Raw file loaded 0x00218000-0x0040235f, assumed entry at 0x00218000 RedBoot> exec Using base address 0x00218000 and length 0x001ea360 Uncompressing Linux................................................................................................................................. done, booting the kernel. ^CLinux version 2.6.21-rt9-ep93xx-m9 (gruberm@grma-linux) (gcc version 4.1.2) #1 PREEMPT RT Tue May 29 19:09:05 CEST 2007 CPU: ARM920T [41129200] revision 0 (ARMv4T), cr=c0007177 Machine: Contec Hypercontrol Micro9-H Memory policy: ECC disabled, Data cache writeback CPU0: D VIVT write-back cache CPU0: I cache: 16384 bytes, associativity 64, 32 byte lines, 8 sets CPU0: D cache: 16384 bytes, associativity 64, 32 byte lines, 8 sets Real-Time Preemption Support (C) 2004-2007 Ingo Molnar Built 1 zonelists. Total pages: 16192 Kernel command line: console=ttyAM1 slram=nvram,0x30000000,0x30100000 root=/dev/nfs nfsroot=192.168.1.223:/export ip=192.168.1.217:192.168.1.223:192.168.1.254:255.255.255.0::eth0: WARNING: experimental RCU implementation. PID hash table entries: 256 (order: 8, 1024 bytes) Console: colour dummy device 80x30 num_possible_cpus(): 1 CPU#0: allocated 2097152 bytes trace buffer. CPU#0: allocated 2097152 bytes max-trace buffer. allocated 2097152 bytes out-trace buffer. tracer: a total of 6291456 bytes allocated. Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) Memory: 32MB 32MB = 64MB total Memory: 54136KB available (3392K code, 794K data, 388K init) Mount-cache hash table entries: 512 CPU: Testing write buffer coherency: ok irq event stamp: 0 hardirqs last enabled at (0): [<00000000>] __init_begin+0x3fff8000/0x30 hardirqs last disabled at (0): [] copy_process+0x344/0x1228 softirqs last enabled at (0): [] copy_process+0x344/0x1228 softirqs last disabled at (0): [<00000000>] __init_begin+0x3fff8000/0x30 BUG: at kernel/sched.c:4303 __schedule() [] (dump_stack+0x0/0x28) from [] (__schedule+0xa24/0xac8) [] (__schedule+0x0/0xac8) from [] (schedule+0xdc/0x128) [] (schedule+0x0/0x128) from [] (kthread+0xcc/0x12c) r4 = C04D4000 [] (kthread+0x0/0x12c) from [] (do_exit+0x0/0x814) r7 = 00000000 r6 = 00000000 r5 = 00000000 r4 = 00000000 --------------------------- | preempt count: 00000000 ] | 0-level deep critical section nesting: ---------------------------------------- NET: Registered protocol family 16 ep93xx: PLL1 running at 400 MHz, PLL2 at 192 MHz ep93xx: FCLK 200 MHz, HCLK 100 MHz, PCLK 50 MHz SCSI subsystem initialized usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 2048 (order: 5, 155648 bytes) TCP bind hash table entries: 2048 (order: 5, 139264 bytes) TCP: Hash tables configured (established 2048 bind 2048) TCP reno registered NetWinder Floating Point Emulator V0.97 (extended precision) JFFS2 version 2.2. (NAND) (C) 2001-2006 Red Hat, Inc. io scheduler noop registered io scheduler deadline registered (default) ep93xx Backlight Driver Initialized. Console: switching to colour frame buffer device 80x30 fb0: Cirrus EP93xx frame buffer device ep93xxfb: framebuffer at 0x5d00000, mapped to 0xffc00000, size 604k ep93xxfb: mode is 640x480x16, linelength=1280 Micro9 Watchdog: Version 0.01 oki_ml9260: remap /dev/can0 memory physical 0x20000000 to virtual 0xc6850000. oki_ml9260: /dev/can0 IRQ-handler installed. oki_ml9260: remap /dev/can1 memory physical 0x21000000 to virtual 0xc6852000. oki_ml9260: /dev/can1 IRQ-handler installed. oki_ml9260: Version: 0.04 registered successfully. Contec Steuerungstechnik und Automation Ges.m.b.H Waldeck 1 / 6330 Kufstein / Austria Serial: AMBA driver $Revision: 1.41 $ apb:uart1: ttyAM0 at MMIO 0x808c0000 (irq = 52) is a AMBA apb:uart2: ttyAM1 at MMIO 0x808d0000 (irq = 54) is a AMBA apb:uart3: ttyAM2 at MMIO 0x808e0000 (irq = 55) is a AMBA ep93xx-pwm ep93xx-pwm: : PWM initalized ep93xx-eth version 0.1 loading eth0: ep93xx on-chip ethernet, IRQ 39, 00:50:c2:40:a0:05. Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx pata_ep93xx pata_ep93xx.0: version 0.3 ata1: PATA max PIO4 cmd 0x00000002 ctl 0x00000019 bmdma 0x00000000 irq 0 ata: polling mode scsi0 : pata_ep93xx ata1: disabling port physmap platform flash device: 04000000 at 10000000 physmap-flash.0: Found 2 x16 devices at 0x0 in 32-bit bank Amd/Fujitsu Extended Query Table at 0x0040 physmap-flash.0: CFI does not contain boot bank location. Assuming top. number of CFI chips: 1 cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness. cmdlinepart partition parsing not available Searching for RedBoot partition table in physmap-flash.0 at offset 0x1fe0000 6 RedBoot partitions found on MTD device physmap-flash.0 Creating 6 MTD partitions on "physmap-flash.0": 0x00000000-0x00040000 : "RedBoot" 0x00040000-0x00240000 : "kernel" 0x00240000-0x00c00000 : "rootfs" 0x00c00000-0x01fe0000 : "savefs" 0x01fe0000-0x01fff000 : "FIS directory" mtd: partition "FIS directory" doesn't end on an erase block -- force read-only 0x01fff000-0x02000000 : "RedBoot config" mtd: partition "RedBoot config" doesn't start on an erase block boundary -- force read-only ep93xx-spi ep93xx-spi.1: : SPI Controller initalized ep93xx-ohci ep93xx-ohci: EP93xx OHCI ep93xx-ohci ep93xx-ohci: new USB bus registered, assigned bus number 1 ep93xx-ohci ep93xx-ohci: irq 56, io mem 0x80020000 usb usb1: configuration #1 chosen from 1 choice hub 1-0:1.0: USB hub found hub 1-0:1.0: 3 ports detected Initializing USB Mass Storage driver... usb 1-3: new low speed USB device using ep93xx-ohci and address 2 usb 1-3: configuration #1 chosen from 1 choice usbcore: registered new interface driver usb-storage USB Mass Storage support registered. input: NOVATEK USB Keyboard as /class/input/input0 input: USB HID v1.10 Keyboard [NOVATEK USB Keyboard] on usb-ep93xx-3 input: NOVATEK USB Keyboard as /class/input/input1 input: USB HID v1.10 Device [NOVATEK USB Keyboard] on usb-ep93xx-3 usbcore: registered new interface driver usbhid drivers/usb/input/hid-core.c: v2.6:USB HID core driver usbcore: registered new interface driver usbserial drivers/usb/serial/usb-serial.c: USB Serial Driver core drivers/usb/serial/usb-serial.c: USB Serial support registered for FTDI USB Serial Device usbcore: registered new interface driver ftdi_sio drivers/usb/serial/ftdi_sio.c: v1.4.3:USB FTDI Serial Converters Driver mice: PS/2 mouse device common for all mice input: ep93xx-8x8-keyboard as /class/input/input2 ep93xx: ep93xx-8x8-keyboard init done input: LS7366R left/right keyboard as /class/input/input3 input: Cirrus EP93xx touchscreen as /class/input/input4 i2c /dev entries driver ds1307 0-0068: rtc core: registered ds1307 as rtc0 Micro9 24C32 I2C eeprom: detected Micro9 24C32 I2C eeprom: eth0 MAC address 0x00:0x50:0xc2:0x40:0xa0:0x05 Registered led device: ep93xx:green Registered led device: ep93xx:red Advanced Linux Sound Architecture Driver Version 1.0.14rc3 (Wed Mar 14 07:25:50 2007 UTC). ep93xx-ac97: resetting ac97 controller ep93xx-ac97: resetting bus.. done (10) ep93xx-ac97: waiting for codec ready.. ready (43) ep93xx-ac97: waiting for codec to settle.. settled (0) ALSA device list: #0: ep93xx-ac97 (Cirrus Logic CS4202 rev 3) TCP cubic registered NET: Registered protocol family 1 NET: Registered protocol family 10 NET: Registered protocol family 17 NET: Registered protocol family 15 ep93xx-io ep93xx-io: IO init ep93xx-io ep93xx-io: KEYMATRIX found, hole Port C and D not possible ep93xx-io ep93xx-io: PATA driver found, hole Port E,G and H not possible ep93xx-io ep93xx-io: IO initalized ds1307 0-0068: setting the system clock to 2000-01-01 00:04:41 (946685081) IP-Config: Complete: device=eth0, addr=192.168.1.217, mask=255.255.255.0, gw=192.168.1.254, host=192.168.1.217, domain=, nis-domain=(none), bootserver=192.168.1.223, rootserver=192.168.1.223, rootpath= Looking up port of RPC 100003/2 on 192.168.1.223 Looking up port of RPC 100005/1 on 192.168.1.223 VFS: Mounted root (nfs filesystem). ***************************************************************************** * * * REMINDER, the following debugging options are turned on in your .config: * * * * CONFIG_DEBUG_RT_MUTEXES * * CONFIG_CRITICAL_PREEMPT_TIMING * * CONFIG_CRITICAL_IRQSOFF_TIMING * * CONFIG_FUNCTION_TRACE * * CONFIG_DEBUG_SLAB * * * * they may increase runtime overhead and latencies. * * * *******************************************************************