bk@realhost-x2200m2-1:~$ dmesg | grep eth
forcedeth.c: Reverse Engineered nForce ethernet driver. Version 0.56.
forcedeth: using HIGHDMA
eth0: forcedeth.c: subsystem: 0108e:534b bound to 0000:00:08.0
forcedeth: using HIGHDMA
eth1: forcedeth.c: subsystem: 0108e:534b bound to 0000:00:09.0
eth2: Tigon3 [partno(BCM95715) rev 9003 PHY(5714)] (PCIX:133MHz:64-bit) 10/100/1000BaseT Ethernet 00:16:36:d2:ef:de
eth2: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] Split[0] WireSpeed[1] TSOcap[1]
eth2: dma_rwctrl[76148000] dma_mask[40-bit]
eth3: Tigon3 [partno(BCM95715) rev 9003 PHY(5714)] (PCIX:133MHz:64-bit) 10/100/1000BaseT Ethernet 00:16:36:d2:ef:df
eth3: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[1] Split[0] WireSpeed[1] TSOcap[1]
eth3: dma_rwctrl[76148000] dma_mask[40-bit]
device eth5 entered promiscuous mode
audit(1182336703.790:2): dev=eth5 prom=256 old_prom=0 auid=4294967295
tg3: eth5: Link is up at 100 Mbps, full duplex.
tg3: eth5: Flow control is off for TX and off for RX.
bridge-eth5: enabling the bridge
bridge-eth5: up
bridge-eth5: already up
bridge-eth5: attached
bridge-eth5: enabled promiscuous mode
bridge-eth5: disabled promiscuous mode
bridge-eth5: enabled promiscuous mode
bridge-eth5: disabled promiscuous mode
bridge-eth5: enabled promiscuous mode