Linux version 2.6.20-ubuntu1-ictivity2 (hp@lisa) (gcc version 4.1.2 (Ubuntu 4.1.2-0ubuntu4)) #7 SMP Tue May 22 15:21:38 CEST 2007 (Ictivity ZENworks 2.6.20) BIOS-provided physical RAM map: sanitize start sanitize end copy_e820_map() start: 0000000000000000 size: 000000000009fc00 end: 000000000009fc00 type: 1 copy_e820_map() type is E820_RAM copy_e820_map() start: 000000000009fc00 size: 0000000000000400 end: 00000000000a0000 type: 2 copy_e820_map() start: 00000000000e0000 size: 0000000000020000 end: 0000000000100000 type: 2 copy_e820_map() start: 0000000000100000 size: 000000001f6f0000 end: 000000001f7f0000 type: 1 copy_e820_map() type is E820_RAM copy_e820_map() start: 000000001f7f0000 size: 0000000000810000 end: 0000000020000000 type: 2 copy_e820_map() start: 00000000fec00000 size: 0000000001400000 end: 0000000100000000 type: 2 BIOS-e820: 0000000000000000 - 000000000009fc00 (usable) BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved) BIOS-e820: 00000000000e0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 000000001f7f0000 (usable) BIOS-e820: 000000001f7f0000 - 0000000020000000 (reserved) BIOS-e820: 00000000fec00000 - 0000000100000000 (reserved) 0MB HIGHMEM available. 503MB LOWMEM available. found SMP MP-table at 000faa60 initrd extends beyond end of memory (0x1f7ffcaf > 0x1f7f0000) disabling initrd Zone PFN ranges: DMA 0 -> 4096 Normal 4096 -> 129008 HighMem 129008 -> 129008 early_node_map[1] active PFN ranges 0: 0 -> 129008 DMI 2.3 present. ACPI: PM-Timer IO Port: 0xf808 ACPI: LAPIC (acpi_id[0x01] lapic_id[0x00] enabled) Processor #0 15:2 APIC version 20 ACPI: LAPIC (acpi_id[0x02] lapic_id[0x01] disabled) ACPI: LAPIC_NMI (acpi_id[0x01] high edge lint[0x1]) ACPI: LAPIC_NMI (acpi_id[0x02] high edge lint[0x1]) Using ACPI for processor (LAPIC) configuration information Intel MultiProcessor Specification v1.4 Virtual Wire compatibility mode. OEM ID: COMPAQ Product ID: APIC at: 0xFEE00000 I/O APIC #1 Version 17 at 0xFEC00000. Enabling APIC mode: Flat. Using 1 I/O APICs Processors: 1 Allocating PCI resources starting at 30000000 (gap: 20000000:dec00000) Detected 2793.054 MHz processor. Built 1 zonelists. Total pages: 128001 Kernel command line: initrd=boot/initrd vga=normal install=tftp://10.112.2.2/boot rootimage=/root PROXYADDR=10.112.2.2 TFTPIP=10.112.2.2 splash=no PXEBOOT=YES mode=5 pci=noacpi irqpoll console=tty0 console=ttyS0,9600n8 Misrouted IRQ fixup and polling support enabled This may significantly impact system performance Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Initializing CPU#0 PID hash table entries: 2048 (order: 11, 8192 bytes) Console: colour VGA+ 80x25 Dentry cache hash table entries: 65536 (order: 6, 262144 bytes) Inode-cache hash table entries: 32768 (order: 5, 131072 bytes) Memory: 508352k/516032k available (1552k kernel code, 7224k reserved, 599k data, 296k init, 0k highmem) virtual kernel memory layout: fixmap : 0xfff4e000 - 0xfffff000 ( 708 kB) pkmap : 0xff800000 - 0xffc00000 (4096 kB) vmalloc : 0xe0000000 - 0xff7fe000 ( 503 MB) lowmem : 0xc0000000 - 0xdf7f0000 ( 503 MB) .init : 0xc031f000 - 0xc0369000 ( 296 kB) .data : 0xc0284001 - 0xc0319c14 ( 599 kB) .text : 0xc0100000 - 0xc0284001 (1552 kB) Checking if this processor honours the WP bit even in supervisor mode... Ok. Calibrating delay using timer specific routine.. 5626.31 BogoMIPS (lpj=11252624) Mount-cache hash table entries: 512 CPU: Trace cache: 12K uops, L1 D cache: 8K CPU: L2 cache: 512K CPU: Hyper-Threading is disabled Checking 'hlt' instruction... OK. SMP alternatives: switching to UP code Freeing SMP alternatives: 11k freed ACPI: Core revision 20060707 ACPI: setting ELCR to 0e20 (from 0c20) CPU0: Intel(R) Pentium(R) 4 CPU 2.80GHz stepping 09 Total of 1 processors activated (5626.31 BogoMIPS). ENABLING IO-APIC IRQs ..TIMER: vector=0x31 apic1=-1 pin1=-1 apic2=-1 pin2=-1 ...trying to set up timer (IRQ0) through the 8259A ... failed. ...trying to set up timer as Virtual Wire IRQ... works. Brought up 1 CPUs Time: 10:25:42 Date: 05/13/107 NET: Registered protocol family 16 EISA bus registered ACPI: bus type pci registered PCI: PCI BIOS revision 2.20 entry at 0xec5a9, last bus=5 PCI: Using configuration type 1 Setting up standard PCI resources ACPI: Interpreter enabled ACPI: Using PIC for interrupt routing Linux Plug and Play Support v0.97 (c) Adam Belay pnp: PnP ACPI init pnp: PnP ACPI: found 14 devices PnPBIOS: Disabled by ACPI PNP usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb PCI: Probing PCI hardware ACPI: Assume root bridge [\_SB_.PCI0] bus is 0 PCI: Enabled i801 SMBus device PCI quirk: region f800-f87f claimed by ICH4 ACPI/GPIO/TCO PCI quirk: region fa00-fa3f claimed by ICH4 GPIO PCI: Transparent bridge - 0000:00:1e.0 PCI: Using IRQ router PIIX/ICH [8086/24d0] at 0000:00:1f.0 PCI->APIC IRQ transform: 0000:00:02.0[A] -> IRQ 16 PCI->APIC IRQ transform: 0000:00:1d.0[A] -> IRQ 16 PCI->APIC IRQ transform: 0000:00:1d.1[B] -> IRQ 19 PCI->APIC IRQ transform: 0000:00:1d.2[C] -> IRQ 18 PCI->APIC IRQ transform: 0000:00:1d.7[D] -> IRQ 23 PCI->APIC IRQ transform: 0000:00:1f.1[A] -> IRQ 18 PCI->APIC IRQ transform: 0000:00:1f.2[A] -> IRQ 18 PCI->APIC IRQ transform: 0000:00:1f.3[B] -> IRQ 17 PCI->APIC IRQ transform: 0000:00:1f.5[B] -> IRQ 17 PCI->APIC IRQ transform: 0000:05:02.0[A] -> IRQ 20 pnp: 00:0b: ioport range 0x4d0-0x4d1 has been reserved pnp: 00:0c: ioport range 0x400-0x41f has been reserved pnp: 00:0c: ioport range 0x420-0x43f has been reserved pnp: 00:0c: ioport range 0x440-0x45f has been reserved pnp: 00:0c: ioport range 0x460-0x47f could not be reserved pnp: 00:0c: ioport range 0xf800-0xf81f could not be reserved pnp: 00:0c: ioport range 0xf820-0xf83f could not be reserved pnp: 00:0c: ioport range 0xf840-0xf85f has been reserved pnp: 00:0c: ioport range 0xf860-0xf87f has been reserved PCI: Ignore bogus resource 6 [0:0] of 0000:00:02.0 PCI: Bridge: 0000:00:1e.0 IO window: disabled. MEM window: fc500000-fc7fffff PREFETCH window: disabled. NET: Registered protocol family 2 IP route cache hash table entries: 4096 (order: 2, 16384 bytes) TCP established hash table entries: 16384 (order: 5, 131072 bytes) TCP bind hash table entries: 8192 (order: 4, 65536 bytes) TCP: Hash tables configured (established 16384 bind 8192) TCP reno registered audit: initializing netlink socket (disabled) audit(1181730337.788:1): initialized io scheduler noop registered io scheduler anticipatory registered io scheduler deadline registered io scheduler cfq registered (default) isapnp: Scanning for PnP cards... isapnp: No Plug & Play device found Real Time Clock Driver v1.12ac Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing enabled serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A serial8250: ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A 00:08: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A mice: PS/2 mouse device common for all mice RAMDISK driver initialized: 16 RAM disks of 100000K size 1024 blocksize Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx ehci_hcd 0000:00:1d.7: EHCI Host Controller ehci_hcd 0000:00:1d.7: new USB bus registered, assigned bus number 1 ehci_hcd 0000:00:1d.7: debug port 1 ehci_hcd 0000:00:1d.7: irq 23, io mem 0xfc480000 ehci_hcd 0000:00:1d.7: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004 usb usb1: configuration #1 chosen from 1 choice hub 1-0:1.0: USB hub found hub 1-0:1.0: 8 ports detected hub 1-0:1.0: over-current change on port 7 USB Universal Host Controller Interface driver v3.0 uhci_hcd 0000:00:1d.0: UHCI Host Controller uhci_hcd 0000:00:1d.0: new USB bus registered, assigned bus number 2 uhci_hcd 0000:00:1d.0: irq 16, io base 0x00001440 usb usb2: configuration #1 chosen from 1 choice hub 2-0:1.0: USB hub found hub 2-0:1.0: 2 ports detected uhci_hcd 0000:00:1d.1: UHCI Host Controller uhci_hcd 0000:00:1d.1: new USB bus registered, assigned bus number 3 uhci_hcd 0000:00:1d.1: irq 19, io base 0x00001460 usb usb3: configuration #1 chosen from 1 choice hub 3-0:1.0: USB hub found hub 3-0:1.0: 2 ports detected uhci_hcd 0000:00:1d.2: UHCI Host Controller uhci_hcd 0000:00:1d.2: new USB bus registered, assigned bus number 4 uhci_hcd 0000:00:1d.2: irq 18, io base 0x00001480 usb usb4: configuration #1 chosen from 1 choice hub 4-0:1.0: USB hub found hub 4-0:1.0: 2 ports detected sl811: driver sl811-hcd, 19 May 2005 usbcore: registered new interface driver hiddev usbcore: registered new interface driver usbhid drivers/usb/input/hid-core.c: v2.6:USB HID core driver PNP: PS/2 Controller [PNP0303:KBD,PNP0f0e:PS2M] at 0x60,0x64 irq 1,12 serio: i8042 KBD port at 0x60,0x64 irq 1 serio: i8042 AUX port at 0x60,0x64 irq 12 EISA: Probing bus 0 at eisa.0 Cannot allocate resource for EISA slot 1 EISA: Detected 0 cards. TCP cubic registered NET: Registered protocol family 1 Using IPI Shortcut mode Magic number: 11:409:426 Time: tsc clocksource has been installed. input: AT Translated Set 2 keyboard as /class/input/input0 VFS: Cannot open root device "" or unknown-block(8,6) Please append a correct "root=" boot option Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(8,6)