--- ../old/adm5120sw.c	2008-01-29 15:20:01.000000000 +0100
+++ target/linux/adm5120/files/drivers/net/adm5120sw.c	2008-01-30 23:02:14.000000000 +0100
@@ -95,6 +95,11 @@
 struct adm5120_if_priv {
 	unsigned int	vlan_no;
 	unsigned int	port_mask;
+#if (LINUX_VERSION_CODE < KERNEL_VERSION(2,6,24))
+#else
+	struct net_device* adm5120_net_dev;
+#endif
+	struct napi_struct napi;
 };
 
 struct dma_desc {
@@ -495,9 +500,17 @@
 }
 
 #ifdef CONFIG_ADM5120_SWITCH_NAPI
+#if (KERNEL_VERSION_CODE < KERNEL_VERSION(2,6,24)
 static int adm5120_if_poll(struct net_device *dev, int *budget)
 {
 	int limit = min(dev->quota, *budget);
+#else
+static int adm5120_if_poll(struct napi_struct *napi, int budget)
+{
+	struct adm5120_if_priv *lp = container_of(napi, struct adm5120_if_priv, napi);
+	struct net_device *dev = lp->adm5120_net_dev;
+	int limit = budget;
+#endif
 	int done;
 	u32 status;
 
@@ -508,23 +521,32 @@
 
 	SW_DBG("%s: processing RX ring\n", dev->name);
 	done = adm5120_switch_rx(limit);
-
+#if (KERNEL_VERSION_CODE < KERNEL_VERSION(2,6,24))
 	*budget -= done;
 	dev->quota -= done;
+#endif
 
 	status = sw_int_status() & SWITCH_INTS_POLL;
 	if ((done < limit) && (!status)) {
 		SW_DBG("disable polling mode for %s\n", dev->name);
+#if (KERNEL_VERSION_CODE < KERNEL_VERSION(2,6,24))
 		netif_rx_complete(dev);
+#else
+		netif_rx_complete(dev, napi);
+#endif
 		sw_int_unmask(SWITCH_INTS_POLL);
 		return 0;
 	}
 
 	SW_DBG("%s still in polling mode, done=%d, status=%x\n",
 			dev->name, done, status);
+#if (KERNEL_VERSION_CODE < KERNEL_VERSION(2,6,24))
+	return done;
+#else
 	return 1;
+#endif
 }
-#endif /* CONFIG_ADM5120_SWITCH_USE_NAPI */
+#endif /* CONFIG_ADM5120_SWITCH_NAPI */
 
 
 static irqreturn_t adm5120_switch_irq(int irq, void *dev_id)
@@ -540,11 +562,20 @@
 	sw_int_ack(status & ~SWITCH_INTS_POLL);
 
 	if (status & SWITCH_INTS_POLL) {
-		struct net_device *dev = dev_id;
+		struct net_device *dev = (struct net_device *) dev_id;
+#if (KERNEL_VERSION_CODE < KERNEL_VERSION(2,6,24)
+		struct adm5120_if_priv *lp = netdev_priv(dev);
+#endif
+		
 		sw_dump_intr_mask("poll ints", status);
 		SW_DBG("enable polling mode for %s\n", dev->name);
 		sw_int_mask(SWITCH_INTS_POLL);
+
+#if (KERNEL_VERSION_CODE < KERNEL_VERSION(2,6,24)
+		netif_rx_schedule(dev, &lp->napi);
+#else
 		netif_rx_schedule(dev);
+#endif
 	}
 #else
 	sw_int_ack(status);
@@ -781,6 +812,7 @@
 
 static int adm5120_if_open(struct net_device *dev)
 {
+	struct adm5120_if_priv *lp = netdev_priv(dev);
 	u32 t;
 	int err;
 	int i;
@@ -792,6 +824,9 @@
 		goto err;
 	}
 
+#ifdef CONFIG_ADM5120_SWITCH_NAPI
+	napi_enable(&lp->napi);
+#endif
 	if (!sw_used++)
 		/* enable interrupts on first open */
 		sw_int_unmask(SWITCH_INTS_USED);
@@ -814,11 +849,15 @@
 
 static int adm5120_if_stop(struct net_device *dev)
 {
+	struct adm5120_if_priv *lp = netdev_priv(dev);
 	u32 t;
 	int i;
 
 	netif_stop_queue(dev);
 
+#ifdef CONFIG_ADM5120_SWITCH_NAPI
+	napi_disable(&lp->napi);
+#endif
 	/* disable port if not assigned to other devices */
 	t = sw_read_reg(SWITCH_REG_PORT_CONF0);
 	t |= SWITCH_PORTS_NOCPU;
@@ -1010,13 +1049,17 @@
 	dev->tx_timeout		= adm5120_if_tx_timeout;
 	dev->watchdog_timeo 	= TX_TIMEOUT;
 	dev->set_mac_address 	= adm5120_if_set_mac_address;
+#if (KERNEL_VERSION_CODE < KERNEL_VERSION(2,6,24))
 #ifdef CONFIG_ADM5120_SWITCH_NAPI
 	dev->poll		= adm5120_if_poll;
 	dev->weight		= 64;
 #endif
-
 	SET_MODULE_OWNER(dev);
-
+#else
+#ifdef CONFIG_ADM5120_SWITCH_NAPI
+	netif_napi_add(dev, &priv->napi, adm5120_if_poll, 64);
+#endif
+#endif
 	return dev;
 }
 
@@ -1108,6 +1151,10 @@
 
 		priv->vlan_no = i;
 		priv->port_mask = adm5120_eth_vlans[i];
+#if (KERNEL_VERSION_CODE < KERNEL_VERSION(2,6,24))
+#else
+		priv->adm5120_net_dev = dev;
+#endif
 
 		memcpy(dev->dev_addr, adm5120_eth_macs[i], 6);
 		adm5120_write_mac(dev);