[    7.729505] Zaptel Version: 1.4.3
[    7.729508] Zaptel Echo Canceller: MG2
[    7.738320] Linux agpgart interface v0.102 (c) Dave Jones
[    7.748006] piix4_smbus 0000:00:0f.0: Found 0000:00:0f.0 device
[    7.792067] pnp: Device 00:0b activated.
[    7.792076] parport: PnPBIOS parport detected.
[    7.792135] parport0: PC-style at 0x378, irq 7 [PCSPP]
[    7.843126] NET: Registered protocol family 10
[    7.843338] lo: Disabled Privacy Extensions
[    8.139195] ACPI: PCI Interrupt 0000:00:0c.0[A] -> GSI 27 (level, low) -> IRQ 18
[    8.139230] Found TE4XXP at base address fe9fdc00, remapped to f88a4c00
[    8.139244] TE4XXP version c01a0164, burst OFF, slip debug: OFF
[    8.139660] FALC version: 00000005, Board ID: 00
[    8.139666] Reg 0: 0x1fe23400
[    8.139669] Reg 1: 0x1fe23000
[    8.139672] Reg 2: 0xffffffff
[    8.139675] Reg 3: 0x00000000
[    8.139678] Reg 4: 0x0000ff00
[    8.139681] Reg 5: 0x00000000
[    8.139685] Reg 6: 0xc01a0164
[    8.139688] Reg 7: 0x00001000
[    8.139691] Reg 8: 0x00000000
[    8.139694] Reg 9: 0x00ff00ff
[    8.139698] Reg 10: 0x0000004a
[    8.139798] TE4XXP: Launching card: 0
[    8.139802] TE4XXP: Setting up global serial parameters
[    8.142532] Found a Wildcard: Wildcard TE405P (2nd Gen)
[    8.283118] About to enter spanconfig!
[    8.283125] Done with spanconfig!
[    8.297987] Registered tone zone 0 (United States / North America)
[    8.297996] About to enter startup!
[    8.298067] TE4XXP: Span 1 configured for ESF/B8ZS
[    8.298091] wct4xxp: Setting yellow alarm on span 1
[    8.298103] timing source auto card 0!
[    8.298177] SPAN 1: Primary Sync Source
[    8.311013] timing source auto card 0!
[    8.311590] VPM400: Span 0 U-law mode
[    8.331685] VPM: DTMF threshold set to 1000
[    8.332089] VPM400: Span 1 U-law mode
[    8.351637] VPM: DTMF threshold set to 1000
[    8.352036] VPM400: Span 2 U-law mode
[    8.371593] VPM: DTMF threshold set to 1000
[    8.371991] VPM400: Span 3 U-law mode
[    8.391548] VPM: DTMF threshold set to 1000
[    8.411504] VPM: DTMF threshold set to 1000
[    8.431460] VPM: DTMF threshold set to 1000
[    8.451415] VPM: DTMF threshold set to 1000
[    8.471371] VPM: DTMF threshold set to 1000
[    8.471636] VPM400: hardware DTMF enabled.
[    8.471638] VPM400: Present and operational servicing 4 span(s)
[    8.471641] Completed startup!
[    8.686022] lp0: using parport0 (interrupt-driven).
[    8.868269] Adding 2433808k swap on /dev/disk/by-uuid/96a45d0a-72c9-4c7f-9647-54adc96b784b.  Priority:-1 extents:1 across:2433808k
[    9.040016] EXT3 FS on sda1, internal journal
[   11.016298] About to enter spanconfig!
[   11.016311] About to enter startup!
[   11.016394] TE4XXP: Span 1 configured for ESF/B8ZS
[   11.016482] SPAN 1: Primary Sync Source
[   11.016486] Completed startup!
[   11.016790] Registered tone zone 0 (United States / North America)
[   11.016854] timing source auto card 0!
[   11.028812] timing source auto card 0!
[   16.017039] wct4xxp: Clearing yellow alarm on span 1
[   18.440516] eth1: no IPv6 routers present
[  206.724934] About to enter spanconfig!
[  206.724946] About to enter startup!
[  206.725028] TE4XXP: Span 1 configured for ESF/B8ZS
[  206.725053] wct4xxp: Setting yellow alarm on span 1
[  206.725156] SPAN 1: Primary Sync Source
[  206.725160] Completed startup!
[  206.725660] timing source auto card 0!
[  206.726929] Registered tone zone 0 (United States / North America)
[  206.736574] timing source auto card 0!
[  211.724803] wct4xxp: Clearing yellow alarm on span 1