wodim: No write mode specified.
wodim: Asuming -tao mode.
wodim: Future versions of wodim may have different drive dependent defaults.
wodim: Operation not permitted. Warning: Cannot raise RLIMIT_MEMLOCK limits.scsidev: '/dev/hdc'
devname: '/dev/hdc'
scsibus: -2 target: -2 lun: -2
Linux sg driver version: 3.5.27
Wodim version: 1.1.2
SCSI buffer size: 64512
Beginning DMA speed test. Set CDR_NODMATEST environment variable if device
communication breaks or freezes immediately after that.
TOC Type: 3 = CD-ROM XA mode 2
Driveropts: 'burnfree'
atapi: 1
Device type    : Removable CD-ROM
Version        : 0
Response Format: 2
Capabilities   : 
Vendor_info    : 'HL-DT-ST'
Identification : 'DVD+-RW GSA-T11N'
Revision       : 'A103'
Device seems to be: Generic mmc2 DVD-R/DVD-RW.
Current: 0x0009 (CD-R)
Profile: 0x0011 (DVD-R sequential recording) 
Profile: 0x0014 (DVD-RW sequential recording) 
Profile: 0x0013 (DVD-RW restricted overwrite) 
Profile: 0x001A (DVD+RW) 
Profile: 0x001B (DVD+R) 
Profile: 0x002B (DVD+R/DL) 
Profile: 0x0010 (DVD-ROM) 
Profile: 0x0009 (CD-R) (current)
Profile: 0x000A (CD-RW) 
Profile: 0x0008 (CD-ROM) 
Using generic SCSI-3/mmc   CD-R/CD-RW driver (mmc_cdr).
Driver flags   : MMC-3 SWABAUDIO BURNFREE 
Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R
Drive buf size : 1053696 = 1029 KB
Drive DMA Speed: 1154 kB/s 6x CD 0x DVD
FIFO size      : 12582912 = 12288 KB
Speed set to 4234 KB/s
wodim: DMA speed too slow (OK for 5x). Cannot write at speed 24x.
   0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
Performing OPC...
Starting new track at sector: 0
Writing  time:  974.492s
Average write speed   4.9x.
Min drive buffer fill was 7%
Fixating...
Fixating time:   22.947s