/****************************************************************************
**
** Copyright (C) 2000-2006 TROLLTECH ASA. All rights reserved.
**
** This file is part of the Phone Edition of the Qtopia Toolkit.
**
** This software is licensed under the terms of the GNU General Public
** License (GPL) version 2.
**
** See http://www.trolltech.com/gpl/ for GPL licensing information.
**
** Contact info@trolltech.com if any conditions of this licensing are
** not clear to you.
**
**
**
** This file is provided AS IS with NO WARRANTY OF ANY KIND, INCLUDING THE
** WARRANTY OF DESIGN, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
**
****************************************************************************/

#ifndef QT_QWS_HTCPHONE
#define QT_QWS_HTCPHONE
#endif

#if defined(__GNUC__) && (__GNUC__ > 2)
#define QPE_USE_MALLOC_FOR_NEW
#endif

#define QPE_DEFAULT_TODAY_MODE "Daily"

#define QPE_NEED_CALIBRATION

#define QPE_ARCHITECTURE "HTC Mobile Phone"

// The serial device for AT command access to the phone
// hardware:
//
#define QTOPIA_PHONE_DEVICE "/dev/ttyS0"
//
// The baud rate for the serial connection:
//
#define QTOPIA_PHONE_RATE 115200

// Sets the phone vendor plugin to load (normally all plugins are loaded).
// #define QTOPIA_PRELOAD_PHONE_PLUGIN "htcphone"

// Define this to use the "advanced" GSM 07.10 CMUX mode instead of "basic".
//#define QTOPIA_ADVANCED_CMUX

// Define these to use direct serial ports for multiplexing channels.
// The primary AT command channel is defined by "QTOPIA_PHONE_DEVICE".
// Channels may be omitted if they aren't appropriate.

// Define this if setup commands for GPRS data sessions should be sent
// on the primary command channel instead of the data channel.
#define QTOPIA_MUX_DATA_SETUP_ON_COMMAND_CHANNEL
#define QTOPIA_MUX_DATA_DEVICE "/dev/ttyS8"

// Define this if setup commands for GPRS data sessions should be sent
// on the primary command channel instead of the data channel.
#define QTOPIA_MUX_DATA_SETUP_ON_COMMAND_CHANNEL

#define QTOPIA_ENABLE_EXPORTED_BACKGROUNDS
#define QTOPIA_ENABLE_GLOBAL_BACKGROUNDS

// Disable media player visualization
#define NO_VISUALIZATION

// Start Synchronization daemons for TCP and Serial comms by default.
#define QDSYNC_DEFAULT_PORTS QStringList() << "tcp" << "serial"
// Specify the location of the serial port
#define QDSYNC_DEFAULT_SERIAL_PORT "/dev/ttyUSB0"
// Specify the time to delay the first Synchronization instance from running
#define QDSYNC_STARTUP_DELAY 30000 // 30 seconds
// Specify the device name to report
#define QDSYNC_MODEL "Greenphone"

#define V4L_VIDEO_DEVICE "/dev/video"