copy_e820_map() start: 0000000000100000 size: 000000001fdf0000 end: 000000001fef0000 type: 1 copy_e820_map() type is E820_RAM copy_e820_map() start: 000000001fef0000 size: 0000000000003000 end: 000000001fef3000 type: 4 copy_e820_map() start: 000000001fef3000 size: 000000000000d000 end: 000000001ff00000 type: 3 copy_e820_map() start: 00000000ffb00000 size: 0000000000500000 end: 0000000100000000 type: 2 BIOS-e820: 0000000000000000 - 00000000000a0000 (usable) BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 000000001fef0000 (usable) BIOS-e820: 000000001fef0000 - 000000001fef3000 (ACPI NVS) BIOS-e820: 000000001fef3000 - 000000001ff00000 (ACPI data) BIOS-e820: 00000000ffb00000 - 0000000100000000 (reserved) 510MB LOWMEM available. Entering add_active_range(0, 0, 130800) 0 entries of 256 used Zone PFN ranges: DMA 0 -> 4096 Normal 4096 -> 130800 early_node_map[1] active PFN ranges 0: 0 -> 130800 On node 0 totalpages: 130800 DMA zone: 32 pages used for memmap DMA zone: 0 pages reserved DMA zone: 4064 pages, LIFO batch:0 Normal zone: 989 pages used for memmap Normal zone: 125715 pages, LIFO batch:31 DMI 2.2 present. Allocating PCI resources starting at 20000000 (gap: 1ff00000:dfc00000) Detected 1002.347 MHz processor. Built 1 zonelists. Total pages: 129779 Kernel command line: ip=dhcp root=/dev/nfs nfsroot=192.168.0.6:/!/circle/nest/helix Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Initializing CPU#0 PID hash table entries: 2048 (order: 11, 8192 bytes) Console: colour VGA+ 80x25 Dentry cache hash table entries: 65536 (order: 6, 262144 bytes) Inode-cache hash table entries: 32768 (order: 5, 131072 bytes) Memory: 514628k/523200k available (2253k kernel code, 8024k reserved, 773k data, 180k init, 0k highmem) virtual kernel memory layout: fixmap : 0xffffd000 - 0xfffff000 ( 8 kB) vmalloc : 0xe0800000 - 0xffffb000 ( 503 MB) lowmem : 0xc0000000 - 0xdfef0000 ( 510 MB) .init : 0xc03f8000 - 0xc0425000 ( 180 kB) .data : 0xc0333722 - 0xc03f4ec4 ( 773 kB) .text : 0xc0100000 - 0xc0333722 (2253 kB) Checking if this processor honours the WP bit even in supervisor mode... Ok. Calibrating delay using timer specific routine.. 2005.57 BogoMIPS (lpj=10027882) Security Framework v1.0.0 initialized Mount-cache hash table entries: 512 CPU: After generic identify, caps: 0387f9ff 00000000 00000000 00000000 00000000 00000000 00000000 CPU: L1 I cache: 16K, L1 D cache: 16K CPU: L2 cache: 256K CPU serial number disabled. CPU: After all inits, caps: 0383f9ff 00000000 00000000 00000040 00000000 00000000 00000000 CPU: Intel Pentium III (Coppermine) stepping 0a Checking 'hlt' instruction... OK. NET: Registered protocol family 16 PCI: PCI BIOS revision 2.10 entry at 0xfb370, last bus=1 PCI: Using configuration type 1 Setting up standard PCI resources SCSI subsystem initialized PCI: Probing PCI hardware PCI: Probing PCI hardware (bus 00) Boot video device is 0000:00:02.0 PCI quirk: region 4000-407f claimed by ICH4 ACPI/GPIO/TCO PCI quirk: region 4080-40bf claimed by ICH4 GPIO PCI: Firmware left 0000:01:03.0 e100 interrupts enabled, disabling PCI: Firmware left 0000:01:05.0 e100 interrupts enabled, disabling PCI: Transparent bridge - 0000:00:1e.0 PCI: Using IRQ router PIIX/ICH [8086/2440] at 0000:00:1f.0 PCI: setting IRQ 11 as level-triggered PCI: Found IRQ 11 for device 0000:00:1f.3 PCI: Sharing IRQ 11 with 0000:01:02.0 PCI: Ignore bogus resource 6 [0:0] of 0000:00:02.0 PCI: Bridge: 0000:00:1e.0 IO window: 9000-afff MEM window: d4000000-d5ffffff PREFETCH window: 20000000-202fffff PCI: Setting latency timer of device 0000:00:1e.0 to 64 NET: Registered protocol family 2 IP route cache hash table entries: 4096 (order: 2, 16384 bytes) TCP established hash table entries: 16384 (order: 4, 65536 bytes) TCP bind hash table entries: 8192 (order: 3, 32768 bytes) TCP: Hash tables configured (established 16384 bind 8192) TCP reno registered IA-32 Microcode Update Driver: v1.14a Total HugeTLB memory allocated, 0 Installing knfsd (copyright (C) 1996 okir@monad.swb.de). io scheduler noop registered io scheduler anticipatory registered (default) io scheduler deadline registered io scheduler cfq registered Real Time Clock Driver v1.12ac intel_rng: FWH not detected Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing disabled serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A floppy0: no floppy controllers found RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize loop: loaded (max 8 devices) nbd: registered device at major 43 eepro100.c:v1.09j-t 9/29/99 Donald Becker http://www.scyld.com/network/eepro100.html eepro100.c: $Revision: 1.36 $ 2000/11/17 Modified by Andrey V. Savochkin and others PCI: setting IRQ 12 as level-triggered PCI: Found IRQ 12 for device 0000:01:03.0 eth0: OEM i82557/i82558 10/100 Ethernet, 00:50:8D:1C:3C:18, IRQ 12. Board assembly 727095-004, Physical connectors present: RJ45 Primary interface chip i82555 PHY #1. General self-test: passed. Serial sub-system self-test: passed. Internal registers self-test: passed. ROM checksum self-test: passed (0x04f4518b). PCI: setting IRQ 10 as level-triggered PCI: Found IRQ 10 for device 0000:01:05.0 eth1: OEM i82557/i82558 10/100 Ethernet, 00:50:8D:1C:3C:19, IRQ 10. Board assembly 727095-004, Physical connectors present: RJ45 Primary interface chip i82555 PHY #1. General self-test: passed. Serial sub-system self-test: passed. Internal registers self-test: passed. ROM checksum self-test: passed (0x04f4518b). Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx ICH2: IDE controller at PCI slot 0000:00:1f.1 ICH2: chipset revision 5 ICH2: not 100% native mode: will probe irqs later ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:pio ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:pio, hdd:pio Probing IDE interface ide0... hda: IC35L180AVV207-1, ATA DISK drive hda: hw_config=600b hda: hw_config=600b ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 Probing IDE interface ide1... HPT372: IDE controller at PCI slot 0000:01:02.0 PCI: Found IRQ 11 for device 0000:01:02.0 PCI: Sharing IRQ 11 with 0000:00:1f.3 HPT372: chipset revision 5 HPT372: 100% native mode on irq 11 HPT37X: using 33MHz PCI clock ide2: BM-DMA at 0xa000-0xa007, BIOS settings: hde:DMA, hdf:pio ide3: BM-DMA at 0xa008-0xa00f, BIOS settings: hdg:pio, hdh:pio Probing IDE interface ide2... hde: IC35L180AVV207-1, ATA DISK drive hde: hw_config=600b hde: hw_config=600b ide2 at 0x9000-0x9007,0x9402 on irq 11 Probing IDE interface ide3... Probing IDE interface ide1... Probing IDE interface ide3... serio: i8042 KBD port at 0x60,0x64 irq 1 mice: PS/2 mouse device common for all mice input: AT Translated Set 2 keyboard as /class/input/input0 i2c /dev entries driver i810_smbus 0000:00:02.0: i810/i815 i2c device found. md: linear personality registered for level -1 md: raid0 personality registered for level 0 md: raid1 personality registered for level 1 raid6: int32x1 300 MB/s raid6: int32x2 342 MB/s raid6: int32x4 280 MB/s raid6: int32x8 259 MB/s raid6: mmxx1 942 MB/s raid6: mmxx2 1142 MB/s raid6: sse1x1 788 MB/s raid6: sse1x2 1120 MB/s raid6: using algorithm sse1x2 (1120 MB/s) md: raid6 personality registered for level 6 md: raid5 personality registered for level 5 md: raid4 personality registered for level 4 raid5: automatically using best checksumming function: pIII_sse pIII_sse : 2034.400 MB/sec raid5: using function: pIII_sse (2034.400 MB/sec) device-mapper: ioctl: 4.11.0-ioctl (2006-10-12) initialised: dm-devel@redhat.com TCP cubic registered NET: Registered protocol family 1 NET: Registered protocol family 17 Using IPI Shortcut mode Time: tsc clocksource has been installed. Sending DHCP requests ., OK IP-Config: Got DHCP answer from 192.168.0.6, my address is 192.168.0.3 IP-Config: Complete: device=eth0, addr=192.168.0.3, mask=255.255.255.0, gw=192.168.0.1, host=192.168.0.3, domain=mydomain.org, nis-domain=(none), bootserver=192.168.0.6, rootserver=192.168.0.6, rootpath=/!/circle/nest/helix md: Autodetecting RAID arrays. md: autorun ... md: ... autorun DONE. Looking up port of RPC 100003/2 on 192.168.0.6 Looking up port of RPC 100005/1 on 192.168.0.6 VFS: Mounted root (nfs filesystem) readonly. Freeing unused kernel memory: 180k freed Linux agpgart interface v0.101 (c) Dave Jones agpgart: Detected an Intel i815 Chipset. agpgart: AGP aperture is 64M @ 0xd0000000 helix ~ # fdisk /dev/hda Unable to open /dev/hda helix ~ # fdisk /dev/hde Unable to open /dev/hde