root@carl-desktop:/etc/udev/rules.d# dmesg | tail -20 [ 22.532000] Clocksource tsc unstable (delta = -90917592 ns) [ 22.764000] agpgart: Found an AGP 3.0 compliant device at 0000:00:00.0. [ 22.764000] agpgart: Putting AGP V3 device at 0000:00:00.0 into 8x mode [ 22.764000] agpgart: Putting AGP V3 device at 0000:01:00.0 into 8x mode [ 23.020000] [drm] Setting GART location based on new memory map [ 23.020000] [drm] Loading R300 Microcode [ 23.020000] [drm] writeback test succeeded in 1 usecs [ 24.424000] NET: Registered protocol family 17 [ 29.320000] NET: Registered protocol family 10 [ 29.320000] lo: Disabled Privacy Extensions [ 40.068000] eth0: no IPv6 routers present [ 47.380000] UDF-fs: No VRS found [ 47.476000] ISO 9660 Extensions: Microsoft Joliet Level 3 [ 47.524000] ISOFS: changing to secondary root [ 298.144000] ndiswrapper version 1.45 loaded (smp=yes) [ 298.308000] usb 5-7: reset high speed USB device using ehci_hcd and address 6 [ 298.488000] ndiswrapper: driver usr5421x (U.S. Robotics Corporation,06/16/2005, 4.01.19.7) loaded [ 298.700000] wlan0: ethernet device 00:14:c1:3f:b1:db using NDIS driver: usr5421x, version: 0x4011405, NDIS version: 0x501, vendor: 'Broadcom RNDIS Network Adapter', 0BAF:011B.F.conf [ 298.908000] wlan0: encryption modes supported: WEP; TKIP with WPA, WPA2, WPA2PSK; AES/CCMP with WPA, WPA2, WPA2PSK [ 298.920000] usbcore: registered new interface driver ndiswrapper root@carl-desktop:/etc/udev/rules.d# iwlist scan lo Interface doesn't support scanning. eth0 Interface doesn't support scanning. wlan0 Scan completed : Cell 01 - Address: 00:18:39:D2:FF:BB ESSID:"linksys3" Protocol:IEEE 802.11g Mode:Managed Frequency:2.437 GHz (Channel 6) Quality:73/100 Signal level:-49 dBm Noise level:-96 dBm Encryption key:off Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 18 Mb/s 24 Mb/s; 36 Mb/s; 54 Mb/s; 6 Mb/s; 9 Mb/s 12 Mb/s; 48 Mb/s Extra:bcn_int=100 Extra:atim=0