XSF v1.53 Usage :
       XSF [1|2|3|4] [R|W] binfile [/FULL] [/SAVESKIP] [/OFF] [/CHKSUM:xxxx]
           [/SKIPSTART:xxxx] [/SKIPLEN:xxxx] [/LEN:xxxx] [/UP:x] [/NC]
           [/9S:filename] [/ARST] [/SLED:x] [/AUTO] [/B] [/EMPTY] [/DELAY:x]
           [/BAT:filename]

          [1|2|3|4] - 1:PM   2:PS   3:SM   4:SS
              [R|W] - R:Read W:Write   (Default=W)
              /FULL - Update whole FlashROM
          /SAVESKIP - Save skipped range data to a file
               /OFF - Turn off auto range setting
            /CHKSUM - Check the checksum ,xxxx is hex checksum
         /SKIPSTART - Set skipped range ,xxxx is hex address
           /SKIPLEN - Set skipped length ,xxxx is hex length
               /LEN - Flash length ,xxxx is hex length
                /UP - Enable WFlash mode(micro-p flash )
                      x is 1(Update boot code) or 0(Dont update boot code)
                /NC - Ignore compare
                /9S - Update boot code from specific filename, for 5239S only.
              /ARST - Check ATA SRST
            /SLED:x - Move Sled x times
              /AUTO - Auto flash and quit program
                 /B - Both port mode for LED
             /EMPTY - Specify the FlashROM is empty, for speeding up only!
             /DELAY - Delay n seconds after RET is pressed
               /BAT - Run batchfile after flashing, nondata ATAPI cmd only.

G:\xsf>