I'm trying to finish the Ch04: Commands and Concepts assignment using Linux because I already have vmware-server installed on my system. I'm not particularly sure where the Default Gateway is. This is the output I get from ifconfig vmnet1

vmnet1    Link encap:Ethernet  HWaddr 00:50:56:C0:00:01  
          inet addr:192.168.149.1  Bcast:192.168.149.255  Mask:255.255.255.0
          inet6 addr: fe80::250:56ff:fec0:1/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:25 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)

this is the output of route
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
192.168.149.0   *               255.255.255.0   U     0      0        0 vmnet1
172.16.42.0     *               255.255.255.0   U     0      0        0 vmnet8
138.247.244.0   *               255.255.252.0   U     0      0        0 eth1
link-local      *               255.255.0.0     U     0      0        0 eth0
link-local      *               255.255.0.0     U     1000   0        0 eth1
default         138.247.244.1   0.0.0.0         UG    0      0        0 eth1
default         *               0.0.0.0         U     1000   0        0 eth0


The IP Address and Subnet Mask is obvious to me, but the Default Gateway is escaping me.

Anybody happen to know what I'm missing? or is that *.*.*.0 address my answer?