LZMA loader for ADM5120, Copyright (C) 2007 OpenWrt.org decompressing kernel... done! launching kernel... Linux version 2.6.21.1 (yuhi@idared) (gcc version 4.1.2) #16 Sat Jun 2 17:38:53 CEST 2007 ADM5120 revision 8, running at 175MHz Boot loader is: CFE Booted from : NOR flash Board is : ZyXEL Prestige 334WT GETENV: envname is memsize GETENV: returning 0x001000000 CPU revision is: 0001800b ADM5120 board setup Determined physical RAM map: memory: 00c67000 @ 00399000 (usable) Wasting 29472 bytes for tracking 921 unused pages Initrd not found or empty - disabling initrd Built 1 zonelists. Total pages: 4064 Kernel command line: console=ttyS0,115200 rootfs=jffs2,squashfs init=/etc/preinit Primary instruction cache 8kB, physically tagged, 2-way, linesize 16 bytes. Primary data cache 8kB, 2-way, linesize 16 bytes. Synthesized TLB refill handler (20 instructions). Synthesized TLB load handler fastpath (32 instructions). Synthesized TLB store handler fastpath (32 instructions). Synthesized TLB modify handler fastpath (31 instructions). PID hash table entries: 64 (order: 6, 256 bytes) Using 87.500 MHz high precision timer. Dentry cache hash table entries: 2048 (order: 1, 8192 bytes) Inode-cache hash table entries: 1024 (order: 0, 4096 bytes) Memory: 12552k/12700k available (2030k kernel code, 148k reserved, 310k data, 1232k i nit, 0k highmem) Mount-cache hash table entries: 512 NET: Registered protocol family 16 adm5120: system has PCI BIOS registering PCI controller with io_map_base unset usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb PCI: fixing up ADM5120 header PCI: mapping irq for device 0000:00:02.0, slot:2, pin:1, irq:15 Time: MIPS clocksource has been installed. NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 512 (order: 0, 4096 bytes) TCP bind hash table entries: 512 (order: -1, 2048 bytes) TCP: Hash tables configured (established 512 bind 512) TCP reno registered squashfs: version 3.0 (2006/03/15) Phillip Lougher Registering mini_fo version $Id$ io scheduler noop registered io scheduler deadline registered (default) Registered led device: adm5120:led ttyS0 at I/O 0x12600000 (irq = 9) is a ADM5120 ttyS1 at I/O 0x12800000 (irq = 10) is a ADM5120 eth0: ADM5120 switch port0 eth1: ADM5120 switch port1 eth2: ADM5120 switch port2 eth3: ADM5120 switch port3 eth4: ADM5120 switch port4 nf_conntrack version 0.5.0 (99 buckets, 792 max) ip_tables: (C) 2000-2006 Netfilter Core Team TCP vegas registered NET: Registered protocol family 1 NET: Registered protocol family 17 NET: Registered protocol family 15 Bridge firewalling registered 802.1Q VLAN Support v1.8 Ben Greear All bugs added by David S. Miller Freeing unused kernel memory: 1232k freed Warning: unable to open an initial console. Algorithmics/MIPS FPU Emulator v1.5 device eth0 entered promiscuous mode br-lan: port 1(eth0) entering learning state br-lan: topology change detected, propagating br-lan: port 1(eth0) entering forwarding state PPP generic driver version 2.4.2 acx: this driver is still EXPERIMENTAL acx: reading README file and/or Craig's HOWTO is recommended, visit http://acx100.sf. net in case of further questions/discussion acx: compiled to use 32bit I/O access. I/O timing issues might occur, such as non-wor king firmware upload. Report them acx: running on a BIG-ENDIAN CPU acx: PCI module v0.3.36 initialized, waiting for cards to probe... PCI: Enabling device 0000:00:02.0 (0000 -> 0002) acx: found ACX111-based wireless network card at 0000:00:02.0, irq:15, phymem1:0x1142 0000, phymem2:0x11400000, mem1:0xb1420000, mem1_size:8192, mem2:0xb1400000, mem2_size :131072 initial debug setting is 0x000A using IRQ 15 acx: need to load firmware for acx111 chipset with radio ID 16, please provide via fi rmware hotplug: acx: either one file only (ombined firmware image file, radio-specific) or two fil es (radio-less base image file *plus* separate adio-specific extension file) requesting firmware image 'tiacx111c16' acx: firmware image 'tiacx111c16' was not provided. Check your hotplug scripts requesting firmware image 'tiacx111' acx: firmware image 'tiacx111' was not provided. Check your hotplug scripts acx: reset_dev() FAILED acx_pci: probe of 0000:00:02.0 failed with error -5 init started: BusyBox v1.4.2 (2007-05-24 16:50:23 CEST) multi-call binary Please press Enter to activate this console. BusyBox v1.4.2 (2007-05-24 16:50:23 CEST) Built-in shell (ash) Enter 'help' for a list of built-in commands. _______ ________ __ | |.-----.-----.-----.| | | |.----.| |_ | - || _ | -__| || | | || _|| _| |_______|| __|_____|__|__||________||__| |____| |__| W I R E L E S S F R E E D O M KAMIKAZE (bleeding edge, r7445) ------------------- * 10 oz Vodka Shake well with ice and strain * 10 oz Triple sec mixture into 10 shot glasses. * 10 oz lime juice Salute! --------------------------------------------------- root@OpenWrt:/#