wmaster0: Selected rate control algorithm 'simple'
rt61pci->rt61pci_init_firmware_cont: Error - Failed to load Firmware.
Linux Tulip driver version 1.1.13-NAPI (May 11, 2002)
ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 11
ACPI: PCI Interrupt 0000:01:0d.0[A] -> Link [LNKB] -> GSI 11 (level, low) -> IRQ 11
tulip0:  MII transceiver #1 config 3000 status 7829 advertising 01e1.
eth0: Lite-On 82c168 PNIC rev 32 at c4904000, 00:A0:CC:58:AA:3C, IRQ 11.
input: PC Speaker as /class/input/input2
parport: PnPBIOS parport detected.
parport0: PC-style at 0x378 (0x778), irq 7, dma 3 [PCSPP,TRISTATE,COMPAT,ECP,DMA]
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
eth0: Setting full-duplex based on MII#1 link partner capability of 45e1.
eth0: no IPv6 routers present
usb 1-1: USB disconnect, address 2
usb 1-1: new full speed USB device using uhci_hcd and address 3
usb 1-1: configuration #1 chosen from 1 choice
usb 1-1: USB disconnect, address 3
usb 1-1: new full speed USB device using uhci_hcd and address 4
usb 1-1: configuration #1 chosen from 1 choice