# $Id: iaxmodem,v 1.5 2006/12/27 03:56:35 faxguy Exp $

#
# prototype config for the IAXmodem softmodem which uses
# the spandsp soft-DSP library
#

#
CountryCode:            1
AreaCode:               512
FAXNumber:              +1.512.874.7610
LongDistancePrefix:     1
InternationalPrefix:    011
DialStringRules:        etc/dialrules
ServerTracing:          1
SessionTracing:         0xFFF
RecvFileMode:           0600
LogFileMode:            0600
DeviceMode:             0600
RingsBeforeAnswer:      1
SpeakerVolume:          off
GettyArgs:              "-h %l dx_%s"
LocalIdentifier:        CatalisInc
TagLineFont:            etc/lutRS18.pcf
TagLineFormat:          "From %%l|%c|Page %%P of %%T"
MaxRecvPages:           25
FaxRcvdCmd:             bin/faxrcvd.local
#

#
#
# Modem-related stuff: should reflect modem command interface
# and hardware connection/cabling (e.g. flow control).
#
ModemType:              Class1          # use this to supply a hint

#
#             *** Caller-ID settings ***
#
# Enabling this will use the hfaxd-protocol to set Caller*ID
#
#ModemSetOriginCmd:     AT+VSID="%s","%d"
#
# If "glare" during initialization becomes a problem then take
# the modem off-hook during initialization, and then place it
# back on-hook when done.
#
#ModemResetCmds:        "ATH1\nAT+VCID=1"       # enables CallID display
#ModemReadyCmds:        ATH0
#
# You'll likely want Caller*ID display (also displays DID) enabled.
#
ModemResetCmds:         AT+VCID=1       # enables CallID display
#
# If you are "missing" Caller*ID data on some calls (but not all)
# and if you do not have adequate glare protection you may want to
# not answer based on RINGs, but rather enable the CallIDAnswerLength
# for NDID, disable AT+VCID=1 and do this:
#
#RingsBeforeAnswer: 0
#ModemRingResponse: AT+VRID=1

# The pty apparently does not support changing parity.
PagerTTYParity:         none

Class1AdaptRecvCmd:     AT+FAR=1
Class1TMConnectDelay:   400             # counteract quick CONNECT response
Class1RMQueryCmd:       "!24,48,72,96"  # V.17 fast-train recv doesn't work well

CallIDPattern:          "NMBR="
CallIDPattern:          "NAME="
CallIDPattern:          "ANID="
CallIDPattern:          "NDID="
#CallIDAnswerLength:    4
# Uncomment these if you really want them, but you probably don't.
#CallIDPattern:          "DATE="
#CallIDPattern:          "TIME="