FAT: FAT read failed (blocknr 9643)
scsi 11:0:0:0: rejecting I/O to dead device
FAT: unable to read inode block for updating (i_pos 2350053980)
usb 1-1: new full speed USB device using uhci_hcd and address 5
usb 1-1: not running at top speed; connect to a high speed hub
usb 1-1: configuration #1 chosen from 1 choice
scsi12 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 5
usb-storage: waiting for device to settle before scanning
usb 2-1: USB disconnect, address 3
usb-storage: device scan complete
scsi 12:0:0:0: Direct-Access     TOSHIBA  MK8025GAS        0811 PQ: 0 ANSI: 0
sd 12:0:0:0: [sdc] 156301488 512-byte hardware sectors (80026 MB)
sd 12:0:0:0: [sdc] Test WP failed, assume Write Enabled
sd 12:0:0:0: [sdc] Assuming drive cache: write through
sd 12:0:0:0: [sdc] 156301488 512-byte hardware sectors (80026 MB)
sd 12:0:0:0: [sdc] Test WP failed, assume Write Enabled
sd 12:0:0:0: [sdc] Assuming drive cache: write through
 sdc: sdc1
sd 12:0:0:0: [sdc] Attached SCSI disk
usb 2-1: new full speed USB device using uhci_hcd and address 4
usb 2-1: configuration #1 chosen from 1 choice
usb 2-1: SN9C105 PC Camera Controller detected (vid:pid 0x045E:0x00F5)
usb 2-1: No supported image sensor detected for this bridge