# cat /etc/zaptel.conf |grep -v ^#
span=1,0,0,esf,b8zs
loadzone = us
defaultzone=us

bchan=1-23
dchan=24

# cat /etc/asterisk/zapata.conf |grep -v ^#
[trunkgroups]

[channels]
switchtype=national
context=from-ctc
signalling=pri_cpe
prilocaldialplan=local
group=1
channel => 1-23

*CLI> zap show status
Description                              Alarms     IRQ        bpviol     CRC4  
wanpipe1 card 0                          OK         0          0          0     

Error CLEC SENT ME:

L1745690CP1#

Jun 13 17:16:17.040: ISDN Se1:23 Q931: RX <- SETUP pd = 8  callref = 0x0002

        Bearer Capability i = 0x8090A3

                Standard = CCITT

                Transfer Capability = Speech

                Transfer Mode = Circuit

                Transfer Rate = 64 kbit/s

        Channel ID i = 0xA98381

                Exclusive, Channel 1

        Progress Ind i = 0x8083 - Origination address is non-ISDN       <<<<

        Calling Party Number i = 0x00C3, N/A

                Plan:Unknown, Type:Unknown

        Called Party Number i = 0xA1, '18004444444'

                Plan:ISDN, Type:National

Jun 13 17:16:17.088: ISDN Se1:23 Q931: TX -> RELEASE_COMP pd = 8  callref = 0x80

02

        Cause i = 0x82E4 - Invalid information element contents           <<<<<THIS IS THE ERROR MESSAGE  

L1745690CP1#

------------------------

# wanrouter status

Devices currently active:
        wanpipe1


Wanpipe Config:

Device name | Protocol Map | Adapter  | IRQ | Slot/IO | If's | CLK | Baud rate |
wanpipe1    | N/A          | A101/2   | 21  | 2       | 1    | EXT | 0         |

Wanrouter Status:

Device name | Protocol | Station | Status        |
wanpipe1    | AFT HDLC | N/A     | Connected     |