rtc_cmos 00:04: rtc core: registered rtc_cmos as rtc0
rtc_cmos: probe of 00:04 failed with error -16
ACPI: PCI Interrupt 0000:1b:00.0[A] -> GSI 17 (level, low) -> IRQ 18
PCI: Setting latency timer of device 0000:1b:00.0 to 64
eth1: Tigon3 [partno(none) rev 4201 PHY(5750)] (PCI Express) 10/100/1000Base-T Ethernet 00:1a:64:a0:e0:d1
eth1: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[1] WireSpeed[1] TSOcap[1]
eth1: dma_rwctrl[76180000] dma_mask[64-bit]
ACPI: PCI Interrupt 0000:00:1f.3[B] -> GSI 17 (level, low) -> IRQ 18
Adding 2104472k swap on /dev/sda1.  Priority:-1 extents:1 across:2104472k
device-mapper: ioctl: 4.11.0-ioctl (2006-10-12) initialised: dm-devel@redhat.com
loop: module loaded
kjournald starting.  Commit interval 5 seconds
EXT3 FS on sda3, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
AppArmor: AppArmor initialized
audit(1202502356.768:2):  type=1505 info="AppArmor initialized" pid=2229
IA-32 Microcode Update Driver: v1.14a <tigran@aivazian.fsnet.co.uk>
powernow: This module only works with AMD K7 CPUs
PM: Writing back config space on device 0000:1a:00.0 at offset 1 (was 100546, writing 100146)
NET: Registered protocol family 10
lo: Disabled Privacy Extensions
ADDRCONF(NETDEV_UP): eth0: link is not ready
Mobile IPv6
ip6_tables: (C) 2000-2006 Netfilter Core Team
ip_tables: (C) 2000-2006 Netfilter Core Team
lp0: using parport0 (interrupt-driven).
audit(1202477165.470:3): audit_pid=3200 old=0 by auid=4294967295
tg3: eth0: Link is up at 100 Mbps, full duplex.
tg3: eth0: Flow control is on for TX and on for RX.
ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
eth0: no IPv6 routers present
Netfilter messages via NETLINK v0.30.
nf_conntrack version 0.5.0 (8187 buckets, 65496 max)