##########################Kconfig#######################################

if ARCH_MSM

comment "MSM7200 Board Type"
	depends on ARCH_MSM


config MACH_HALIBUT
	depends on ARCH_MSM
	default y
	bool "Halibut Board (QCT SURF7200A)"
	help
	  Support for the Qualcomm SURF7200A eval board.

config MACH_KAISER
	depends on ARCH_MSM
	default y
	bool "HTC Kaiser phone aka HTC TyTN II"
	help
	  Support for HTC Kaiser phone.

config MSM_SMD
	depends on ARCH_MSM
	default y
	bool "MSM Shared Memory Driver"
	help
	  Support for the shared memory interface to communicate
	  with the baseband core on the MSM devices.

config MSM_SMD_TTY
	depends on ARCH_MSM && MSM_SMD
	default y
	bool "MSM Shared Memory TTY Driver"
	help
	  Provides a TTY interface to the MSM SMD channels.

config MSM_SMD_RPC_ROUTER
	depends on ARCH_MSM && MSM_SMD
	default y
	bool "MSM Shared Memory RPC Router"
	help
	  RPC Multiplexing Driver -- used to route RPC messages
	  between multiple userspace applications and applications
	  on the MSM baseband core.

config MSM_SMD_QMI
	depends on ARCH_MSM && MSM_SMD
	default y
	bool "MSM Shared Memory QMI Driver"
	help
	  The QMI control channel is used to configure, enable,
	  and disable data transports over the virtual rmnet
	  ethernet device.

config MSM_HW3D
	depends on ARCH_MSM
	default y
	bool "MSM 3D Access Driver"
	help
	  Provides access to registers and interrupts needed by
	  the userspace 3D library.

config KAISER_LCD
	tristate "HTC Kaiser VSFB LCD support"
	depends on MACH_KAISER && LCD_CLASS_DEVICE
	help
	  This driver provides support for HTC Kaiser LCD display.
endif




####################################Makefile###########################################################################




obj-y += timer.o irq.o misc.o datamover.o idle.o
obj-y += common.o
obj-y += gpio.o generic_gpio.o

obj-$(CONFIG_MACH_HALIBUT) += board-halibut.o keypad-halibut.o

obj-$(CONFIG_MSM_SMD) += smd.o
obj-$(CONFIG_MSM_SMD_TTY) += smd_tty.o
obj-$(CONFIG_MSM_SMD_RPC_ROUTER) += smd_rpcrouter.o
obj-$(CONFIG_MSM_SMD_QMI) += smd_qmi.o
obj-$(CONFIG_MSM_HW3D) += hw3d.o
obj-$(CONFIG_KAISER_LCD) += htckaiser_lcd.o
obj-$(CONFIG_MACH_KAISER) += htckaiser.o