qla2xxx 0000:06:01.0: Found an ISP2312, irq 177, iobase 0xf893e000
qla2xxx 0000:06:01.0: Configuring PCI space...
qla2xxx 0000:06:01.0: Configure NVRAM parameters...
qla2xxx 0000:06:01.0: Verifying loaded RISC code...
qla2xxx 0000:06:01.0: Allocated (412 KB) for firmware dump...
qla2xxx 0000:06:01.0: LIP reset occured (f7f7).
qla2xxx 0000:06:01.0: Waiting for LIP to complete...
qla2xxx 0000:06:01.0: LOOP UP detected (2 Gbps).
qla2xxx 0000:06:01.0: Waiting for LIP to complete...
qla2xxx 0000:06:01.0: Topology - (F_Port), Host Loop address 0xffff
scsi2 : qla2xxx
qla2xxx 0000:06:01.0: 
 QLogic Fibre Channel HBA Driver: 8.01.07-k1
  QLogic QLA2340 - 
  ISP2312: PCI-X (100 MHz) @ 0000:06:01.0 hdma-, host#=2, fw=3.03.20 IPX
  Vendor: HP        Model: MSL6000 Series    Rev: 0516
  Type:   Medium Changer                     ANSI SCSI revision: 02
  Vendor: HP        Model: Ultrium 2-SCSI    Rev: F68W
  Type:   Sequential-Access                  ANSI SCSI revision: 03
  Vendor: HP        Model: Ultrium 2-SCSI    Rev: F68W
  Type:   Sequential-Access                  ANSI SCSI revision: 03
SCSI Media Changer driver v0.25 
ch0: type #1 (mt): 0x0+1 [medium transport]
ch0: type #2 (st): 0x20+29 [storage]
ch0: type #3 (ie): 0x1c0+1 [import/export]
ch0: type #4 (dt): 0x1e0+2 [data transfer]
ch0: dt 0x1e0: ID 1, LUN 0, Huh? device not found!
ch0: dt 0x1e1: ID 2, LUN 0, Huh? device not found!
ch0: INITIALIZE ELEMENT STATUS, may take some time ...
st: Version 20050830, fixed bufsize 32768, s/g segs 256
ch0: ... finished
ch 2:0:0:0: Attached scsi changer ch0
st 2:0:0:1: Attached scsi tape st0
st0: try direct i/o: yes (alignment 512 B)
st 2:0:0:2: Attached scsi tape st1
st1: try direct i/o: yes (alignment 512 B)
sd 1:0:0:0: Attached scsi generic sg0 type 0
ch 2:0:0:0: Attached scsi generic sg1 type 8
st 2:0:0:1: Attached scsi generic sg2 type 1
st 2:0:0:2: Attached scsi generic sg3 type 1